clutch shaft 中文意思是什麼

clutch shaft 解釋
離合漆
  • clutch : vt vi 抓，抓住；攫住；握緊。 clutch at a straw （危急時）撈稻草；急不暇擇；急來抱佛腳。 clutch th...
  • shaft : n 1 箭；箭桿。2 （槍、槌、斧等的）柄；矛。3 【植物；植物學】稈；莖；柄。4 【動物；動物學】羽軸；...
  1. Clutch pedal shaft bracket

    離合器踏板軸托架
  2. Clutch pedal shaft lever

    離合器踏板軸桿
  3. Clutch pedal shaft

    離合器踏板軸
  4. Energy - saving performance of vehicle driving axle shaft overrunning - sliding clutch

    汽車超越滑行半軸離合器節能性分析
  5. Clutch rotor and brake are fixed on the output shaft, and the input armature plate can be set onto the input flywheel so that when the clutch is energized the fly wheel will drive the output shaft. when the clutch is disengaged and the brake is energized the output shaft will stop

    離合器之轉子與剎車器被固定在出力軸上，入力的電極板可固定在入力的飛輪上，當電流通過離合器時飛輪帶動出力軸，當離合器分離時，剎車有電流通過出力軸就停止。
  6. Clutch release shaft bushing

    離合器分離軸襯套
  7. The shaft may be started by a clutch or stopped with a brake

    軸可能先由離合器啟動，最後由閘來停止。
  8. Clutch operating shaft lever

    離合器操縱軸桿
  9. Through militia programs, the final plan is to change the transmission ratio of gearbox, the parameter of friction piece as well as the gear width of the sixth gear of the second shaft. finally, the parts of transmission system - clutch, gearbox, driving shaft, driving bridge are checked and the problems are solved

    本文通過多目標規劃，最終的優化方案是適當改變變速器傳動比、摩擦片參數及二軸六檔齒輪齒寬，最後對傳動系各部件- - -離合器、變速器、傳動軸、驅動橋等進行了校核，使問題得到妥善解決。
  10. Because the newly designed clutch is installed on the driven shaft, smooth acceleration is possible

    因為最新設計的離合器安裝在從動軸上，所以平穩加速是可能的。
  11. Overrunning clutch as output mechanism of pulse - type stepless transmission is friction roller - type mainly. because roller and output shaft contact with a higher pair, surface of output shaft appears groove mark obviously when repeated driving

    脈動無級變速器的輸出機構? ?超越離合器，目前主要是摩擦滾柱式超越離合器，由於滾柱與輸出軸之間以高副接觸，往復驅動下輸出軸表面明顯出現溝痕。
  12. The paper designs a lower pair and one - way overrunning clutch. because its arc - block, outer ring, roller, slide - block and output shaft contact by lower pairs, they overcome higher pairs ’ shortcomings such as wearing easily, bad resistance to impact, bad bearing capacity and so on

    本文創新設計了一種低副單向超越離合器，其弧塊與外環，弧塊與滾柱，滾柱與滑塊以及滑塊與輸出軸之間都是以低副聯接，克服了高副易磨損、耐沖擊性差，承載力低等缺點。
  13. The start shaft is an integral part of the clutch assembly

    開始豎井不可分割的一部分的離合器總成
  14. Clutch input shaft

    離合器輸入軸
  15. The front / reverse switching mechanism was placed on the driving shaft, while the acceleration clutch was placed on the driven shaft

    前/后機械開關安裝在驅動軸上，同時加速離合器安裝在從動軸上。
  16. Two - way clutch rotor is attached to the output shaft, and clutch bearing cam is on the output - input shaft. when the right side is energized the output - input shaft is driven and when current is cut to the right side it disengages so the output - input shaft stops

    雙側的離合器轉子被固定在出力軸上而離合器的軸在出入軸上，當右側的離合器通過電流時出力軸就會被帶動，當右側斷電時離合器就會分離，出入軸就停。
  17. Automatic mechanical transmission as so called amt, accomplishes automatic gearshift based on manual fixed - shaft and dry clutch, which takes ecu as kernel, and then uses hydraulic system to control clutch, gearshift and manipulates throttle by adopting electronics technique and automatic gearshift theory

    電控機械式自動變速器（ amt ）是在傳統固定軸式變速器和乾式離合器的基礎上，採用電子技術和自動變速理論，以電子控制單元為核心，通過液壓執行系統控制離合器的分離與接合，選換檔操作以及發動機節氣門的調節來實現起步、換檔的自動操縱。
  18. When the clutch is energized the output shaft is driven ; and when the clutch is disengaged and the brake is energized, the output shaft stops

    當電流通過離合器時，出力軸被帶動，當離合器分離時，剎車有電流通過時，出力軸就停止。
  19. When the left side is energized the output - input shaft is driven, and when current to the left side is cut the clutch disengages and the output - input shaft stops

    當左離合器通電時出力軸被帶動，左側斷電時離合器就會分離，出力軸就停止。
  20. The clutch rotor is fixed on the input shaft and the clutch armature is fixed on the output shaft

    離合器的轉子固定在入力軸，而離合器的電極板與剎車被固定在出力軸上。
分享友人
分享到 Line

分享到臉書