calibration by measurement 中文意思是什麼

calibration by measurement 解釋
由量度標準
  • calibration : n. 1. 測定口徑。2. 刻度，標度，劃度數。3. 校準；標準化。
  • by : adv 1 在側，在旁，在附近。2 （擱）在一邊，（放）到旁邊，（存）在一旁；收著。3 （由旁邊）經過，過...
  • measurement : n. 1. 測量，計量，量度。2. 份量，尺寸，大小，寬度，厚度，深度（等）。3. 測量法。 measurement goods （按體積、容積計算的）體積貨物。
  1. As proved by experiments, the present method can effectively restrain the influence of speckle to the laser triangular measurement system and the obtained calibration accuracy is about 0. 05mm within 100mm depth range

    只需對特殊設計的模塊進行一次測量，便可完成對整個測量系統的校準。該方法能夠有效的抑制激光散斑的影響，具有較高的系統精度。
  2. Measurement microphones - part 3 : primary method for free - field calibration of laboratory standard microphones by the reciprocity technique iec 61094 - 3 : 1995 ; german version en 61094 - 3 : 1995

    測量傳聲器.第3部分:用互易技術對實驗室標準傳聲器進
  3. This article studies on a novel method about detector calibration and monochromator calibration by using silicon pin photodiode. the detector and the monochromator of one spectrum measurement system had been calibrated using the method, and the spectrum distribution of one laser - produced plasmas ( lpp ) source with jet gas target was measured. the use of a specific combination of the silicon photodiode and multiplayer reflect films is the notable character in monochromator calibration

    本文研究了一種利用光電二極體傳遞標準探測器標定普通探測器和單色儀系統的方法，實際標定了所用的探測器和單色儀系統，測得了噴氣靶激光等離子體光源的相對光譜分佈，設計出絕對光譜分佈的測量方法，並且利用labview的g語言及相應的數據採集卡等硬體設備構造出一套智能化、高效率的測量系統，完成了多層膜反射率測量工作。
  4. The calibration of piezoelectric accelerometer is an important area of the shock and vibration measurement technology, and the calibrated piezoelectric accelerometer is divided into standard accelerometer and working accelerometer, usually standard accelerometer is calibrated by absolute method and working accelerometer is calibrated by comparison method

    壓電加速度傳感器的校準是振動與沖擊測量技術中的一個重要研究領域，被校的壓電加速度傳感器有標準加速度計和工作用加速度計之分，通常標準加速度計用絕對法校準，工作用加速度計用比較法校準。
  5. The laboratory can provide calibration service for the measurement of the wavelength of any laser having a nominal wavelength of 633 nm. calibration is performed by comparing the wavelength of the laser under test with the wavelength of the standard iodine - stabilized helium - neon laser of the laboratory

    本所可為波長標稱值為633nm的激光器提供波長測量服務。被測試的激光波長將與本所的標準碘穩頻氦氖激光器的波長比對而進行校正。
  6. The method of exterior measuring shore beacon has been put forward by using evaluation precision of original azimuth of missile aiming on the background of test for the precision of missile aiming " xx " underwater to surface missile on the sea, established math model and analyzed main parameters of measurement, principle, calibration and azimuth calculating for method of exterior measuring shore beacon was discussed

    對國內主要代表型號的導彈瞄準系統進行了比較詳細的綜述。文章是以「 xx 」潛地導彈海上瞄準精度試驗為背景，給出了一種外測岸標的方法來評估艦載導彈武器系統方位瞄準精度的鑒定方法，適用於潛地導彈初始方位瞄準精度的鑒定。
  7. Calibration specification for contact stylus instruments of surface roughness measurement by the profile method

    觸針式表面粗糙度測量儀校準規范
  8. 2. the necessity and difficulty are discussed for the in - place calibration of inertial measurement unit being subjected to the vibration, shock and acceleration induced by the host vehicles. a new in - place calibration method based on the fixed axe rotation constraint is presented

    2 、討論了載體經受振動、沖擊和加速度的情況下，慣性測量組合參數現場標定的必要性和技術難點，提出了基於定軸轉動約束的現場標定演算法。
  9. Petroleum and liquid petroleum products - tank calibration by liquid measurement - incremental method using volumetric meters

    石油和液化石油產品.通過液體測量進行油箱校準.使用容積測量儀的遞增法
  10. 1 calibration the comparison of a measurement standard of instrument of known accuracy with another standard of instrument to detect, correlate, eliminate by adjustment, and report any variation in the accuracy of the item being compared

