bulk temperature 中文意思是什麼

bulk temperature 解釋
按體積計算的平均溫度
  • bulk : n 1 體積，容積，大小。2 巨大；龐然大物；大塊；大批，大量。3 貨艙；船貨；散裝貨物。4 〈the bulk〉...
  • temperature : n. 1. 溫度，氣溫。2. 體溫。3. 〈口語〉發燒，高燒。
  1. Results show that : ( 1 ) for each particle size of andalusite, variation tendency of the properties of the material is generally the same : the maximum of bulk density, compressive strength and rupture strength appears in the range of 5 % - 10 % content of fiber, these properties of the material remarkably decrease as the fiber content exceed 10 % ; while at the same fiber content, the properties of the material increase with the increase of firing temperature

    結果表明： （ 1 ）對于不同粒度的原料，性能變化規律大致相同：在同一燒成溫度下，體積密度、常溫耐壓強度、常溫抗折強度在5 10之間出現峰值，加入量超過10之後材料的性能明顯下降；在相同的纖維含量下，隨著燒成溫度的提高，試樣的各項性能均有所上升。
  2. If the temperature gradient becomes too large, then convection will take over the bulk of the energy transport.

    如果溫度梯變得太大，那麼對流將承擔能量傳輸的大部分。
  3. Preparation and fracture behavior under monaxial compression at room temperature of zr57nb5cu15. 4ni12. 6al10 bulk amorphous alloy

    10大塊非晶態合金的制備及其室溫單軸壓縮斷裂行為
  4. The research includes temperature controlling in deep cool condition, data sampling, relationship between levitation force and levitation gap in different temperature, and relationship between levitation force and temperature in a certain levitation gap - the deep cool condition is provided by g - m refrigerator, and a bent adapter connector fixed on second step cooling head is designed to fix ybacuo bulk

    研究包括深冷環境下的溫度控制；數據採集；不同溫度下懸浮力與懸浮間距的關系及一定懸浮間距下懸浮力與溫度的關系。在g - m製冷機作用下實現深冷測試環境，並設計出固定於製冷機二級冷頭處的轉變接頭以固定高溫超導體。
  5. As the action of the solid bounding surface is strong enough, the surface polar ordering is almost independent of temperature and unaffected by the phase transitions in the bulk of the nlcs

    當基板的表面作用較強時，界面第一分子層的極性序幾乎獨立於溫度，不受體液晶相變影響。
  6. It is found that the relation between the melting temperature and the cohesive energy of bulk materials can be used to nanomaterials, but the coefficient depends on the height of nanofilms

    研究表明，塊體材料熔化溫度與結合能的關系式在納米薄膜體系仍然成立，但比例系數是一個依賴于薄膜厚度的參量。
  7. The sort, material composite, structure properties and conduction mechanisms of eca ( electrical conductive adhesive ) were discussed in this paper. then three types of ega specimens were designed and made, on which temperature cycles test from - 55 ? to + 125 ? and thermal aging at + 125 ? were carried out. changes of the adhesive strength, eca ' s bulk resistance and contact resistance under the environment stress were summarized and a detailed evaluation on these specimens was given

    本文在全面闡述導電膠的分類組成、物理結構、導電機理的基礎上，設計並製作了三批導電膠樣品，通過對樣品進行長時間的- 55 ? ? + 125溫度循環和125高溫存儲試驗，總結了導電膠粘接強度、體電阻和接觸電阻在環境應力下的變化規律，對三類樣品的長期可靠性做出了全面的評價，並結合導電膠電阻率和「穿流閾值」的計算機模擬，給出了提高導電膠可靠性和電導率的建議，介紹了國內外在高電導率高可靠性導電膠研製方面的一些最新進展。
  8. After the sample is turned out, its internal and external structures are observed and its bulk density is measured in order to determine how the sintering temperature, the time of thermal preservation, and the quantity of admixture affect the performance of lytag

    通過對試樣內、外部結構觀察和容重的測定，研究燒成溫度、保溫時間及外加劑摻量對粉煤灰陶粒性能的影響。
  9. The nano - bulk al should be kept more man 30 minutes at temperature no more than 300 to annealed which is much lower than that of ordinary aluminum materials

    對納米鋁塊體材料的退火實驗表明，模壓成形的鋁塊體材料的退火溫度（ 300 ）比常規的鋁材（ 400 ）要低，退火保溫時間應在30分鐘以上。
  10. The tensile and compression experiment on bulk nanocrystalline ag prepared by igc method was carried on mt810 with different grain sizes and zwick 10tn2s machine at different strain rates under normal temperature respectively. the stain rate sensitivity m was found to be 0. 025, which was extremely lower than the ordinary values. also the work hardening exponent is very low

