calibration voltage 中文意思是什麼

calibration voltage 解釋
定標電壓
  • calibration : n. 1. 測定口徑。2. 刻度，標度，劃度數。3. 校準；標準化。
  • voltage : n. 【電學】電壓，電壓量，伏特數。 the working voltage （電氣的）耐壓限度。
  1. Single range voltmeters are normally calibrated at cardinal points ( maximum 10 test points ). for multi - range voltmeters, the basic calibration will include measurements at full ranges and linearity check at 5 voltage levels for one range. linearity check for other ranges can be offered at extra cost

    單量程電壓表一般以基點（最多十個測試點）進行校正；多量程電壓表的基本校正則會包括全量程測量及按五個電壓量位為一個量程進行線性檢查。
  2. Calibration of a single range high voltage voltmeter

    校正一臺單量程高壓電壓表。
  3. Calibration of a single range ac high voltage voltmeter

    校正一個單量程交流高壓電壓表
  4. Verification regulation of hf voltage calibration apparatus types do - 2 and the like

    Do - 2型高頻電壓校準裝置檢定規程
  5. If the potentiometer under test has its own internal voltage reference and power supply, these will be used, unless they are found to be unstable. generally, the calibration procedure recommended in the manufacturer s service manual will be followed

    若接受測試的電位差計附有內部電壓標準及電力供應設備，在測量過程中，除非此等電壓標準及電力供應被發現並不穩定，否則將盡量被使用。
  6. Calibration of a single range dc high voltage supply

    校正一單量程直流高壓電源。
  7. Calibration of a multi - range high - voltage voltmeter with not more than 4 ranges

    校正一臺不超過四個量程的多量程高壓電壓表。
  8. Calibration of a multi - range ac high voltage voltmeter with not more than 2 ranges

    校正一個不超過兩個量程的多量程交流高壓電壓表
  9. Electronic voltage reference standards submitted for calibration should have a nominal voltage of 1 v, 1. 018 v or 10 v. additional uncertainty will be added for other values of emf

    呈交作校正的電子電壓標準器具，其標稱電壓應為1v ， 1 . 018v或10v 。否則，其牽涉的測量不確定度將會增大。
  10. Calibration of a wattmeter at rated voltage with 5 different current settings on one current range ( at one frequency and one power factor )

    按額定電壓，校正一個電流量程上有五個不同電流值的功率表（一個頻率及一個功率因數） 。
  11. Sb2016 is suitable to be used as power load & standard resistance of every calibration institutions, research institutions, factories and schools, specially for testing and calibration the kinds ofwithstanding voltage tester

    適用於各計量與科研機構、工廠與學校作功率負載及電阻標準，特別適用於檢測/校準各種規格的耐壓測試儀。
  12. The company is engaged in the distribution and sales of all sorts of r & d and qc equipment for analysis and inspection, electric measuring instruments, electronics measuring instruments, industrial calibration standard equipment, high - voltage test equipment, equipment for material analysis and inspection, teaching equipment for education, etc

    代理及銷售國內外： r & d及qc檢測設備、電機測定儀器、電子測定儀器設備、工業校正儀器、高壓試驗設備、材料分析檢驗、學校教學設備等服務。
  13. The bias voltage in the circuit is supplied by the bgr, which reduces the power consumption and the area of the chip. this paper takes polygon interpolation as non - linear calibration method, adopts hdl verilog to design the digital duty cycle measuring circuit, from which we have obtained a group of

    選擇了臺積電0 . 25 mcmos工藝庫，利用hspice模擬工具對整個溫度傳感電路進行模擬測試，結果顯示所設計體溫計在30 c 50 c的溫度范圍內具有0 . 01 c以上的檢測精度、 0 . 1 c的顯示精度和180 w的最小功耗。
  14. The system can simulate the transfer process of photo - thermal and thermal - electric at a given parameter setting of structure, environment and circuit. on the basis of circuit structure, the calibration, parameter adjusting and signal readout can be simulated, the vary process of readout circuit, readout voltage, optical gain, optical gain rate, and uniformity can be given. in addition, all kinds of character parameters of device can be forecasted

    本論文根據umbirfpa的原理，建立它的軟體模擬系統，它可以根據給定的結構、環境、電路設置等參數首先模擬光熱、熱電轉換過程，並可根據電路結構，模擬校準、參數調節並讀出信號，給出讀出電流和電壓、光學增益、光學增益比、非均勻性等各特徵量的定量變化過程，預測製成后器件的各種性能參數。
  15. Inductive voltage dividers ( ivd s ) will be calibrated by comparison with the laboratory s 8 - dial ivd, normally at specific frequencies of 400 hz, 1 khz and 10 khz with an input test voltage of 25 v. the calibration normally involve measurement of voltage ratio ( magnitude ) of the output voltage related to the input voltage of the ivd

    感應分壓器一般按400hz 、 1khz及10khz等指定頻率及25v的輸入測試電壓，透過與本所的八刻盤感應分壓器對比而進行校正。校正工作一般包括測量該感應分壓器輸入電壓與相對輸出電壓的電壓比（幅值） 。
  16. Calibration of precision ac voltmeter at one frequency voltage combination by ac - dc transfer

    以交直流轉換方法按一頻率電壓組合校正精密交流電壓計
  17. Calibration at each additional frequency voltage combination by ac - dc transfer, for the same equipment

    以交直流轉換方法按每一額外頻率電壓組合校正同一儀器
  18. Silicon piezoresistive sensors are widely used for pressure measure. consistency, temperature shift and non - linearity are ubiquitous because of semiconductor ’ s inherent characteristics. compensation and calibration are needed for piezoresistive sensor ’ s output voltage

    對于廣泛應用於壓力測量的硅壓阻式傳感器，由於所用的半導體材料的固有特性，普遍存在著:一致性、溫度漂移和非線性等問題。
  19. Verification regulation of precise ac voltage calibration source

    精密交流電壓校準源檢定規程
  20. The basic calibration for a single decade ivd will include measurement of voltage ratio for all output settings of the ivd at one test frequency

    一個單盤感應分壓器的基本校正工作包括按一測試頻率，測量該電感分壓器所有輸出定位的電壓比。
分享友人
分享到 Line

分享到臉書