cold-state temperature 中文意思是什麼

cold-state temperature 解釋
冷態溫度
  • cold : adj 1 冷，寒，凍；冰涼的。2 冷靜的，冷淡的，無情的，冷酷的；無趣味的；沉悶的；令人打冷顫的；掃興...
  • state : n 1 〈常作 S 〉國，國家；〈通例作 S 〉（美國、澳洲的）州；〈the States〉 美國。2 國務，政權，政府...
  • temperature : n. 1. 溫度，氣溫。2. 體溫。3. 〈口語〉發燒，高燒。
  1. Adopt advanced technic of f4 whole cold - press to moulding and heat melt to process to make, let the lining no slot to link withal cheek by jowl connect with exterior metalpipes wall, in the state of allowwing to work keep to distort in - phase, thereby to enhance using - life of lining in the working status of opposite high temperature high vacuum, stop the ecumenic pad fluorin pipes using in condition of cold and heat alternate and minus tension to come into being the matter of padding fluorin floor shrivel to jam the flowway and plastic rip, its perfect choice use to transport medium of strong corrosive strong oxidation by modern chemical - industry corporation

    採用氟塑料f4整體冷壓成型及熱熔加工等先進技術製造，使內襯層無縫搭接且與外層金屬管壁緊密粘接，在允許工作狀態下能夠保持同步變形，從而提高了襯里層在相對高溫高真空度的工況下的使用壽命，杜絕了一般襯氟管在冷熱交替，及負壓的條件下使用易產生襯塑層鼓癟阻塞流道及塑料拉裂的問題，是現代化工企業在輸送強腐蝕強氧化介質理想的選擇。
  2. After thermodynamic calculation on several operation conditions of the furnace, cold - state flow and resistance mensuration, the combustion of the tubular - furnace hearth was changed into swirl and addition of radiate cylinder and oxygen content detection minish 1. 25 surplus air to less than 1. 15, improving the combustion condition and convection and radiate heat transfer efficacy, resuling in reducing the waste - gas temperature 45, decreasing exhaust gas loss, and saving fuel by 6 %

    摘要通過對加熱爐幾種工況進行熱力計算、冷態試驗的流場分佈及阻力測定和熱態試驗的爐膛溫度場分佈及管壁溫度等參數的測定，確定將管式加熱爐爐膛內直流燃燒改為旋流場燃燒和增加輻射筒，增設煙氣含氧量分析，可以將燃燒的過剩空氣系數從1 . 35減小到1 . 15以下，極好地改善爐膛內的燃燒狀況和對流輻射傳熱效果，從而降低排煙溫度45 ，減少加熱爐排煙損失，節約了煤氣量6 %以上。
  3. 2 ). it has a great temperature gradient along the height in hot and cold plenums of cefr in steady state. the buoyancy force cannot be ignored because the flow velocity is low in the whole flow regions

    冷熱鈉池在穩態工況下沿高度方向有很大的溫度梯度，整個流動區域內的流速較低，浮升力的影響不可忽略； 3
  4. On the basis of the analysis of fundamental principle of thermoelectric refrigeration, the steady state mathematical model of the thermoelectric system was founded. according to the model, the theoretical analysis and calculation are made on various working conditions, and analyzed theoretically the effects on thermoelectric system which caused by hot and cold temperature difference, the device ’ s effective system figure of merit, the properties of the heat changers, which established theoretical basic for the opening up and design of the thermoelectric system and its performance test

    在分析熱電製冷基本原理的基礎上，建立了熱電裝置的穩態系統數學模型，並依據該模型對熱電裝置系統進行了不同的工作狀態下的熱力分析計算，並就熱電裝置的冷熱端溫差、電堆片的優值系數、散熱器的散熱性能與熱電熱泵裝置性能的影響進行了理論分析，為熱電裝置的開發設計和現有熱電裝置的性能測試建立計算理論基礎。
  5. The optimal performance state ' s parameter of thermoelectric refrigerator under different work conditions was obtained on the assumption that the temperature in the cold side is invariable. and, the optimal performance state ' s parameter of thermoelectric refrigerator under the third kind boundary conditions was also obtained. the transmission of heat differential equation for the heat conduction process of thermoelectric module was derived and the solution with the first kind boundary conditions under the influence of thomson effect and the solution with the third kind boundary conditions without the influence of thomson effect was obtained

    在假設熱電製冷的熱端溫度固定的條件下，得出熱電製冷器在不同工況下的最佳工作參數並進一步求得在三類邊界條件下的最佳工作參數;導出了電偶臂在電與熱的偶合作用下傳熱微分方程，並對其進行解析求解:在考慮湯姆遜效應的影響下得出一類跟三類邊界條件下傳熱方程的解析解，在忽略湯姆遜效應的影響下得出二類跟三類相的邊界條件下傳熱方程的解析解。
  6. Abstract : based on the research of the three - dimensional models of glass batch, molten glass flow and heat transfer within glass furnaces, the result of graphic simulation of temperature and velocity fields are given. by comparison with the erosion refractory photos in the cold state of 300 t / d float furnace of hangzhou float glass industry ltd., the reliability of the models is proved. at the same time, the effect of glass temperature and velocity fields distribution on erosion of refractory with in float glass furnace are discussed

    文摘:通過對窯內配合料及玻璃液流運動和傳熱的三維數學模型研究，對玻璃液溫度場和流場進行了圖形模擬，將模擬結果與杭州浮法玻璃工業有限公司300噸級浮法窯冷修時所拍攝的各部位耐火材料被侵蝕情況照片進行了比較、分析，驗證了模型的可靠性，並分析耐火材料的被侵蝕與玻璃液溫度場和流場分佈的影響。
分享友人
分享到 Line

分享到臉書