    本文從用惰性氣體蒸發冷凝和真空原位壓結法（ igc ）制備得到的直徑80mm ，厚度7 . 6mm的大尺寸納米晶金屬ag樣品上切割得到符合力學實驗要求的拉伸和壓縮試樣，在mts810和zwick精密力學測試機上分別精確測定了拉伸和壓縮應力?應變曲線與晶粒尺寸和應變速率的關系。
  11. ( 3 ) for parameterization of the sensible heat, the positively correlation between surface temperature and bulk transfer coefficient lead to a positive additional sub - scale flux. its magnitude is determined by the grid average roughness and average wind velocity on the reference level

    （ 3 ）對區域感熱通量的計算而言，由於地表溫度和整體輸送系數產生一個正的次網格通量項，它主要由網格平均粗糙度和參考高度平均風速所決定。
  12. Adhesives - methods of preparing bulk specimens - elevated - temperature - curing one - part systems

    粘合劑.散裝樣品的制備方法.高溫處理單成份系統
  13. Good : all bulk ingredients stored in well designed, sanitary tanks or vessels, and at specified temperature

    好：所有的散裝原料儲存在設計良好的衛生的缸或容器內，且存於規定的溫度。
  14. Poor : most bulk ingredients stored in tanks or vessels of poor design which are difficult to maintain in a sanitary condition. ingredient temperature ( s ) is frequently outside specified range

    差：大多數散裝原料儲存在設計拙劣的缸或容器中，難以保持衛生的條件。原料溫度經常超過規定溫度范圍。
  15. The iron covered silicon powder was fabricated separately by the milling method and the mixing method. treated separately at 500, 600, 700, 800, 900 and 1000 for 1 minute, the iron silicon alloy bulk was attained. it also found that the density of the bulk was enhanced by the boost of the treated temperature

    實驗分別採用球磨法和混料法制備鐵硅包覆粉末，採用放電等離子燒結技術分別在500 ， 600 ， 700 ， 800 ， 900 ， 1000保溫一分鐘進行處理，得到鐵硅合金塊體，研究發現，隨著處理溫度的提高，塊體的緻密度隨之增加，顯微結構的分析表明，塊體基本保持了包覆粉末原始自然狀態。
  16. The results demonstrate that the theory predicted values of compression, bulk modulus, linear expansion, and thermal expansive coefficient of compressed solids are very agreement with the corresponding experimental data. in summary, the error with respect to theory prediction and its causes are pro bably analyzed in detail. the discussion suggests that the function of the phenomenological short - distance repulsive force constant a ( v ) and approximation for anderson - griineisen parameter 5t ( v ) proposed in this paper are valid and applicable in high pressures ( up to loogpa ) and high temperatures ( from debye temperature 0d to melting temperature tm ) for many types of solids

    在本文最後一節，為了驗證固體在等壓過程中anderson grhneisen參量乓與體積膨脹的唯象假設：乓久w兀的有效性，及由此假設而推導出來的等壓態方程的廣泛應用性，本論文主要針對十六種堿金屬鹵化物、三種堿性氧化物、三種硅酸鹽礦物質的線膨脹八n 、體積熱膨脹v vo （ n 、熱膨脹系數a （ n 、體積彈性模量肘d等隨溫度的變化作了理論上的預測，且與相應的實驗數據作了比較與分析
  17. Bulk silicon, with indirect band gap of 1. 12 ev, does n ' t emit visible light at room temperature

    本體硅為間接禁帶半導體，且禁帶寬度比較窄（ 1 . 12ev ） ，在室溫下很難發可見光。
  18. The mechanism of the luminescence has been discussed. bulk silicon, with indirect band gap of 1. 12ev does n ' t emit light at room temperature

    本體硅為間接禁帶半導體，且禁帶寬度較窄，室溫下很難發光。
  19. The analysis of the steady bulk temperature field in spiral bevel gears

    弧齒錐齒輪傳動的穩態本體溫度場分析
  20. Emmed 32 is recommended to used for open or closed systems with a bulk temperature of 315 maximum and a skin temperature of 360 maximum

    Emmed 32適用作開放式或密閉式系統的傳熱油，整體操作油溫可達315 ，而在熱源接觸面可抵受360的界面溫度。
分享友人
分享到 Line

分享到臉書