charging voltage 中文意思是什麼
-
The technology of high power constant current charging, high voltage heavy current discharging switch, high speed and high voltage pulse generator, precision synchronization delay, auto control and so on are concretely introduced in this paper
具體研究了大功率恆流充電技術、高壓大電流放電開關、高速高壓脈沖發生器、高精度延時同步技術及系統自動控制技術。 -
From the model, we can solve and gain the values and change orders of charging current, charging voltage, discharging current, discharging voltage and inductive current. after that, the electromagnetic fields can be created from two circuits " currents, and their magnetic rector and flux can be simulated from ansys solver
用ansys multiphysics模塊求解出充電電流、充電電壓、放電電流、放電電壓和感應電流以及這些參數隨時間變化的規律：然後利用兩個迴路的電流耦合出電磁場，並模擬出磁矢量、磁通密度。 -
For the circuit - breakers of rated voltage 252kv up, the synthetic test methods are introduced according now condition because of the limitation of the transformer short - circuit capacity. the correlative prescribes on switching line - charging current in gb / t1984 - 200x " alternating - current high - voltage circuit - breaker " are discussed according to the test results and theoretic analysis
由於開合空載架空線路試驗對電源側的阻抗有明確的規定，這就要求試驗電源必須具有足夠大的短路容量，實驗室很難滿足要求，因此，一般對較高電壓等級的斷路器採用合成試驗方法，本文介紹了利用現有條件，對252kv以上電壓等級的斷路器採用合成試驗時的試驗線路。 -
Study on high voltage and constant current charging power supply based on soft switching
基於軟開關的高壓恆流充電電源的研究 -
The li - ion or li - polymer battery ic use cc / cv charging mode which includes the 3 charging stages : the trickle charging, large constant current charging and constant voltage charging
本文設計的鋰電池充電器晶元採用了恆流恆壓的充電方法，並在此基礎上將充電過程分為三個階段:預充電、恆流充電和恆壓充電。 -
After which, the battery will be charged by large constant current to allow the fast charging. finally, the constant voltage charging is adopted to guarantee the battery was charged to its full capacity. under the condition that the temperature has raised to a certain threshold at the constant current charging stage, the over temperature circuit is performing and it provides a compensation current which switches the system to constant temperature charging mode with the intention of protecting the ic
即在充電初期採用較小的電流對電池進行預處理，對出現過放電的電池進行修復和保護;然後採用較大的恆定電流對電池充電，實現快速充電的目的;最後採用恆定壓充電，確保電池充滿;在恆流充電階段，當晶元溫度上升到一定程度時，晶元過熱保護電路開始工作，該電路以提供充電補償電流的形式使充電進入恆溫充電模式，對晶元進行保護。 -
Automatically detect the voltage of battery, regulate the charging current, and compensate for the self - discharging loss of battery at any moment to ensure that the generator set obtains the suffcient electric quantity of battery required whenever the generator set starts
自動檢測蓄電池電壓，調節充電電流大小，隨時補充電池自放電損失，保證機組任一時刻起動所需電池電量。 -
Voltage meter, current meter, frepuency meter, oil pressure meter, water temperature meter, timer, battery voltage or charging current meter, protection indicator, speed and voltage inching switch and etc
電壓表電流表頻率表油壓表水溫表計時器電池電壓或充電電流表保護指示燈轉速及電壓微調開關等。 -
Because central potentials of four y windings in 12 - phase generator are not equal each other and there is no common reference inside the generator, it is difficult to identify the on / off of rectifying elements. in this paper, by using a mathematical model with line voltage substitute for phase voltage, the problem that there is no common reference in the 12 - phase generator with rectifier is solved. based on results of the studies on small prototype, 920kw charging generator applied in a submarine is improved in design, and therefore power oscillation with high magnitude when two generators are operating in parallel
由於十二相發電機中四個y繞組的中點電位不等，電機內部沒有公共參考點，從而在判斷整流元件導通時，不能象三相同步發電機整流系統那樣認為陽極電位最高或陰極電位最低的整流元件導通，本文採用了以線電壓代替相電壓建立十二相整流發電機的數學模型，從而解決了十二相發電機無公共參考點的問題。 -
Constrained to technologies, the lead - acid battery mainly adopted traditional charging methods such as constant voltage, constant voltage with current limitation, constant current, etc. the charging current of these methods cannot match efficiently the acceptance curve of the lead - acid battery proposed by j. a. mas. as a result, some of these methods have a low time efficiency and incompleteness charging. and some of them lead to overcharge and gas - generation, which will result in low - efficiency, time - consuming and prone - to - damage of the charging operation
鉛酸蓄電池由於受到技術條件的限制，其充電主要採用恆壓、恆壓限流、恆流等常規充電模式，這些方法的充電電流未能有效的遵從馬斯所提出的可接受充電電流曲線，因而有的充電方法時間效率低、充電不完全;有的則存在著過充電和析氣等現象，並導致充電過程的低效，耗時和易損。 -
The charging of lead - acid battery, the most widely accepted secondary battery, constrained to technological limitation, mainly adopted traditional charging methods such as constant voltage, constant voltage with current limitation, constant current and etc. those methods may not follow the internal physical and chemical laws within the battery, leading to serious overcharge and gas - generation, and resulting in low - efficiency, time - consumming and prone - to - damage of the charging operation
二次電池中被最廣泛接受的鉛酸蓄電池由於技術條件的限制，其充電主要採用恆壓、恆壓限流、恆流等常規模式，這些充電方法未能遵從電池內部的物理化學規律，大多存在著嚴重的過充電和析氣等現象，並導致充電過程的低效，耗時和易損。 -
On charge, the counter-voltage or overvoltage of the battery could be so high as to restrict the charging characteristics at low temperatures.
