coil insulation 中文意思是什麼

coil insulation 解釋
線圈絕緣
  • coil : vt vi 卷，盤繞，（把…）盤[卷]成一圈 （up）。n 1 （一）卷，（一）盤，（一）圈。2 螺旋管，蛇管。3 ...
  • insulation : n. 1. 隔離，孤立。2. 【物理學】絕緣，絕熱。
  1. The problem about neutral - point - grounding mode is an all - around technical problem which associated with not only power system reliability ， insulation coordination ， electromagnetic interference ， but assault safety 。 in china ， the neutral grounding modes of the 10kv net involved of none grounding, grounding by arc suppressing coils, resistance grounding or reactance grounding in the past 。 with the development of civic power network ， low resistance grounding mode was used to restrain the over voltage, particularly in guangzhou, shanghai ， beijing ， and zhuhai etc. it was reported that the over - voltage level of low resistance grounding mode is lower than that of arc suppressing coil mode, but the operation carried out the other way 。 at substations in guangzhou and shanghai it was found that the low resistance grounding mode is successful 。 but in some areas ， such as zhuhai ， substations grounding with low resistance revealed some problems ， including power supply reliability rapidly dropping ， transmitting line often tripping ； and person safety being threatened 。 so interiorly the grounding mode selection of the 10kv network was disputed, which mainly focused on the fault form of 10kv net grounding, the apply area of suppressing arcing coil grounding mode, power supply reliability level of the two modes, person safety, communication interfere and the workload of maintenance

    爭議點主要是在10kv電網接地故障的形式、消弧線圈接地的應用范圍、兩種運行方式供電可靠性的高低、人身安全、通訊干擾和運行維護工作量等諸多方面。 11 17本論文就是針對以電纜為主的城區10kv電網中性點接地方式的選擇問題進行研究。論文首先對10kv電網的中性點運行各種方式進行分析，比較各方式的特點，然後以重慶儲奇門變電站10kv電網的實際參數來建立數值計算模型，在考慮了電網接地電容電流變化、中性點電阻取值大小、接地點接地電阻值變化等多種影響因素的情況下，對中性點經消弧線圈接地和經小電阻接地方式下電網的過電壓水平和接地點短路電流大小進行了數值計算，其計算結果與電科院所作現場試驗進行了比較。
  2. Among them insulated the insulation resistance testing instrument to adopt the high direct voltage testing method ; the ac insulate testing instrument adopt to the instrument of ac high voltage, and we also designed the protected circuit with excessive current ; the coil insulate testing instrument is adopt surge voltage impact testing method

    其中絕緣電阻測試儀採用了直流高電壓測試法；工頻耐壓測試儀採用高壓工頻測試，並設計了過流保護電路；匝間耐壓測試儀採用浪涌電壓測試法，並設計了多路可控硅控制脈沖輸出電路。
  3. Recommended practice for measurement of power factor tip - up of electric machinery stator coil insulation

    電動機械定子線圈絕緣的損失角增量測量的推薦實施規程
  4. 2. after the electromagnetic coil has been vacuum and sealed in, then coverd the insulation shield, in order to increase heat conduction capacity and machinery strenth, conteol temperature rise and buzzer noise, and resist dampness and 8kv crest voltage thunder strucked

    2電磁線圈真空浸漆封閉后再套絕緣護套，即了熱傳導能和和機械強度，抑制了溫升和蜂鳴噪音，抗潮防濕，可抗擊8kv峰值的雷擊電壓。
  5. An inductor constructed by layering the coil between layers of core material, the coil typica - lly consists of a bare metal material ( no insulation ), this technology is sonetimes refferred to as ” non - wirewound ”. the inductance value can be made larger by adding additional layers for a given spiral pattern

    指一電感其線圈分佈在鐵芯材質的各層上，此種線圈常包含一裸露的金屬（非絕緣材料） ，這種技術有時亦叫做「非繞線式」 ，只要在既有的螺旋電路方式下，插入額外的層數，即可增加電感值。
  6. This paper is introduce the hardware module of computer - controlling testing instrument of electrical engineering ' s insulation performance. the testing instrument of electrical engineering ' s insulation performance is divided into three parts : insulation resistance testing instrument, ac insulate testing instrument and coil insulate testing instrument

    本論文在簡要的介紹了安全性能測試的目的，分類及要求之後，詳細的介紹了本人設計的電機安全性能測試硬體的三個部分：絕緣電阻測試，工頻耐壓測試和匝間耐壓測試。
  7. Alavizadeh, a. r., zargari, a., grise, w. r, ” the application of ansys software in analyzing and predicting thermal behavior ” electrical insulation conference and electrical manufacturing & coil winding conference, 1999. proceedings 26 - 28 oct. 1999

    卓玉娟， "有限元素法在汽車碟式剎車制動器之分析與應用」國立中興大學，土木工程學系， 2003年。
  8. Specifications for withstand voltage test on stator coil and winding insulation of high voltage ac machines

    高壓交流電機定子線圈及繞組絕緣耐電壓試驗規范
  9. Any material or component mounted on the outside of the motor, coil or transformer such that the material or component does not touch the windings or enter the confines of the outer wrap, is not considered part of the insulation system and need not be tabulated in the system description

    任何安裝于外部發動機、纏繞機或變壓器的材料或部件都不可接觸繞組線圈或外部遮罩的范圍，它們不屬于絕緣系統的一部分，所以不需要在系統描述中列出。
  10. Using for end of coil and outer insulation of electric component

    用於電子器件的外部絕緣和線圈的末端。
  11. Eis electrical insulation systems - procedures for thermal evaluation - part 22 : specific requirements for encapsulated - coil model - wire - wound electrical insulation system

    電氣絕緣結構.熱評價程序.第22部分:密閉線圈模型的特殊要求.線繞電絕緣系統
分享友人
分享到 Line

分享到臉書