carbon particle 中文意思是什麼

carbon particle 解釋
碳粒子
  • carbon : n. 1. 【化學】碳。2. 【電學】碳精棒[片、粉];碳精電極。3. (一張)復寫紙。4. 復寫的副本。
  • particle : n 1 顆粒,微粒;微量,極少量。2 【物、數】粒子,質點。3 【語法】虛詞,不變詞〈冠詞、副詞、介詞、...
  1. The structures and characteristics of several graphite samples are measured by means of powder x - ray diffraction ( xrd ), brunauer - emmer - teller ( bet ) surface area measurement, inductively coupled plasma ( icp ) spectroscopy, particle size analysis and electrochemical measurements. the effects of origin, structure, impurity, particle size, specific surface area of carbon materials on the electrochemical characteristics are studied. a synthetic graphite with abundant resources, low cost and favorable performance is determined as the raw material for modification of graphite

    採用xrd 、 bet 、 icp 、激光粒徑分析及電化學性能測試等方法,對國內外多種典型石墨樣品的結構與性能進行比較,研究石墨材料的來源、晶體結構、雜質含量、顆粒大小、比表面積等因素對其充放電性能的影響,確定一種性能較好、價格低廉、來源廣泛的普通人造石墨粉作為熱處理與摻雜改性、以及復合結構炭材料研究的原材料。
  2. With the wide application of carbon / phenolic composite in spacecrafts and missile hulls, the prediction of dynamic response or internal damage of structures subject to explosion, impact or the shock wave induced from the sediment of high - energy particle beam and the evaluation of capability of composite in defending stress wave, aroused the study of the constitutive relation and the characteristic of stress wave propagating

    隨著碳酚醛在航天飛行器結構及導彈殼體中日益廣泛的應用,預測結構受到爆炸作用、沖擊或由於高能粒子束在其表層大量沉積而產生的應力波所引起的動態響應及內部損傷,以及對其防護應力波的性能進行評估等,都需要對碳酚醛的本構關系以及應力波在其中的傳播特性開展研究。
  3. Meanwhile in the condition of high temperature, water vapors can participate in combustion. water gas reaction will happen, which will reduce carbon particle in flame, and reform combustion performance, so improve combustion efficiency. the article developed a kind of technology of water injection into intake ports for 4135g diesel engine, meanwhile designed a suit of water injection system

    同時在高溫條件下,水蒸汽參與燃燒,部分水分子與未完全燃燒的熾熱的炭粒發生水煤氣反應,形成可燃性氣體,從而減少了火焰中的炭粒,提高了油的燃燒程度,改善了燃燒狀況,提高了油的燃燒效率。
  4. Carbon nanotube ( cnts ), as a kind of nano material, can produce special catalytic action to some materials because of its small particle diameter and large surface area

    碳納米管作為一種納米材料,由於小粒徑、大比表面積效應,可對某些物質的電化學行為產生特有的催化效應,常用於酶傳感器的構建。
  5. Test method for particle size distribution of granular activated carbon

    粒狀活性碳粒徑分佈的試驗方法
  6. Standard test method for determination of particle size of powdered activated carbon by air jet sieving

    粉末活性碳粒徑測定的標準試驗方法
  7. In this paper, based on the experi ment and research data of the injected water quality in lunnan oil field in many years, the actual situation of the injected water in lunnan oil field is analyzed and discussed and the chemical indices ( content of the iron, dissolved oxygen, sulfide, carbon dioxide and oil and corrosion rote ), the bacterial index, the phys ical indices ( content and particle diameter of the suspended sub stance ) and the compatibility of injected water with formation water, etc. are evaluated one by one

    文章立足於多年來輪南油田注入水水質的實驗研究數據,對輪南油田注入水現狀進行分析討論;對化學指標(鐵含量、溶解氧、硫化物含量、二氧化碳含量、含油量、腐蝕率) 、細菌指標、物理指標(懸浮物含量、懸浮物粒徑)和注入水與地層水配伍性等進行逐一評定。
  8. Testing of carbon materials ; determination of particle size distribution by sieving ; solid matters

    碳素材料試驗.通過篩分測定顆粒大小分配.固態物質
  9. This kind of catalyst was very fine, with strong interaction between the support and the active component particle, and high dispersion of such particles on the surface of the support. yield of carbon nanotubes can also be improved greatly by the doping of molybdenum to catalyst