充電時，蓄電池的反電壓或過電壓太高，以致限制了低溫充電性能。 -
The research on high - voltage capacitor direct current charging power supply is performed by using matlab in this paper
本文利用matlab語言提供的動態模擬軟體包simulink對高壓電容直流充電電源進行了研究。 -
These results prove that the charging action of the power supply is right. the simulation method is applied with other power supply system. at the same time, the hardware system of 2qkv - 60kw high - voltage capacitor direct current charging power supply is described in this paper, and discuss why designed a full digital phase - shifting pulse circuit
同時，本文敘述了20kv ? 60kw高壓電容直流充電電源的硬體電路的設計，其中討論了為什麼不採用已有的uc3875 、 uc3879等晶元來產生zvspwmdc dc變換器的移相脈沖，設計了全數字式移相脈沖產生電路。 -
The main parameter are : the mean power of 45kw, the highest output voltage of 400v, the maximum output current of 50ka, the maximum repetitive rate of 100 hz, the preliminary charging time of 35s
裝置的主要參數為：平均功率45kw ，最高輸出電壓400v ，最大輸出電流50ka ，重復頻率1 100hz連續可調，預充電時間35秒。 -
Surface flashover across the insulators in vacuum is the major limitation of the performance of the high power system, such as high power microwave tube, pulse power switch, high - energy linear accelerator, etc. flashover studies are of considerable importance in many applications. alumina ceramics are used widely in vacuum insulation system. the flashover and charging performance have been systematically investigated on alumina ceramics in vacuum under pulse voltage ( 0. 7 / 4 ^ 8 )
真空中絕緣子沿面閃絡現象是制約高功率微波管、脈沖功率開關、高能粒子加速器等系統性能的主要原因，這是因為真空中絕緣子在一個比自身及相同真空間隙擊穿電場低得多的電場下就發生了表面閃絡的緣故，研究真空中絕緣子沿面閃絡現象及其形成機理對于改善和提高系統性能有重要意義。 -
When switching the no - load overhead lines by alternating - current high - voltage circuit breaker which is a kind of daily operations in electric power system, over - voltage is probably bringed out and insulating property of the electric devices is breakdowned sometimes, especially, when occuring re - strike. the main purposes that the tests on switching line - charging current are performed in the laboratory are assessing re - strike performance of circuit - breakers. according to the test results, the design of the circuit - breaker is optimized and re - strike performance is improved
交流高壓斷路器是電力系統中最關鍵最重要的設備之一，斷路器開合空載架空線路是電力系統中常見的操作，操作過程中通常會出現過電壓，對系統絕緣造成威脅，嚴重時會破壞系統的絕緣性能，發生事故，隨著電力系統電壓等級的提高、輸電線路不斷延長及傳輸容量的增大，由操作過電壓引起的絕緣閃絡、設備破壞事故的幾率更加突出。 -
A " saddle " shape appears in the curve of relationship between smd ( sauter mean diameter ) and charging voltage, the droplets " size distribution fluctuates with the change of charging voltage. the influence of electric field on flow field is apparent. the distribution of velocity and turbulent energy, structure and size of vortex appear different changes with the increase of voltage of charging
索太爾粒徑隨電壓的變化曲線中出現「馬鞍」現象，粒徑的分佈情況隨電壓的升高出現波動性變化；電場對流場的作用明顯，速度與湍能的分佈及渦的結構等流場特性隨電場的改變均有不同規律的變化。 -
The maximum output of ion beam current is obtained at a charging voltage of 8 kv for the magnetic field power system, which is in accordance with the theory of magnetic insulation. the ion beam parameters are an accelerating voltage of 300 kv, an ion current density of 300 a / cm2 with beam pu lse width of 80 ns and with composition of 70 % proton and 30 % carbon ions
在磁場電源電壓為8kv ，獲得了與磁絕緣理論相符的最大離子束流密度輸出，離子束參數為：加速電壓300kv ，離子束流密度300a cm ~ 2 ，離子束脈沖寬度80ns ，成分約為70 h離子和30 c離子。 -
The effect of the charging voltage on the the life of storage battery
充電電壓對蓄電池壽命的影響研究
分享友人