calibration point 中文意思是什麼

calibration point 解釋
標準點
  • calibration : n. 1. 測定口徑。2. 刻度，標度，劃度數。3. 校準；標準化。
  • point : n 1 尖頭，尖端；尖頭器具；〈美國〉筆尖；接種針，雕刻針，編織針；小岬，小地角；【拳擊】下巴。2 【...
  1. In the self - calibration scheme, the thesis emphasizes the accuracy of camera intrinsic and extrinsic parameters. we presents an accurate f method based on corresponding point adjustment. the method adjusts coresponding points according to the fixedness of projective transformed cross ratio, then calculates f matrix accurately through linear and non - linear methods. when computing intrinsic parameter, a matrix, we simplify the step, and stress on the two important parameters of a. the result will be getten through solving kruppa equation based on svd decomposition. in order to compute extrinsic parameters, we use linear method to get initial r and t, then apply non - linear method to accurate them

    提出了基於匹配點調整的f求精方法，先根據攝影交比不見性對手工選擇的匹配點進行調整，再用線性、非線性結合的方法求精f矩陣；在計算內部參數a中，進行了一定的簡化，把重心放在a中重要的兩個參數上，用svd分解法計算kruppa方程；在計算外部參數時，首先用線性法求解r 、 t ，然後再用非線性法迭代求精。
  2. Based on the verification regulation of prt, this paper studies the temperature characteristics of prt, suggests a method of improving the accuracy of measurement and supplies the uncertainty of calibration point

    摘要分析了檢定規程對鉑電阻溫度計的要求，通過研究鉑電阻溫度計的測溫特性，提出了提高鉑電阻溫度計測量精度的方法，並給出了在溫度校準點的測量不確定度。
  3. Which combines four acceleration techniques : fast detection of overlapped regions by reverse calibration, more - careful selection of control points, fast surface closet point computation with closet vertex caching and compatibility test of pairing points based on the difference of modulation

    針對兩幅距離像間的配準，我們分別從重疊區域檢測、控制點選取、對應點計算和對應點有效性檢查四個方面提出了多種加速方案，從而實現了大數據量距離像的快速局部配準。
  4. Reconstruction and camera poses recovery from multi self - calibration images with marked point occlusions

    基於標記點丟失的多幅自標定圖像的3維重建和相機姿態恢復
  5. Exsiting calibration methods are classified as ( 1 ) methods using point targets and distributed targets ; ( 2 ) methods using only distributed targets and ( 3 ) methods using only point targets. then the typical algorithms of every methods are given in which those of method ( 1 ) and ( 2 ) are modified based on a quantity of literatures

    然後在眾多演算法中挑選了三種技術的典型演算法，在綜合多篇文獻的基礎上，給出修正的混合點目標和分佈目標的定標演算法：對所選的分佈目標演算法本人進行了修正，並給出了這個修雁的演算法；點目標演算法則按照原文獻給出。
  6. The main steps include camera calibration, the matching of motion and stereo images, 3 - d feature point correspondences and resolving the motion parameters

    其主要步驟包括相機檢校、運動與立體影像的匹配、運動前後三維特徵點的對應以及運動參數的求解。
  7. The deviation angle between different telescopes is found out by comparing the images from the different telescopes and the calibration of the solar point deviation is realized

    研究由不同波段望遠鏡獲得的太陽圖像處理的方法，建立相應的數學模型，編制計算程序，進行模擬圖像處理，實現不同望遠鏡間的指向偏差標定。
  8. Finally, computer aid measurement correction system is set up. the experiment is done in this system. it proves that nonstandard calibration technology is feasible and oddity point problem is avoidable

    通過此輔助測量校正系統，我們進行了實驗，驗證了網路分析儀非標準校正技術的可行性及其奇異點研究結論的正確性。
  9. Both methods provide good performance, and the latter is better since it can give a better describing of the residual distribution of matches. in the study of camera self - calibration, firstly, based on discussion of using and the selecting of scene constraints, two new robust vanishing point estimation algorithms are presented. one is based on peransac, and the other is based on clustering

