boundary temperature 中文意思是什麼

boundary temperature 解釋
邊界溫度
  • boundary : n 邊界，疆界，限界 （between）;（球場）邊線；界標；界限，范圍，分野。 aboundary dispute 邊界糾紛...
  • temperature : n. 1. 溫度，氣溫。2. 體溫。3. 〈口語〉發燒，高燒。
  1. First by estimative calculation the final boundary condition can be gained, then the accurate result of three - dimension temperature field and stress can be gotten through placing accurate boundary condition

    得到了三維溫度場和應力場數據結果。在計算過程中採用了根據實測值反算的思路，使計算得到的溫度場有可靠的實驗依據。
  2. With account for the effect of temperature and shock - boundary layer interaction, the forebody / inlet with plane lip and wedge lip are designed by using the design methods of constant shock wave intensity and constant shock wave angle. in the design, the incidence angle of the first ramp, height of isolator, length of forebody and total turning angle of the designed forebody / inlet models are given

    另外，根據優選結果，給定前體長度、前體預壓縮楔角、總壓縮轉角及隔離段高度，分別用等激波強度和等激波角度的方法設計了唇口平直和唇口帶楔角的前體進氣道。
  3. Wind field ; temperature field ; urban heat island ; urban boundary layer ; beijing area

    風場溫度場城市熱島城市邊界層北京區域
  4. At first the finite element theory for temperature analysis is introduced, and then mainly discussed the calculation models of cement hydration heat and the boundary condition under sun radiation

    首先對這一方法的基本原理進行了簡要的介紹，著重探討了計算中的水化熱計算模型、日照邊界條件處理等。
  5. But the grain growth, grain semiconduction and grain boundary insulation were influenced by many factors, such as the type and contents of dopants, sintering temperature and so on. therefore, in this thesis the effect of the restore sintering temperature, the oxygenize temperature, the donor and acceptor dopant on the dielectric and varistor properties of devices were studied. with sem, the microstructure of srtio3 - based double function ceramic was analyzed

    而晶粒生長、晶粒半導化和晶界絕緣化受到多種因素的影響，諸如雜質的種類和含量、燒成溫度等，因此本論文研究了還原燒成溫度、中溫氧化溫度、施主和受主摻雜等對srtio _ 3基陶瓷的壓敏和介電性能的影響，並藉助于sem分析對srtio _ 3基雙功能陶瓷的微觀結構進行了分析。
  6. Based on these experiments, it may be claimed that there is segregation of sn to grain boundaries in 0. 15 % c steel during cooling from a high solution treatment temperature. this segregation reduces grain boundary cohesion, which results in low hot ductility and intergranular fracture

    通過試驗和計算得出: sn在0 . 1swt . % c鋼中發生非平衡晶界偏聚的臨界時間為1245左右，臨界冷卻速率大約為8 / s ，與試驗結果基本一致。
  7. At the same time, the temperature fields of the radial - thrust floating ring hybrid bearing which includes the lubricant inertia item is discussed, the associated equations and the boundary conditions of temperature are given

    同時，本文對計入慣性項下徑推聯合浮環軸承的溫度場問題進行了理論研究，首次導出了該種情況下的聯立方程組和邊界條件。
  8. The measuring of low - temperature specific heat is an important and effective method to study the structure of electronic states, the atomic vibration of lattice, phase transition and structure of grain boundary

    低溫比熱測量是研究固體的電子能態結構、原子點陣振動狀態、相變、界面結構等信息的重要的且很有效的手段之一。
  9. This paper establishes a model simulating dam actual placing process and considering the non - continuity of initial temperature on the boundary of new and old concrete, daily air temperature change, concrete - placing temperature, hydration heat, heat insulation on boundary, water - storing process, placing intermission and curing with water. the calculation of stress field considers the concrete weight, static water pressure, thermal stress, different autogenous volume change between rcc and normal concrete, change of elastic modulus of concrete with age and creep action

    考慮了乞今最為全面的初始條件和邊界條件，包括模擬壩體的實際升程過程，考慮了新老混凝土接觸面上的初始溫度不連續，逐日的氣溫變化，混凝土的入倉溫度，水化熱溫升，邊界保溫，水庫蓄水過程，澆築間歇以及灑水養生等因素；應力場的計算考慮了混凝土的自重，靜水壓力，溫度應力，常態混凝土與碾壓混凝土不同的自生體積變形，混凝土的彈性模量隨齡期的變化以及徐變的作用。
  10. Combining the generating method of molecular reflective thermal velocities according to diffuse reflection model, an algorithm named as inverse temperature sampling ( its ) is developed, which enables to evaluate the molecular reflective characteristic temperature from the molecular incident energy and the boundary heat flux

    在此基礎上，通過結合壁面漫反射模型下分子反射速度的抽樣方法，發展了一種從邊界熱流求得與壁面碰撞分子的平均反射特徵溫度的逆溫度抽樣演算法。
  11. A transfer model is established, which can be used to study the interaction between the land surface physical processes of inhomogeneous region and the structure of atmosphere boundary - layer over urban and rural terrains. the model has simulated surface heat flux, surface temperature, temperature profiles, height of mixture layer and so on. and the differences between urban area, suburban area and rural area have been compared. this model mainly depends on the parameters below : surface albedo, surface roughness coefficient, moisture available coefficient of soil, thermal capacity and thermal diffusion coefficient of errain, cloudage. the result shows that this model can simulate the structure and eigenvalues of atmosphere boundary layer and their changes in a day. parameters used in this model aim at beijing city, and the time is at the beginning of september. to other cities, or other time, the parameters should be adjusted accordingly. in addition, being adjusted, the model can also be used for other homogeneous and inhomogeneous terrains

