coagulation bath 中文意思是什麼
coagulation bath
解釋
紡絲浴- coagulation : n. 凝固（作用）；凝結物。
- bath : n （pl baths ）1 沐浴，洗澡。2 浴缸；澡盆。3 浴室，（公共）澡堂。4 〈常 pl 〉（豪華的）大浴場；溫...
-
As the time in the first coagulation bath increases, the water flux decreases and the clearance rates of urea and creatintine both first increase, then decrease and increase a little at last
隨著在第一凝固浴中停留的時間越長，膜的水通量越低，肌肝和尿素的去除率均是先升高後下降然後稍有上升的趨勢。 -
As the temperature of the second coagulation bath increases, the water flux increases and the clearance rates of urea and creatintine first increase then decrease and increase a little at last
隨著第二凝固浴溫度的上升，水通量一直上升，肌肝和尿素的去除率先是上升，然後下降，最後又有略微上升的趨勢。 -
The dual - bath coagulation method suggested by j. a. va n ' t hof could be used in membranes with high selectivity clearance rate of low - molecular weight substances and moderate water flux theoretically. therefore it may be applied in the field of hemofiltration. to improve and optimize the performance of the pes ultrafiltration membrane applied in the hf, here the flat membranes and hollow fiber ( hf ) membranes are made in certain conditions based on the dual - bath coagulation method where pes is used as the membrane material, dmso as solvent and pvp & peg as additives this paper includes five parts as follow : 1
為了改善和優化聚醚碸超濾膜（單浴法）在血液過濾實際應用中的性能，本論文以j . a . van ' thof等提出的雙凝固浴法為基礎，以聚醚碸（ pes ）為主要成膜材料，以二甲基亞碸為溶劑，並添加一定分子量的致孔劑（ pvp ，聚乙烯吡咯烷酮）以及一定分子量的添加劑（ peg ，聚乙二醇）按照一定配比在一定溫度下製成透明均一的鑄膜液，靜置脫泡后在一定的工藝條件下製成聚醚碸平板膜和中空纖維膜，然後通過測試膜的結構和性能來評估其用於血液過濾中的前景。 -
Effects of coagulation bath temperature on the structure and performance of polyethersulfone hollow - fiber membranes by dry wet process
凝固浴溫度對相轉化聚醚碸中空纖維膜結構與性能的影響 -
3. the effects of the component and the time in the first coagulation bath on the structure and " properties of pes membranes are studied
3 .研究了第一凝固浴的組分和第一凝固浴中的停留時間對膜表層結構與膜性能的影響。 -
The dense top layer as well as porous supporting layer can be made by duel - bath coagulation method simultaneously
雙凝固浴成膜方法可同時獲得較厚的緻密表面層和疏鬆多孔的支撐層。 -
The effects of polymer concentration, solvent volatilization time, temperature and composition of coagulation bath and the thickness of membranes are studied for preparing the best nanofiltration membrane
實驗重點考察了鑄膜液固含量、溶劑蒸發時間、凝膠浴組成和溫度、膜厚等因素對所制納濾膜性能的影響。 -
With a decreasing cellulose concentration of casting solution or an increasing temperature of coagulation bath, the mean pore ssze becomes larger, resulting in higher pure water flux and lower rejection of bsa
隨著鑄膜液濃度的降低或凝固浴（純水）溫度的升高，膜的水通量有較大的提高，但截留率會明顯下降。 -
Effect of temperature of coagulation bath on structure and properties of lyocell fibers from bamboo pulp
凝固浴溫度對有機溶劑法再生竹纖維素纖維結構與性能的影響 -
4. the effect of the temperature and concentration of the second coagulation bath on the structure and properties of pes membranes are studied
4 .研究了第二凝固浴溫度和濃度對聚醚礬膜的結構與性能的影響。 -
In the case of high nmmo concentration of coagulation bath, the pure water flux is higher while the rejection can be kept at a relative high value
而改變凝固浴中nmmo的濃度則可制得高通量、高截留率、高應用價值的分離膜。 -
The results showed that when the nmmo concentration of coagulation bath is 20 %, the temperature is 25 and the cotton pulp concentration is 5 %, cellulose packaging films with the excellent mechanical properties can be prepared
結果表明，棉漿濃度為5 % ，凝固浴濃度為20 % ，凝固浴溫度為25時，可制得有較好力學性能的纖維素包裝膜。 -
Hemofiltration ( hf ) is an important applied field, membranes can be used for hf, which requires that the clearance rate of toxins such as urea and creatintine should be high and water flux should be moderate. membranes made by single - bath coagulation method either have high clearance rate and high water flux or have low clearance rate and low water flux
J . a . van ' thof等提出的雙凝固浴（ dual - bathcoagulationmethod ）成膜方法制膜從理論上可以達到肌肝、尿素選擇分離率高而水通量適中的要求，從而可能應用於血液過濾領域中。 -
By using atomic force microscopy ( afm ) investigation on the membrane surface, different separation properties can be explained very well according to the data of pore size. increasing temperature or nmmo concentration of coagulation bath or decreasing concentration of casting solution leads to larger skin pore size, wider pore size distribution and higher values of the roughness parameters
用原子力顯微鏡（ afm ）對膜表面形態的分析表明：膜表面孔徑隨著鑄膜液濃度的降低、凝固浴溫度和濃度的升高而逐漸變大，且孔徑分佈變寬。 -
With an increase of nmmo concentration of coagulation bath or concentration of casting solution, the crystallinity of membrane increases. however, an increase of temperature of coagulation bath is accompanied by a decrease of crystallinity of membrane
膜的結晶度隨鑄膜液濃度、凝固浴濃度、刮膜速度的增加而增大，隨凝固浴溫度的升高而降低。 -
Fibers based on poly ( acrylic - co - acrylamide ) ( caa ) and poly ( vinyl alcohol ) ( pva ) blends were prepared using n - hydroxymethyl acrylamide as a post - crosslinking agent. the blend aqueous solution was extruded into an acetone coagulation bath to form continuous caa / pva ( camp ) gel fibers via a wet - spinning method. the camp gel fibers were dehydrated by exchanging water with acetone, thermal - crosslinked
以n -羥甲基丙烯酰胺為后交聯劑，制備丙烯酸-丙烯酰胺共聚物聚乙烯醇共混物（ camp ）溶液，擠出成形后，經丙酮浴固化成形，並經后交聯，制備出具有較強吸水和保水能力，且有一定強力的camp纖維。
分享友人