    調校把一部己知其準確度的儀器的量度標準與另一儀器的標準作比較，來檢查、連系、更正並消除及報告比較專案的誤差。
  11. The standards and calibration laboratory - the government of the hong kong special administrative region has been designated by hoklas as one of such competent calibration organisations capable of providing the necessary measurement traceability

    香港特別行政區政府標準及校正實驗所已獲實驗所認可計劃指定為有能力的校正機構之一，能提供所需的測量溯源服務。
  12. Graduation and calibration of surveying instrument for liquid scintillation counter by using radioactivity certified reference material, and the accurate measurement of ( superscript 3 ) h or ( superscript 14 ) c have been finished

    摘要利用放射性標準物質刻度和校準液閃計數器測量儀器，並完成（上標3 ） h和（上標14 ） c活度的精確測量。
  13. Laboratories accredited or seeking accreditation under hoklas are required to have their testing and measuring equipment regularly calibrated by a competent calibration organisation to obtain measurement traceability to the international system of units ( si )

    已獲實驗所認可計劃認可或正申請認可資格的實驗所，須讓其測試或測量設備定期接受校正，而校正工作須由有能力的校正機構執行，使測量能溯源至國際單位制。
  14. The comparative measurement method for vacuum gauge calibration is introduced. the construction, principle and process of the calibrator are described. the effects of six kinds of gas on the calibrated ionization gauge are explored and relative sensitivity is obtained. the necessity of the calibration on the vacuum gauge and instrument is proved by the research

    文章介紹了對真空規管和儀器進行校準的比對法，闡述了校準系統的結構、原理及校準方法;探討了被校電離規在6種不同的氣體中的校準效果及校準前後的差異，說明了氣體歧視效應的存在和影響，得出了各氣體的相對常數;結果表明，對真空規管及儀器進行校準是必要的。
  15. For the spectral radiance calibration of solar ultraviolet spectrum monitor, a basc > 4 diffuser is used, and a more accurate calculation for spectral radiance response is given by a integral formula. process of download signal data from solar ultraviolet spectrum monitor on spaceship obtains measurement results of solar ultraviolet spectral irradiance and solar backscatter spectral radiance

    根據太陽紫外光譜監視器的地面標定結果，對從神舟三號上下載的測量數據進行處理獲得了地外太陽紫外光譜輻照度和地球大氣後向散射光譜輻亮度，與國際上的測量結果對比相對誤差在10 %以內。
  16. Inductive voltage dividers ( ivd s ) will be calibrated by comparison with the laboratory s 8 - dial ivd, normally at specific frequencies of 400 hz, 1 khz and 10 khz with an input test voltage of 25 v. the calibration normally involve measurement of voltage ratio ( magnitude ) of the output voltage related to the input voltage of the ivd

    感應分壓器一般按400hz 、 1khz及10khz等指定頻率及25v的輸入測試電壓，透過與本所的八刻盤感應分壓器對比而進行校正。校正工作一般包括測量該感應分壓器輸入電壓與相對輸出電壓的電壓比（幅值） 。
  17. The article relates that the tool ' s measurement precision has been improved by applying cycling acquisition method, self calibration function and phase - sensitive detector. the image coverage rate is improved and reached to 60 percent by increasing the number of pad ' s buttons. the tool carried out two logging functions : fast - scanner mode and dip mode

    本文敘述了採用循環採集法、自刻度功能、相敏檢波等方法提高了儀器的測量精度；通過增加極板電扣的數量將圖像覆蓋率提高到60 ；實現了快掃描、傾角兩種測井模式；將測斜短節與預處理短節合二為一，縮短了儀器長度；去除了零伺服控制系統，簡化了電路；用fpga晶元對採集控制器重新設計。
  18. The lighting and light matching capability of the automobile headlamp is very important to the safety of night - driving. the measurement of automobile headlamp must use the headlamp measure instrument, which is needed to use a calibration instrument to calibrate. however, whether the calibration instrument is standard must be checked up by a measure system

    汽車前照燈的檢測需要用「汽車前照燈檢測儀」 ，而「汽車前照燈檢測儀」的定期校準工作需要用「前照燈檢測儀校準器」來進行； 「前照燈檢測儀校準器」是否合乎標準需要靠「前照燈檢測儀校準器檢定系統」來檢測。
  19. Measurement microphones - methods for pressure calibration of working standard microphones by comparison

    測量傳聲器.用比較片做用工作標準傳聲器的壓力校準方法
  20. Nim is the signatory to the mutual recognition arrangement ( mra ) for national measurement standards and for calibration and measurement certificates issued by national metrology institutes

    中國計量科學研究院於1999年代表中國簽署了「國家計量基標準及國家計量研究院出具的校準和測量證書相互承認協議」 。
分享友人
分享到 Line

分享到臉書