composite network 中文意思是什麼
composite network
解釋
復合網路-
It is shown that paraffin can be uniformly absorbed into the pore network of expanded graphite, that expanded graphite remains its vermiform structure in pcms, that the phase - change temperatures of composite pcms are similar to that of paraffin, and that the latent heat of composite pcms is are based on the mass fraction of paraffin in the composite materials
結果表明：膨脹石墨吸附石蠟后仍然保持了原來疏鬆多孔的蠕蟲狀形態，石蠟被膨脹石墨微孔所吸附；復合相變儲熱材料的相變溫度與石蠟相似，其相變潛熱與基於復合材料中石蠟含量的潛熱計算值相當。 -
This article is to analysis the building fire automatic sprinkling system, which accords the formulate of automatic sprinkling fire system design specification ( gb50084 - 2001 ), uses hydraulic computation and basic formula, on basis of automatic system network configuration, and adopts project programming software visual basics. 0 and microsoft access2002 data base to composite hydraulic computation program of building fire system, and to realize building fire automatic sprinkling system design computerized
本文對建築消防自動噴水滅火系統（以下簡稱：自噴系統）的分析，依據《自動噴水滅火系統設計規范》 （ gb50084 - 2001 ）的規定，利用水力計算方法和基本公式，在自噴系統管網布置的基礎上，採用工程編程軟體visualbasic6 . 0和microsoftaccess2002數據庫進行建築消防系統的水力計算程序編制，實現建築消防自噴系統設計中的計算機化。 -
The microgels of close monodispersity with different volume and cross - linking density can be prepared by using an inverse emulsion polymerization method. both artificial and natural materials, including zeolites, membranes, vesicles, liquid crystal, microemulsion, micelles, biopolymers, etc., have been used as template. the three - dimentional network structure and spherical morphology of polymeric microgels may guarantee the homogeneous of the structure of the composite, the size and the morphology of the various organic - inorganic composites with unusual structures
在反相乳液聚合條件下，通過控制反應條件可以得到體積不同、交聯度不同的近乎單分散的微凝膠，如同分子篩、單（多）分子膜、囊泡、液晶、微乳液、膠束、生物大分子等可作為微納米無機材料合成模板一樣，高分子微凝膠所特有的三維網路結構和球形形貌有可能對在其中進行的無機結晶或沉積反應施加限域和導向作用，從而控制所生成無機材料的形貌和大小，得到各種具有特異結構的無機-有機復合材料。 -
( 3 ) with the conception of quantum probability and composite method of path in network, the earliest time of node merged with two or more paths is corrected, and then make a dummy activity which follows the node and which holds a duration time that the earliest time of the node added time after the paths are merged, and the subsequent work of the node follow the dummy activity
採用線路合成，引進當量概率概念，對pert網路中有二條以上匯入線路節點的最早時間進行修正，並將修正後增加的時間作為一新活動（工序）的持續時間，然後將該新活動作為原節點的緊后工序，而原節點的緊后工序作為該新工序的緊后工序。 -
This article describes the development process of surrogate models and introduces some experiment design methods and approximation approaches that can be used for a mdo surrogate model, they are full factorial experiment design, orthogonal experiment design, uniform experiment design, central - composite experiment design, and polynomial response surface method, kriging method, radial basis function method and artificial neural network
為此本文中分別介紹了正交試驗，均勻試驗以及中心復合試驗等幾種試驗設計方法，以及多項式響應面， kriging ，和徑向基函數等幾種數學近似方法。並且通過構造描述機翼展向升力分佈的代理模型，對上述幾種方法作了對比分析。 -
A 4x4 optical fiber network embedding in composite materials is designed to determine the feasibility of the self - diagnose program. finally, the method of self - repair using hollow optical fiber filled adhesive is put forward. two samples are made to study the performance
在此基礎上設計了一個可以實現損傷診斷的3x3空心光纖網路構成的智能結構自診斷系統，並按照小型化、經濟化等要求完成了光源的選擇、發光和接受電路的設計、耦合介面和數據採集系統的研究。 -
Based upon the practical situation against harm bird fault in thepower network of xiangfan power supply bureau, this paper introduced the characteristic of the bird harm fault, and analyzed its trip reasons and presented its integrated prevention method such as the installation of the sound arouser, composite sheds, repelling board, shield, sting, net, etc
結合襄樊供電局所轄線路防止鳥害的實際，介紹了鳥害的特點，分析了鳥害跳閘的原因，提出了安裝驚鳥器、復合傘裙、防鳥擋板、防鳥罩、防鳥剌和防鳥網的綜合防止鳥害措施。 -
This composite pipe has its shell constructed with metal with brackets by point welding u - shape tortoise shell network in the inner wall and stuffed with rare earth wearable materials making the pipe enjoy better anti - eroding and wear resistant capability
本產品是以金屬為殼體，管內壁點焊u型或工型龜甲網作為支架，龜甲網內填充稀土耐磨材料的復合管道，具有更好的抗耐磨、抗沖刷性能。 -
In this paper, monte carlo ( mc ) method is used in the research of distributing of construction duration and computation of time parameter of pert network. according to probability viewpoint, critical line and key degree of activity in the network are also defined. aiming at the limitation of application of the mc in large scale the network, the simplified computational method for the network is presented with quantum probability theory and composite method of path in network