    模式主要依賴于以下參數和物理量：地面反照率下墊面粗糙度土壤的可含水量下墊面的熱容量和熱擴散系數雲量等參數。結果表明，本模式能合理地模擬不同地表熱量平衡地表氣溫混合層高度湍流交換系數湍流動能位溫廓線等，以及它們的日變化。該模式所取參數主要針對北京市，時間為九月初，對于其他城市，參數應作相應的調整。
  12. According to differences of construction process, boundary condition, temperature and stress of two schemes extending 3m deep short seam on upstream face in the middle of rcc overflow section and no short seam are calculated, what " s more, in this paper the equivalent line drawing of stable temperature field and unstable temperature field during construction and operation period and the duration curve drawing of typical points " s temperature and stress are plotted, and the results of peak and minimum on temperature in every month and maximum on tensile stress are attained

    根據施工過程和邊界條件，對溢流壩段中間上游面增設3m深短縫和不設短縫兩個方案進行了溫度和應力計算，並繪制出穩定溫度場等值線圖及施工期、運行期非穩定溫度場等值線圖，典型點溫度和應力歷時曲線圖，逐月最高、最低溫度和最大拉應力及相應位置等成果。
  13. ( 3 ) temperature field and residual capacity of reinforced concrete member after fire studied by the numbers, various boundary conditions of heat exchange equation and the solutions of them given an account, the formulae of the residual capacity of the members after fire established, the program of temperature field programmed on the basic of finite difference algorithm, a case given to demonstrate

    （ 3 ）對火災后構件溫度場的分佈和剩餘承載力的計算進行了系統地分析和研究。討論了熱傳導方程的各種邊界條件及相應的解法，建立了不同構件的剩餘承載力計算公式，並結合工程實例用有限差分法編制了相應的溫度場計算程序，與實例吻合良好。
  14. Neural network model for examination of the temperature characteristics of boundary film on friction surface

    摩擦表面邊界膜溫度特性的神經網路模型
  15. By using a same boundary dimensions high efficient and new type copper exchanger substituted carbon steel oil condenser, and increasing flow rate of circulation water to reduce the temperature of freezing oil which feeds into compressor stage, to eliminate the malfunction during compressor operation, and improve running efficiency of the machine

    採取將碳鋼材質的油冷卻器更換成等外形尺寸的高效新型銅管換熱器、增加循環水流量的方法，降低了進入二段壓縮機冷凍油溫度，排除了壓縮機運行中的故障，改善了機組的運行效率。
  16. According to actual situation of production wells, external boundary conditions and coupled inner boundary conditions between welibore and adjacent rocks, welibore and production zones, adjacent rocks and production zones are constructed, and an alternate direction implicit finite difference algorithm ( adi ) is used to solve temperature models

    根據生產井的實際情況，構建起外邊界條件以及井筒與圍巖、井筒與產層、圍巖與產層之間的耦合內邊界條件，採用交替方向半隱式有限差分方法（ adi方法）求解所建立的井下溫度場模型。
  17. Micro - jets impingement cooling heat sink is used to cool the high power lda owing to the very thin hydrodynamic and thermal boundary layers in the impingement region when a jet impinges on a surface. reasonable array of jets can develop the uniform of temperature distribution on target very much

    微射流陣列冷卻熱沉，是利用射流沖擊在駐點區能產生很薄的邊界層來提高換熱效率的，合理的布置射流孔，可以極大的提高被冷卻表面溫度分佈的均勻性。
  18. With reof analyze technique, the mainly anomalous spatial features of soil humidity in the 0 - 50cm layer of huai river basin and their relations to different periods of precipitation and air temperature are specially analyzed by using the observed data including dekad averaged soil moisture, precipitation and air temperature data over the east of china from 1990 to 2000. the results indicate that in the springtime the 30cm layer soil can be treated as a boundary

    本文首先利用中國東部1990 - 2000年旬平均土壤濕度、降水和氣溫觀測資料，通過對0 - 50cm層次土壤濕度進行旋轉主分量分析（ reof ） ，重點分析了淮河流域土壤濕度的時空分佈特徵，並初步研究了與前期、同期和後期不同時段降水與氣溫的關系。
  19. In order to overcome the difficulty mentioned above, this paper provides an improved heat transfer equation and a mended bem for the problems. first of all, the enthalpy and the " virtual temperature " are introduced into the paper to eliminate several mutative thermophysical properties in the heat transfer equation. secondly, the movement of the boundary between the solid and liquid phases in the billet is educed by virtue of the laplace transform

    這些改進包括：引入熱焓和「虛擬溫度」的概念，對非常數的熱物性參數進行整合：充分考慮鑄坯凝固潛熱釋放帶來的影響，利用「溫度回升法」來加以處理；利用拉氏變換和反拉氏變換的原理來對凝固過程中鑄坯內部固液相界面的移動方程進行了推導和求解，在凝固過程中充分考慮鑄坯內部的固液兩相的影響等等。
  20. The non - hydrostatic mesoscale model mm5. v3 is used to simulate the wind field, temperature field etc. of the atmospheric boundary layer over beijing area with the mesh resolution of 1km

    用非靜力平衡的中尺度模式mm5 . v3模擬了北京地區2000年夏季7月10日11日的風速和溫度場等邊界層特徵。
分享友人
分享到 Line

分享到臉書