    本文所採用的檸檬酸法瞬時燒爆工藝制備的催化劑,顆粒小,載體與活性組分接觸好,活性組分分散均勻,可望實現單壁納米碳管的大規模製備。
  10. Pcc is produced by reacting a milk of lime with carbon dioxide, thereby precipitating finely divided calcium carbonate, generally with a particle size of less than 5 microns

    沉澱碳酸鈣pcc由石灰乳和二氧化碳反應而產生,因此產生碳酸鈣細碎粒的沉澱,一般是比
  11. Using this system, research on nox emission and burnout characters of the test facility are carried out. the results of influence on nox emission and carbon in fly ash by coal type, coal particle diameter, furnace temperature and excess air are reached through tests. then micronized coal reburning tests are processed, which show a remarkable effect results on nox reduction and burnout rate

    通過大量的試驗,得出了煤種、煤粉細度、爐膛溫度和過量空氣系數等因素對nox排放和煤粉燃燼率的影響趨勢;並在此基礎上研究了超細粉再燃對脫氮效果和燃燼性能的作用,試驗結果表明超細煤粉再燃對降低nox排放和飛灰含碳量具有明顯的效果。
  12. Microstructure analysis showed that the tungsten carbide particle reinforced steel matrix composites, which were made by electroslag melting and casting method, not only had low content of porosity and nonmetal inclusion, but also could reduce the free carbon content immensely

    顯微缺陷分析顯示,採用電冶熔鑄工藝制備的wc鋼復合材料不僅氣孔、夾雜物含量低,無明顯游離石墨痕跡,而且較好地解決了wc顆粒的偏聚問題,具有明顯的質量優勢。
  13. In this study, we use different particle of carbon powders mixed with epoxy - resin, and coating on polyester woven fabrics for designing the electromagnetic wave absorbing screens, and employ the matching of impedance to designing the transfer of single or plural layers, and observe the influence of the amount of layers and the methods of collocating screens, to attain the method of collocating screen, which achieve best effect of absorbing of electromagnetic wave

    摘要本實驗採用碳粉混合環氧樹脂,塗抹在聚酯布上,做為電磁波吸收體之表面護幕和間距護幕,以單層和多層疊合,並利用阻抗匹配的理論,觀察疊層層數和排列試樣的方法,對電磁波吸收效果的影響,藉由此求出具有最佳吸收效果的排列方法。
  14. Properties of filler ( such as carrier ' s shape, particle diameter, pore size, surface area, as well as surface coverage, carbon content and bonded types of the bonded group ) and filling of chromatographic column shall directly affect retention behavior and separation effect of the articles to be tested

    填充劑的性能(如載體的形狀、粒徑、孔徑、表面積、鍵合基團的表面覆蓋度、含碳量和鍵合類型等因素)以及色譜柱的填充,將直接影響待測物的保留行為和分離效果。
  15. Surface morphology of carbon black particle and nanomechanics of its aggregate

    炭黑粒子的表面形貌及其聚集體的納米力學屬性
  16. Influence of ni particle on field electron emission from carbon nanotubes

    顆粒對碳納米管場致電子發射的影響
  17. In this study, two types of nano particle sulfur composite materials were designed and prepared, that is, conductive - polymer / sulfur composites and active - carbon / sulfur composites, which can be used as advanced cathode materials for rechargeable lithium batteries. sulfur / conductive - polymer composites were prepared simply by thermal treatment of a mixture of elemental sulfur and polymer

    在一定溫度下,單質硫與有機聚合物發生反應,使有機聚合物脫氫硫化並形成導電聚合物硫復合材料,所採用的有機聚合物包括pvc 、 pe 、 pan 、 pp等多種常見的塑料。
  18. Our product includes 4 series, s, c, m, qhm and hongyuan carbon offers specially demanded graphite powder for customers. our anode carbon materials following unique functions : stable internal structure, ellipsoidal, smooth surface, suitable particle distrbution, superior safety and good electrochemical performance

    目前我公司生產的鋰離子電池用負極材料系列產品包括: s 、 c 、 m及qhm ,公司還可以生產客戶的需要訂制產品。
  19. The graphite is covered with a thin film of disordered carbon according to the measurements of xrd, bet, particle size analysis and scanning electron micrographs ( sem ). sugar and phenol resin are used as the precursors of the shell - carbon materials. structure and performance of composite structure carbon material are studied in detail

    提出邊緣碳原子及表面碳原子含量對炭材料嵌理性能的作用機理,並導出該機理的具體表現形式,即炭材料的形貌、比表面積、顆粒大小、有序化程度等結構與物理特性對炭材料的嵌貍性能的影響。
分享友人