cold pressure 中文意思是什麼

cold pressure 解釋
冷壓
  • cold : adj 1 冷,寒,凍;冰涼的。2 冷靜的,冷淡的,無情的,冷酷的;無趣味的;沉悶的;令人打冷顫的;掃興...
  • pressure : n 1 壓;按;擠;榨。2 【物理學】壓力,壓強;大氣壓力;電壓。3 精神壓力,政治[經濟、輿論等]壓力。4...
  1. Affusions use stream of water with or without pressure direct on various parts of the body knee, leg, full body, arm, face, chest, neck, lumber, etc. it can be cold, warm and alternate temperature

    -注水利用無壓或加壓水流以喉管直接澆在身體的各部位膝蓋,腳,全身,手臂,臉,胸,頸,淋巴等等。可以是冷水或熱水,也可以冷熱交替。
  2. Coolant temperature and ambient air pressure may be used to optimize cold starting and altitude performance.

    冷卻水溫度和大氣壓力可用於使冷起動性能和高原性能最優化。
  3. Abstract : apply computer simulation to the distribution pattern of air - flow without considering the cold condition of the combustion and compare the flow patterns under different designed circumstances. and the effect of the design of the partition in the air way of the burner on the flow and mixture of gas and air is especially studied. the result shows that the design of partition plays a very important role in strengthening the mixture of gas and air, but increases the loss of the resistance in the air way and the total pressure of the air way in same working conditions needs increasing

    文摘:應用計算機模擬的方法,在不考慮燃燒的冷態情況下,研究了熱風爐燃燒室內的氣流分佈規律.在此基礎上,比較了2種不同設計方案的氣流流動特徵,尤其是研究了燃燒器空氣通道內阻流板的設置與否對空氣和煤氣的流動和混合的影響.結果表明,阻流板的設計對加強空氣和煤氣的混合有著極為重要的作用,同時也增加了空氣管道的阻力損失,在同樣的工況條件下需要提高管道系統的總壓力
  4. The powder was pressed through molding and cold isostatic pressure, which increased the density and decreased the uneven distribution of stress inside the briquet to make the ceramic briquet equally compact

    粉料採取模壓和冷等靜壓相結合的方法壓制,增大了坯體內部的密度並減少了應力的分佈不均,得到均勻緻密的陶瓷坯體。
  5. Pipe joints and their elements for pipes of unplasticized polyvinylchloride unplasticized pvc under pressure ; sockets reducing of injection moulded for cold welding, dimensions

    未增塑聚氯乙烯受壓管道的管道連接件及其元件.第9部
  6. When heavy bleeding occurs, the injured will have these clinical features : pulse accelerating but weakening, blood pressure dropping, feeling thirsty, skin perspiring, cold and pale, feeling feeble and weak, feeling restless, respiration shallow and quick, showing signs of air hunger and cyanosis

    當大量出血時,傷者會出現以下之臨床表徵:脈搏快而弱血壓下降口渴皮膚濕冷及蒼白軟弱無力情緒不安呼吸淺速出現空氣饑及神智不清等情況。
  7. Once the cold water enters the flack, the vapor pressure falls quickly

    一旦冷水進入長頸瓶,水氣壓就迅速下降。
  8. The man sized head had is a marine sanitation system with electric toilet, hot / cold pressure water and the shower system separated

    衛生間配有自動抽水馬桶、壓力傳送冷熱水和淋浴裝置。
  9. The cold pressure of a new sadness on romola's heart made her linger the more in the silent soothing sense of nearness and love.

    羅摩拉心裏由於這種新的悲傷而產生的冰冷壓力,使她格外留戀這樣相互接近互相愛戀的默默的撫慰之感。
  10. The subject for different process technology and surface treatment of crank takes tracking checkout for its internal stress, analyses relation of jumping measurement, deformation measurement, recovery measurement and stress change, finds the reason and usual law of jumping overproof of crank. through cold pressure alignment, hot pressure alignment, support aged alignment and so on methods for 42crmo steel crank, the subject checks change of stress in the process of alignment and change of tissue and property after alignment for crank, and gives comprehensive evaluation for every alignment technology, then give safe and feasible technology parameter

    本課題主要是對不同加工工藝及不同表面處理過程的曲軸,對其內應力進行跟蹤檢測,分析各工藝過程中跳動量、變形量、恢復量與應力改變的關系,找出曲軸跳動量超差的原因和一般規律。通過對42crmo鋼曲軸進行「常溫壓力校直」 、 「熱壓力校直」 、 「支撐時效校直」等方法的校直,檢測校直過程中曲軸應力的變化及校直后組織和性能的改變,進而對各校直工藝進行綜合評價,給出安全可行的工藝參數。
  11. Atmospheric systems responsible for stratiform precipitating clouds in henan during spring and autumn are low pressure ? cold front, and surface cyclone

