cavity modes 中文意思是什麼

cavity modes 解釋
諧振腔模式
  • cavity : n. 1. 【解剖學】穴,窩,盂,腔,空腔;【醫學】(空)洞。2. 【物理學】模槽;氣蝕區;空腔諧振器;【原子能】(反應堆中的)小室,暗盒。
  • modes : 模式
  1. The detail study on the interaction between the electron beam and standing wave of complex cavity gyrotron with gradual transition and gyroklystron has been done in this dissertation, supported by the pre - study important items " the study on 8mm third harmonic gyrotron with a permanent magnet system " and " the study on 8mm high power gyroklystron ". the main works of this dissertation are listed as following : 1. the study on the rf distribution of the complex cavity with gradual transition is presented, in which the multi - modes coupling are taken into account

    本論文就是結合該課題組的「九?五」重點項目「 8mm三次諧波永磁包裝迴旋管技術的研究」及「十?五」重點項目「 8mm高功率迴旋速調管技術的研究」 ,對以諧振腔為互作用高頻系統的迴旋脈塞器件中兩種典型的器件? ?迴旋振蕩管及迴旋速調管中電子注與駐波場的互作用進行了深入細致的探討和研究,其中迴旋振蕩管採用的是漸變復合腔。
  2. According to the working modes of mr devices, combining the ohm ' s law of magnetic circuit and the design theory of non - steady magnetic circuit, magnetic structures of the automotive damper have been worked out. to emulate the performance of conventional shock absorber, two automotive mr dampers were designed and fabricated at chongqing university. an applied magnetic field increase the yield stress of mr fluids in flow annular passages, which alters the velocity profile of mr fluid in the passages and raise the pressure gradient between low cavity and high one at some given flow rates

    根據磁流變阻尼器工作模式,利用磁路中的歐姆定律和動態磁路設計原理,結合汽車懸架的技術要求和結構特點,提出了基於剪切模式和流動模式共同作用(混合工作模式)的汽車磁流變阻尼器設計原理,討論了阻尼器動態磁路設計中的若干技術問題;根據流體力學navier - stokes方程,分別利用newton流體特性和bingham流體特性,推導了基於平板模型和軸對稱模型的流變學方程,得出了阻尼器阻尼力的計算方法。
  3. In the far from cutoff approximation the energies of empty cavity modes versus radii of three - dimension semiconductor microcavity are evaluated

    摘要半導體微腔中腔模和激子模藕合形成腔極化激元,三維微腔中由於橫向限定腔模和激子模形成離散化的本徵模式。
  4. It is indicated that the cavity modes blueshift with decreased radius, and on decreasing radii there is obvious anticross between the three polaritons resulted from interaction between cavity modes and its corresponding exciton modes

    結果表明隨著微腔半徑的減小腔模能量藍移,腔模與相應的重空穴激子模、輕空穴激子模藕合形成的腔極化激元的三支隨著微腔半徑的減小存在明顯的反交叉行為。
  5. Investigation on transverse modes competition characteristics of vertical - cavity surface - emitting lasers

    垂直腔面發射激光器的橫模競爭特性
  6. The compensator compensates the change of polarized light, and also controls the polarized orientation. in result, we get a cavity, with the orientations of the linear polarized multi - longitudinal modes are agree. the noise of green output reducing, the cavity is steady with multi - longitudinal modes operating

    本文首次將nd : yvo _ 4晶體應用於抑制激光噪聲的補償片法中,利用nd : yvo _ 4晶體的線偏振特性,控制諧振腔內激光束的偏振方向,使多縱模均為線偏振,且偏振方向一致,從而減少了綠光輸出中的波動現象。
  7. Then in this article resonance method is adopted. the paper analyzes the usual measurement methods of complex permittivity, then analyzes and chooses te0np circular cavity based on the methods of the te01n high - q circular cavity, uses the mode purifying and cavity dimension optimizing techniques. the resonant frequencies of varies modes in the resonant cavity have been drawn by using matlab software, which makes our work more rapid and convenient

    本文首先分析了復介電常數的常用測試方法,然後分析並選用了基於高q腔法原理的te0np圓柱腔,應用模式凈化和腔體優化技術,利用matlab這一運算性能強大的工具軟體編程,作出諧振腔中各個模式的頻率分布圖,使系統的設計工作清晰、便捷。
  8. The influences of the tm modes on the rf distribution of the complex cavity are analyzed in detail. further more, the influences of the angle of the section with gradual transition on the rf distribution of the complex cavity are analyzed in detail. 2

