collector diffusion 中文意思是什麼
collector diffusion
解釋
集電極擴散-
The optimum conditions for air electrode preparation were shown as follow : 20 % ptfe and 20 % mno2 in active layer, thickness of active layer 0. 15 - 0. 25mm and the ratio of active carbon to ethine black 4 : 1 ; 60 % ptfe in the gas diffusion and waterproof layer, employing na2so4 as pore - making agents, thickness 0. 35 - 0. 45mm, colding forming and layer sequence catlytic layer / gas diffusion and waterproof layer / current collector layout ; employing 40 meshed nickel screen as current collector and thermal treatment temperature over 200
確定了制備空氣電極的優化工藝條件，催化層中ptfe含量約20 ， mno _ 2的最佳含量約為20 ，催化層中活性炭和乙炔黑的比例為4 ： 1 （質量比） ，厚度在0 . 15 - 0 . 25mm之間。防水透氣層中ptfe的含量約為60 ，以無水硫酸鈉作為造孔劑，厚度一般為0 . 35 - 0 . 45mm 。電極各層採用催化層/防水透氣層/集流體的排布方式，冷壓成型，熱處理對空氣電極的性能影響較大，熱處理溫度不低於200 。 -
After finished the cyclic voltammetry experiments, the results showed that iron steel grid can act as good current collector in the aqueous electrolyte. while the scan rate was fall in the range of 0. 5 - 4. 0mv / s, electrochemical reaction of the lithium insertion / extraction in the solid phase was kinetically limited by the diffusion of lithium ions. after 40 cycles in aqueous electrolyte the discharge capacities of sample of s13 reached 77mah / g, and showed good cycle performance
在水溶液中不銹鋼網可以作為電極的集流體，在0 . 5 - 4 . 0mv / s的掃描速度范圍內，鋰離子在尖晶石鋰錳氧化物的嵌入和脫嵌的電化學反應在動力學上是受鋰離子在固相中的擴散所控制，充放電實驗顯示樣品s13在水電解液中經過40個循環后達到77mah / g的放電容量，具有很好的循環穩定性。 -
Collector diffusion isolation
集極擴散隔離
分享友人