    造成河南春秋季層狀降水雲系的主要天氣系統有低槽冷鋒和地面氣旋兩大類。
  12. The diagnostic analysis for the sandstorm process on the base of height, temperature, pressure and wind etc output from the model shows that the upper cold trough, low - level wind shear, surface cold anticyclonic ridge, mesoscale cyclone and cold front are the main synoptic systems, surface cold anticyclonic ridge and cold front provide condition of wind force to occurrence of the sandstorm weather, the strong mesoscale cyclone before front makes pressure gradient before and after cold front obviously strengthen, moreover, and it increases obviously the temperature of the controlled area, as a result, the updraft movement caused by convergence before front strengthens

    500hpa強鋒區、 700hpa切變和鋒前中尺度系統的強弱及位置變化是沙塵暴天氣發生發展到減弱的直接原因。地面冷高壓、地面氣旋及冷鋒是造成本次沙塵暴天氣的主要地面天氣系統。地面冷高壓及冷鋒為沙塵暴天氣的發生提供了風力條件,而中尺度氣旋使冷鋒前後氣壓梯度明顯增強外,又使所控制的區域增溫明顯,使鋒前輻合上升運動加強,為沙塵暴天氣的發生提供了熱、動力條件。
  13. Everything else being equal, a cold air column, because of its higher air density, is heavier than a warm air column and thus produces a higher air pressure

    在一般相同情況下,冷空氣柱因其密度較高,會比暖空氣柱重,因而產生氣壓較大
  14. In - depth knowledge of supplier base in the following manufacturing processes / products : investment / lost - wax / precision casting, zinc die - castings, aluminum casting ( gravity & pressure ), iron casting, permanent mold casting, sand casting, powdered metallurgy, mim, steel forging, brass forging, cold forming, stamping, deep drawing, fine blanking, machining ( milling, turning, etc. ), sheet metal fabrication, screw machining, cnc machining, mould making, tool & die, assembly, fasteners, springs, etc

    對以下金屬製造工藝/零部件的供應商有資深專業經驗:脫蠟/精鑄件,鋅合金壓鑄件,鋁鑄件(澆鑄或壓鑄) ,鐵鑄件,永久模鑄件,沙鑄,粉狀冶金零件,金屬粉末注射成形件,鋼鐵鍛造,黃銅鍛造,冷鍛/冷鐓,沖壓件,拉深引深件,精密下料,機加件(自動車,數控機床,銑,車,磨等) ,板金件,制模及模具裝配、標準件,彈簧類。
  15. Cold chamber pressure casting

    冷室壓鑄
  16. Basing on the two order tangency at initial point between isotropic curve and hugoniot curve, a new method for calculating cold energy cold pressure and cohesive energy for solid is presented in the paper, comparison with experimental data manifest that this method is very good and can be applied

    利用在初始點等熵線和沖擊絕熱線二級相切的性質,給出了一種可用於計算固體冷能冷壓和結合能的新方法,並推導了利用hugoniot參數計算結合能的公式。與實驗數據的比較表明,這種方法是有效可行的。
  17. Vortex tube utilizes certain pressure gas as working medium producing the effect of separating, which makes the gas separating into cold and hot parts. the cold gas among them can be used refrigeration

    渦流管製冷是利用一定壓力氣體作為工質經過渦流管產生分離效應,使氣流分離成冷熱兩個部分,其中的冷氣流可用來製冷。
  18. 2. using cfd software - fluent, many flow states were been simulated. these states are the influence of nozzle structure with the flow, the distributing characteristic of inside flow, the influence of cold gas flow and outside flow with the work of the nozzle, the change of inside pressure load when the nozzle regulates

    2 、藉助cfd軟體fluent ,計算出可調噴管本身結構對流動的影響、可調噴管流場的參數分佈、冷卻氣流對噴管流動的影響、外流對可調噴管內流的影響、噴管的冷流流場和噴管調節過程中內壁面的壓強載荷變化。
  19. Our company is specialized in the production of swc, swp, swz, swl, swf crossed universal coupling, gcl, gcl, wgj drum rack coupling, ml, mll plum elastic coupling, etc. whats more, the company possesses the productive lines for cold - pressure strip steel with more than 20000 ton each year

    本公司是一家專業生產swc swp swz swl swf十字萬向聯軸器, gcl gcl wgj等鼓形聯軸器,球籠聯軸器, ml mll梅花彈性聯軸器等各種類型聯軸器的專業製造廠家。
  20. The cold pressure tank allows researchers to monitor the pain threshold ( the point at which volunteers first notice the pain ) and pain tolerance ( the point at which volunteers can no longer stand the pain )

    這個冰冷的壓力槽讓研究人員能監控疼痛門檻(志願者最先注意到疼痛的時間點)以及疼痛容忍度(志願者無法再忍受疼痛的時間點) 。
分享友人