circuit capacitance 中文意思是什麼

circuit capacitance 解釋
電路電容
  • circuit : n 1 (某一范圍的)周邊一圈;巡迴,周遊;巡迴路線[區域];迂路。2 巡迴審判(區);巡迴律師會。3 【...
  • capacitance : n. 【電學】電容;電容器。
  1. Survey on the principle and maintenance of circuit by capacitance of digital avometer

    數字萬用表電容測量電路原理及檢修
  2. Experimental results show that the bistable of tuned substrate self - bias was determined by discharge gas pressure, discharge power and tuning circuit parameters etc. the bistable exists is because of there is capacitive coupling in icp system and sheath capacitance is nonlinear

    實驗結果表明這種跳變回滯現象與等離子體的放電氣壓、射頻功率以及調諧外電路的參數等多種因素密切相聯系。而產生跳變回滯現象的原因是icp中存在容性耦合以及鞘層電容具有非線性特性。
  3. Any subtle change of capacitance can be measured through the method of modulation on high - frequency harmonic oscillation return circuit

    電容的微小變化可通過對高頻諧振迴路調制的方法進行測量。
  4. Non negligible cable capacitance in ac control circuit

    交流控制迴路中不容忽視的電纜電容
  5. Accelerometer is used widely for measuring acceleration in civil and military field. at present, there are several type of accelerometers such as piezoelectricity electric charge accelerometer, ic piezoelectricity electric accelerometer, compressive resistance accelerometer and alteration capacitance accelerometer. the main part in alteration capacitance accelerometer is capacitance measurement circuit. foreign countries have produced accelerometer that have tiny volume and high performance. however, our country is not able to produce such accelerometer due to the lack of technique

    加速度計作為一種測量加速度的儀器,在民用、軍用領域都有廣泛的應用。目前市場上的加速度計主要有壓電式電荷加速度計、集成電路式壓電加速度計、壓阻式加速度計、變電容式加速度計等幾種類型的加速度計。變電容式加速度計的設計中一個重要的環節就是電容檢測電路的設計。
  6. The capacitance offset averaging network is used in the distributed track - and - hold circuit block of the designed system. finally, according to the analysis on error effects in adc, the mathematics error model is simulated. furthermore, the input - output characteristics including input -

    最後,基於對a / d轉換器系統中誤差的分析,對其誤差數學模型進行了模擬,得到了包含延遲、限幅、諧波失真等誤差的輸入輸出特性曲線。
  7. Therefore, they serve as restricts to design these blocks at the circuit level. secondly, based on the study of the resistor offset averaging network, a capacitance offset averaging network is designed. the differential non - linearity ( dnl ) and the integral non - linearity ( inl ) are reduced 70 % by applying this capacitance offset averaging network

    其次,研究了電阻誤差平均網路的特性,設計了電容誤差平均網路,分析可得此電路技術可改善電路微分非線性( dnl )和積分非線性( inl )達70 %以上,和電阻誤差平均網路對dnl抑制效果好不同,電容誤差平均網路對inl的抑製程度是對dnl的抑製程度的2倍以上。
  8. The study has completed the design of two - phase inverter and made up of the two - phase inverter - motor system for experimental use it is a variable frequency adjustable speed system with a open - loop control of rotational speed, which consists of voltage - controlled oscillator circulating assign device inverter circuit and two - phase induction motor a accurate mathematical model is set based on the whole system, and simulator program of dynamic and steady condition is established, which is used to calculate the dynamic and steady performance by kron and symmetrical coordinate converter by simulator calculation and experimental research with specific parameter of the system, a comparison is made between predicted and experimental characteristics, experimental measurements are shown to compare closely with corresponding theoretical result it is compared with some variable frequency adjus table speed system comprising inverter and single - phase induction motor from the system efficiency torque pulsation and the effect of two - phase inverter capacitance based on the conclusion, harmonic cancellation pulse width modulation control of a two - phase inverter - fed induction - motor drive system is researched, which cancelled the low harmonic and improve the system performance

    通過對電機的kron變換和對稱分量變換,建立了系統較精確的數學模型,編制了系統動態及穩態運行的模擬計算程序分別計算系統的動態和穩態性能。通過對系統的具體參數進行了模擬運算和實驗研究,實驗和模擬結果進行比較,說明實驗和理論較為一致,並從系統效率、轉矩脈動及兩相逆變器電容的影響等方面與各種逆變器和單相異步電動機組成的變頻調速系統加以比較。在此基礎上,對兩相逆變器供電-異步電動機系統使用諧波抑制pwm控制進行了研究,由於減少了低次諧波,改善了系統性能。
  9. The equivalent - circuit parameters and resonant frequencies of the piezoelectric quartz crystal resonance, the value of half peak width of the electroacoustic conductance spectrum ( fg1 / 2 ) as well as the electrical double - layer capacitance were obtained and analyzed