    在相機自定標技術的研究中，首先，在討論利用和選擇景物約束的基礎上，提出兩個新的消失點估計演算法:基於peransac的估計演算法和基於聚類分析的估計演算法，後者在估計精度上優於前者;其次，提出了綜合利用空間平行線約束和相機主點位置約束的線性迭代自定標方法，提高了相機自定標的魯棒性。
  10. This paper presents a robot autonomous calibration approach, the kinematics equations are built through the probe fixed in the end - effector contacting the constraint planes in the workspace, the robot internal sensor measurements are recorded for kinematics calibration while the tip - point of the probe is in contact with the constraint planes, the locations of the constraint planes are not necessarily known exactly

    摘要介紹一種機器人自標定方法，通過固定於機器人末端執行器上的探針與工作空間中的約束平面接觸，建立運動學約束方程，利用機器人內部傳感器讀數來辯識機器人運動學參數，約束平面的位置無需準確知道。
  11. To this problem a series of image rectification procedure which utilize geometric rectification theory in vehicle license recognition system are pointed out : we first locate vehicle license and execute the edge detection and binary conversion, then proceed calibration in which we use two calibration scheme looking for control point coordinate, one based on the hough transformation, the other based on image analysis method, and finally realize image correction in geometrical transform and bilinear gray interpolation method

    針對此問題本文給出了一套將幾何畸變校正技術應用到汽車牌照自動識別系統中的車牌圖像校正方法：首先提取牌照信息，並對圖像進行邊緣檢測和二值化的預處理；然後提出了基於hough變換控制點提取和基於圖像分析法的控制點提取的兩種實時標定方法；最後通過空間坐標變換和灰度插值完成圖像的校正。
  12. The state administration of light industry fountain pen, ball - point pen quality control testing center designated by the state to the national fountain pen, ball pens, jihaobi, ink pens, ink pens and ink used for product quality testing statutory bodies, and is responsible for national - type, ink, pens with ink, and other special test equipment calibration, and the development of new detection techniques and methods

    國家輕工業自來水筆、圓珠筆質量監督檢測中心是國家指定的對全國自來水筆、圓珠筆、記號筆、墨水筆、筆用油墨和墨水進行產品質量檢測的法定機構，並負責對全國筆類、墨水、筆用油墨等專用測試儀器進行校驗，研製開發新的檢測技術和方法。
  13. A right - angled triangle that is similar to the calibration deice is built in 3 light lines that are imaging lines of 3 point of the calibration device. the relation can solve the external parameters of the digital camera

    在標定裝置三點成像的光線上建立一個直角三角形，使這個直角三角形與標定裝置的三角形相似，由此來確定相機的所有外部參數。
  14. A finer - point calibration 25pt instead of 4pt will give you better approximation of screen locations

    更精細的點刻度（ 25pt而不是4 pt ）可以為屏幕位置提供更好的近似值。
  15. Additionally the linearity of the measurement by pms has been verified by analyzing co and co2 at various concentrations based on a single - point calibration

    圖五所示為採用過程質譜基於單點校正在不同濃度測量co和co2的線性度的測試結果。
  16. Verification regulation of calibration for ge - - ray spectrometer by eu point - ray standard source

    用eu點狀標準源校準鍺譜儀檢定規程
  17. The figure below shows the magnitude of the error that results from a 1 % error in recording either i0 ( intensity of fluorescence at zero - pressure oxygen ) or the intensity at the high calibration point

    下圖表明了誤差值，記錄中結果為1 %誤差或i0 （在零壓力氧下熒光強度）或在高校準點下的強度。
  18. Camera self - calibration algorithm from matched - point sets on two orthogonal planes

    基於雙正交平面上匹配點對的攝像機自標定演算法
  19. Otherwise, some problems of the dynamic calibration of multi - dimension force / torque sensors are studied, and the author of this thesis also gives out his own point of view

    另外，本文還分析了多維力/力矩傳感器的動態標定實驗中的若干問題，提出了自己的看法。
  20. In this paper, a 9 - point loading method been used in the new balance calibration system to load six component loads on a balance. at same time, the automatic loads method and the design of loading device are also important

    同時，在具有全自動加載功能的校準系統研製中，自動加載方式選取和加載機構的設計也是其中的關鍵技術難點之一。
分享友人
分享到 Line

分享到臉書