calibrated error 中文意思是什麼

calibrated error 解釋
標定誤差
  • calibrated : 標刻度的
  • error : n. 1. 錯誤；失錯。2. 謬見，誤想；誤信；誤解。3. 罪過。4. 【數學】誤差；【法律】誤審，違法；（棒球中的）錯打。adj. -less 無錯誤的，正確的。
  1. The most important criteria that used to check the calibrated model are root mean square error ( rms ), the mean absolute error normalized rms error, and mass balance

    模型參數使用試錯法識別，識別過程中最重要的指標是均方差、平均絕對誤差、標準均方差和水均衡。
  2. After the construct of the motion simulation model, genetic algorithm is used to do the adjustment of pid parameters of the control system of the joint motors, integral separation pid control and angle error analysis is finished, and three force / torque sensors, touch sensors, distance sensors and photoelectric switches are calibrated and installed

    在建立了機器人關節控制系統模型后，使用遺傳演算法對其關節電機控制系統進行pid參數整定，進行機器人關節的積分分離的pid控制策略和轉角誤差的理論分析，並進行了機器人三維力/力矩傳感器、接觸傳感器、測距傳感器和光電開關的標定與安裝。
  3. Its static total error and dynamic total error directly effect the accuracy of test measuring data. so it : must be precisely detected and calibrated before test, in order to calculate its static total error and dynamic total error. the original eots - e theodolite detect - calibrating system was established in 1970s

    Eots - e型電影經緯儀一直是靶場重要的標準值測量設備，在多年來的靶場試驗中起著重要的作用，其自身的靜態總體誤差和動態總體誤差直接影響到經緯儀測量數據的準確性，因此在每次應用之前都需對其進行精確標定，以計算出經緯儀的靜態總體誤差和動態總體誤差。
  4. Initially the xinanjiang model was calibrated using the shuffle complex evolution method ( sce - ua ) under ideal situations - where the data inputs are assumed to be error free and the flow series for which the model results are fitted are generated from a known set of model parameter values

    起先在理想的條件下我們用單純多邊形進化（ sce - ua ）的演算法對新安江模型進行了計算，模型的輸入假設是無誤差的，用一套已經知的參數來計算輸出的流量系列。
  5. Consider to simplifying the process of calibrating dynamic error parameters of accelerometer and shortening the time of calibrating test, all dynamic error parameters are calibrated at one - time, based on the mathematic model of dynamic error of accelerometer and integrating the model and the testing theory of the three - axis turntable, meanwhile, the angle - vibration table is avoided

    摘要為了簡化加速度計動態誤差系數的標定過程，縮短標定試驗時間，在建立加速度計動態誤差數學模型的基礎上，結合三軸轉臺模型及測試原理，一次性標定出加速度計動態誤差系數，同時避免了角振動臺的使用。
分享友人
分享到 Line

分享到臉書