    獲得並分析了pqc諧振等效電路參數、諧振頻率、電導譜半峰寬f _ ( g1 2 )和雙電層電容,考察了電極界面發生的吸附動力學過程。
  10. The circuit has good characteristics and is applied in ect system. 3 ) the influence of stray capacitance on the c / v circuit is discussed, according to its conclusion, the appropriate component, parameter and phase shift is find out

    分析了雜散電容對c v變換電路性能的影響,並以此為依據選擇合適的器件、電路參數及適當的相移調整,解決了雜散電容給電路帶來的影響。
  11. The main works are listed as follows : ( 1 ) the small capacitance measuring circuit for ect based on the charge amplification principle was deeply analyzed and improved. the stray - immunity and the charge injection effect of this circuit were deeply analyzed. the influence of the charge injection effect was eliminated by practical time sequences and circuit structure differential

    本文的主要工作和創新點如下: ( 1 )對基於電荷放大原理的微弱電容測量電路進行了深入的分析和改進,深入分析了該電路的抗雜散電容性能及電荷注入效應問題,通過時序的合理設計消除了電荷注入效應等因素對測量結果的影響,改進了該電路的數學模型。
  12. Capacitance between any two terminals in the installation should no more than 1. 06. 3. insulation level of installation : for rated voltage of 6kv installation, it can endure 23kv rms for 1 min between the phrase to phrase or phrase to earth of main circuit ; for rated voltage of 10kv installation, it can endure 30kv rms for 1 min between the phrase to phrase or phrase to earth of main circuit ; it can be endure 2kv rms for 1 min between auxiliary circuits of installation

    3 .裝置的絕緣水平: 6kv額定電壓的成套裝置,其主電路相間及相與地之間,工頻耐受電壓方均根值23kv , 1min 10kv額定電壓的成套裝置,其主電路相間以及相與地之間,工頻耐受電壓方均根值30kv , 1min成套裝置輔助電路工頻耐受電壓方均根值2kv , 1min 。
  13. Application guide for capacitance current switching for ac high - voltage circuit breakers

    交流高壓斷路器用電容性電流開關的應用指南
  14. Wide range of capacitance 0. 47pf - 10uf is available for various circuit needs

    電容量范圍廣,適用於多種迴路中
  15. In order to eliminate the influences caused by temperature, electrode - polarization and autoeciousness - capacitance, the traditional instrument has added complicated circuits so that it cause such shortcomings as big error, time - retardation and a relatively small scope. through the problems caused by 2 - probe electrode and ac current source, a new measuring circuit based on the excitation of bi - directional voltage pulse and the sensor of 4 - probe electrode is proposed, using single - chip to achieve auto - temperature compensation

    作者在參閱國內外大量相關參考文獻的基礎上,從電導測試技術的原理性研究出發,分析了採用交流激勵源、兩電導電極為傳感器的傳統電導測試系統所面臨的種種問題,提出並研製了一種基於雙極性脈沖電壓激勵、以四電導電極為探頭、運用單片機進行溫度自動補償的新型電導率測量系統。
  16. Then the time constant is computed through the equation set, thus the liquor resistance and conductivity is obtained. and the expression of the conductivity ' s computation is given out. the method is verified by circuit design and establishment of experimental scheme. this method eliminate effectively the effect that the distributed capacitance put on the conductivity measurement

    並推出了電導率求解過程的全部表達式。設計電路,制定實驗方案進行實驗驗證。分析實驗結果表明,該方法有效消除引線分佈電容對電導率測量的影響。
  17. A lcc multi - resonant ( mr ) network is added to the traditional three - level converters to realize zvs. the unique arrangement of a multi - resonant network results in absorption of all major parasitic components hi the resonant circuit, such as transistor output capacitance, diode junction capacitance and transformer leakage inductance, which can eliminate parasitic oscillation in the converter

    它的優點在於諧振電容吸收了開關管和續流二極體的結電容,諧振電感吸收了變壓器的漏感,使得開關管和續流二極體都能在軟開關的條件下完成導通和關斷過程,消除了電路中的寄生振蕩。
  18. Inductance capacitance coupled circuit

    感容耦合電路
  19. The analysis of ppf ’ s operation principle is introduced in detail in this paper. further more, the effect on the circuit operation is also analysed, which caused by clamping capacitance and different transformer leakage inductance value

    本文首先深入研究了推挽正激變換器的工作原理,分析了穩態條件下的工作模態,同時分析了箝位電容與變壓器原邊漏感的大小對于工作模態的影響。
  20. This paper aims to finish the electronic interface circuit of the tuning fork micromechanical gyroscope detected by capacitance to ensure the vibrating of the gyroscope and to detect and process the signals

    本文針對音叉電容式微機械陀螺的介面電路設計、穩幅諧振、微弱信號檢測和處理等問題開展研究。
分享友人