combustion chamber wall 中文意思是什麼

combustion chamber wall 解釋
燃燒室壁
  • combustion : n. 1. 燃燒，發火，點火。2. （有機體內營養料的）氧化。3. 騷動。
  • chamber : n 1 〈古、詩〉室，房間；寢室，臥室；〈pl 〉套房；〈pl 〉律師[法官]辦公室。2 會議室，會場；議會，...
  • wall : n 1 墻壁；（石、磚等的）圍墻；城墻。2 （形狀、用途）像墻壁的東西，障壁；土堤，堤防。3 （礦井、容...
  1. It is discovered that the combustion condition of the second stage pc is up to the outlet temperature of the first stage pc and the content of combustible gases in first stage flue also plays positive effect on the ignition of second stage pc. the effects of parameters of two coal - air mixture, wall temperature of first ignition chamber and annular filling air on imfit are studied experimentally in this thesis. in this thesis, the numerical simulations of ignition and combustion of pc in imfit are conducted

    本文通過建立數學模型，對感應加熱煤粉多級無油點火進行數值模擬，研究了一級煤粉煤粉在點火室內的著火過程和二級點燃過程、煤粉粒徑分佈對煤粉多級無油點火的影響，研究了一級點火室壁面溫度、一級煤粉氣流和二級煤粉氣流的風粉參數在煤粉多級無油點火過程中的影響規律；根據二級點燃段的流場和溫度場分佈，研究了環形夾心風推遲二級煤粉著火的機理。
  2. Great difference in pressure for two flow made pressure wave system and it help to extend the delay time for gas in chamber, which increases combustion effusion. second, to increase combustion effusion, the inlet temperature of air and gas should be enhanced in the range of heat releasing in chemical reaction. third, the first work condition is unburned absolutely and the second work condition is burnt in shear layer of inlet and the end of down wall zone in straight segment

    對于壓力差很大的兩股氣流，所形成的壓縮波系的結構可以增加燃氣駐留時間，提高燃燒穩定性;為了提高擴散燃燒的效率，在保證能放熱的化學反應溫度范圍之內，應適當提高燃氣及空氣的來流入口溫度;燃氣噴嘴應居於燃燒室軸線上，是改進超音速燃燒室結構的一種思路。
  3. Referred and analyzed the developing and researching achievement of high turbulent combustion chamber on diesel engine in the world, the grooved combustion chamber is designed and developed based on the rationale of designing high turbulent combustion chamber and employed the effect of the grooved of the combustion chamber wall on the spray impingement

    在分析和參考國內外柴油機高紊流燃燒系統開發研究成果的基礎上，根據高紊流燃燒室設計的理論基礎，利用矩形環槽對燃油噴霧撞壁效應能加速混合氣形成的機理，設計開發了在燃燒室側壁上加工有矩形環槽的燃燒室方案。
  4. The research indicated that, if the secondary combustion chamber was looked on as a controlled object, with the adjusting valve as a input, the pressure and the temperature of a selected point on the inside wall of the combustion chamber as outputs, then such controlled system would be a strongly non - linear, time varying system with number of random disturbances, which resulted in huge difficulty to build an analyzed mathematics model for the spray burning of the liquid fuel, so that classic control methods were all invalid

    研究表明，若將rbcc發動機的二次燃燒室視為一個控制對象，同時以燃燒室內壁面取定點處的壓強、溫度和調節閥的開度為輸入輸出變量，則該系統將是輸入?輸出特性非線性很強、隨機干擾嚴重的復雜時變系統。這導致建立燃油噴霧燃燒具體模型的很大困難，從而宣告了經典控制方案的失效。
  5. The experimental investigations were first conducted on diesel spray wall - impingement mixing process with or without a bump on a flat wall and in a combustion chamber by means of plif method in the self - made constant volume combustion spray simulation set - up which can reproduce the typical working conditions and high - pressure fuel injection of modern diesel engines. the simulation computation of a cfd code about them was then carried out

    首先在自行研製的、可以模擬現代柴油機典型工作環境及高壓燃油噴射特性的定容燃燒噴霧模擬裝置上用片狀激光誘導熒光法（ plif ）對平壁上、燃燒室內不設置和設置bump的柴油噴霧撞壁混合過程進行了試驗研究，然後又用cfd多維數值分析軟體對其進行了模擬計算。
  6. The last or main injection pulse is set around tdc. when the diesel spray impinging on the combustion wall, the bump around the combustion chamber wall can strip off the wall jet and form a secondary spray in combustion chamber, so the fuel and air can mix well and homogenous

    在主噴射時刻，利用燃燒室壁面的bump迅速剝離壁面射流，在空間形成二次射流，二次射流進入燃燒室空間后，再一次與空氣混合，形成相對均勻的稀混合氣。
  7. Research on heat treatment deformation of big diameter thin wall combustion chamber case

    大直徑薄壁燃燒室殼體熱處理變形研究
  8. By simulated supersonic combustion in ‘ double - chamber ’, wall - pressure value is compared with experimented data. the simulated values accord well with experimented data

    通過對「雙燃室」結構的數值模擬，將壁面壓力值與實驗值對比，其計算值較好地符合了實驗值。
分享友人
分享到 Line

分享到臉書