    主要工作如下:一、在多模情況下,利用模式耦合理論,對漸變結構復合腔的高頻特性進行了研究,詳細地分析了漸變復合腔中電波模式對高頻特性的影響。
  9. Based on the self - consistent nonlinear theory of complex cavity gyrotron with gradual transition, a simulation code of self - consistent nonlinear beam - wave interaction has been made, in which the multiple modes interaction with an electron beam and the mode coupling are taken into account. the interaction between the electron beam and hsn - h521 rf field for third - harmonic gyrotron is simulated. the influences of the thickness and the velocity spread and the velocity ratio of the electron beam and the fluctuation of the magnetic field and the technologic errors of complex cavity on the multi - modes interaction with an electron beam are analyzed

    二、在漸變復合腔迴旋管多模自洽非線性理論的基礎上,編制了高次諧波漸變復合腔迴旋管多模注?波互作用自洽非線性模擬軟體,並對8mm波段三次諧波漸變結構復合腔迴旋管的注? ?波互作用進行了大量的自洽非線性數值模擬計算與研究,進而分析了電子注的厚度、速度零散、速度比值、磁場波動、腔體尺寸的加工誤差等等多種因素對互作用效率的影響。
  10. Based on this arithmetic, the high frequency characteristics of five - cavity with open boundary is calculated by the code written in fortran language. then the transit effect of five modes of five - cavity with open boundary is also calculated using code mathcad and matlab. the results show that the working mode of five - cavity transit tube oscillator is 3 / 6 mode, and the analysis of the theory are in good agreement with the simulation results

    根據從基於四腔渡越時間效應的自調制出發,經過一段飄移,然後再採用雙間隙提取腔邊耦合輸出高功率微波的思路,採用粒子模擬方法優化設計出一種峰值功率為1 . 5gw ,頻率為9 . 3ghz的六腔渡越輻射振蕩器,並研究了它的一系列工作特性。
  11. The transit effect of all modes of three four and five - cavity resonant is calculated by code mathcad and matlab

    用小信號理論研究了電子束與五腔開放腔五個模式的互作用。
  12. In the photoluminescence ( pl ) spectra, a new emission band due to the exciton - exciton collision process ( p band ) is observed under low excitation intensity at room temperature. and some fine structures origination from the cavity modes of the fabry - p rot etalon could also be seen clearly

    在單根zno微柱(直徑有25 m )的p帶發光峰上還可以觀察到明顯的f - p腔模式分佈,通過計算得到其腔長為21 m ,同微米柱的尺寸相當。
  13. The paper did scrupulous discussion and investigation on the interaction between electron beam and standing wave field in the gyroklystron, which is typical in the electron cyclotron maser which action rf system is resonant cavity. the main works of this dissertation are listed as following : first, solving field in absorbing material and field matching method were used to derive the dispersion equation in waveguides and field matching formulas of hybrid modes in an abrupt cavity with absorber. based on the theoretical analysis, numerical simulations of the cavities in gyroklystron were done

    主要工作有:一、採用吸收介質分區求解及場匹配的方法推導出含有吸收層的色散方程,單側加入吸收介質及兩側均加入吸收介質兩種突變結構混合模場的匹配方程,在理論分析的基礎上,通過相關的模擬軟體,建立了迴旋速調管介質加載中間腔的計算模型,對迴旋速調管中間腔進行了數值模擬,並給出了主要的計算結果。
  14. Three parts ( 6 chapters ) are included in this dissertation except the 1 st and 6th chapters. the first part ( the 2nd, 3rd and 4th chapters ) is the theory for analyzing and designing resonators with diffraction optical elements by use of a matrix eigenvalue method. the eigen modes and diffraction loss for a laser cavity have been obtained by this method

    本論文主要包括三個部分共八章,除第一章緒論和第八章總結外,主要內容如下:第一部分(第二、三、四章)主要討論和分析了決定激光光束的輸出特性和光束參量的激光諧振腔,闡述和建立了矩陣本徵值方法分析和設計激光諧振腔的系統理論。
  15. Numerical simulations show that : ( 1 ) owing to the temperature variation resulting in the change of the refractive index of both the semiconductor medium and the fi ber, and further inducing the shift of the longitudinal modes of the fgesl, the lasing wavelength of the fgesl has a shift tendency to longer wavelengths with the increase of the temperature ; the mode hopping happens for a short external cavity and disappears for a long external cavity

    數值模擬的結果表明:由於溫度變化造成半導體介質和光纖的折射率發生變化從而導致fgesl的縱模發生移動,因此fgesl的激射波長隨著溫度的升高將存在向長波長方向發生移動的趨勢,對于短外腔, fgesl的縱模間距較大,半導體介質折射率隨溫度的變化程度大於光纖折射率隨溫度的變化程度,因而存在模式跳躍現象;對于長外腔,由子fgesl的縱模間隔很小,因而不存在明顯的模式跳躍現象。
分享友人