本文用mc （ montecarlo ）方法研究了施工工期的分佈規律和pert （ programevaluationandreviewtechnique ）網路的時間參數的計算；用概率論的觀點定義了pert網路主導線路和關鍵度；針對大型施工進度網路mc方法應用的局限性，採用線路合成方法，引進當量概率概念，提出了pert網路的簡化計算方法；根據工程搭接施工網路的特點，將其轉化為廣義pert網路，探討了其施工進度風險的計算。 -
In addition, by treating the conductivity data, tunneling conduction was found to be present in the nanocomposites, which also could be used to account fo r the non - universality of the critical exponent. investigations into the microstructures of the nanocomposites revealed that the nanosheets form " house of cards " conducting network spanning across the whole composite
對該納米復合材料的微細結構的研究表明，納米石墨薄片在尼龍6基體中形成類似於「卡片屋」 （ 「 houseofcards 」 ）結構的導電網路，貫穿整個復合物體系。 -
The resulting composite particles showed well responses to electric and magnetic fields, which was reflected by the formation of network structure under electric and magnetic fields superimposed perpendicularly
結果表明，所制得的鎳聚苯乙烯二氧化鈦（ ni pst tio _ 2 ）復合微球對電磁場有良好的響應性，在相互垂直的電場與磁場作用下排列形成了一種網狀花樣結構。 -
Secondly, two carbon fiber reinforced composite beams were fabricated, and their modal frequencies were measured by an experiment method. thirdly, delaminations were modeled by pairs of nodes with the same coordinates but different node numbers, while the modal frequencies of these beams with different delamination location and size were computed by an eas piezoelectric solid element. moreover, a novel method combining computational mechanics and neural network was demonstrated for composite health monitoring ; the first five flexure modal frequencies obtained by fem were modified by a primary revising approach and were used to train the neural network
本文較全面地評述了神經網路的應用模型、改進演算法等，編制了bp神經網路程序：制備了纖維增強復合材料試件，並進行實驗模態分析；利用坐標相同、節點號不同的方法模擬脫層損傷，基於eas列式的壓電固體單元計算了不同脫層損傷情況下的頻率信息；針對基於實驗數據訓練神經網路存在樣本不足的缺陷，本文提出了利用有限元方法對含有脫層損傷的復合材料試件進行數值模擬，以前五階彎曲模態頻率構建訓練樣本的新思路，並提出了一種初步的計算值修正方法，以此構建神經網路的訓練樣本：將實驗模態分析的結果送入訓練好的神經網路進行預測，實現了對復合材料梁的脫層損傷的定位和損傷程度的評估。 -
This composite pipe has its shell constructed with metal with brackets by point welding u - shape tortoise shell network in the inner wall and stuffed with nanometer wearable materials making the pipe enjoy better performance in high - temperature resistance, anti - eroding, acid resistance and wear
本產品是以金屬為殼體，管內壁點焊u型或工型龜甲網作為支架，龜甲網內填充納米耐磨材料的復合管道，具有更好的耐高溫、抗沖刷、耐酸、耐磨損等特點。 -
The physical meaning of the fuzzy neural network parameters and their influence on the model performance are discussed through the research of composite liquid - solid extrusion model, and the reasonable method of evaluating the network parameters is confirmed which can quicken the training speed. some problems and the influence of the evolution operator on the optimization course are discussed, arid the reasonable range of the evolution parameter is concluded
通過對復合材料液-固擠壓成形工藝系統建模的研究，探討了模糊神經網路參數的物理意義及其對網路學習速度的影響，確定了可加快網路學習速度的參數賦值方法；結合液-固擠壓工藝特點探討了利用遺傳演算法進行參數優化過程中一些問題的處理方法及遺傳操作運算元對優化過程的影響，確定了參數選取的合理范圍。 -
Artificial neural network optimization method for ceramic martix composite design
復合陶瓷材料設計中的人工神經網路優化方法 -
Introducing the composite furniture and equipment grant for aided schools with effect from the 2001 02 school year ; developing the basic competency assessments ; and implementing the district teacher network scheme
落實教育制度改革的多項措施，包括提供更多與幼兒教育有關的訓練加強為有特殊教育需要的學生提供的支援由二一至二學年起實行向資助學校發放綜合傢具及設備經常津貼制訂基本能力評估以及推行地區教師專業交流計劃 -
The composite ga - rbf network was applied in this artificial olfactory system for pattern recognition
依據肉氣味模式，採用遺傳優化的組合rbf神經網路作為模式識別方法。 -
Thirdly, researching data communication on network, data communication with socket and http protocol is proposed. reliability, real time, concurrency of message and model data is ensured. fourth, a new composite query method of local and long - distance, information of feature and geometry based on long - distance service of the cad software are implemented
4 、研究了產品模型信息查詢技術，提出了本地與遠程相結合的混合式查詢框架，並在客戶端採用ug二次開發技術實現了基於遠程cad軟體應用服務的特徵和幾何信息的遠程查詢。 -
Based on summarizing the actual research status, developing prospects, and the characteristic of different ways in preparation for silicon based composite, three ways were chosen, which was pyrolysis for si - phenolic resin prolyzed carbon material, using different catalyzer to prepare for si - o network coated silicon and carbon complex composite, easily chemical and deoxidizing reaction for super tiny metals mixed silicon and carbon complescomposite
通過高溫熱解法制備了硅-酚醛樹脂（ pf ， phenolicresin ）熱解碳材料。在700的條件下制備了硅-酚醛樹脂熱解碳材料，發現si和熱解碳的質量比為3 : 7時材料具有最優異的性能，首次脫嵌容量為394 . 7mah ? g ~ （ - 1 ） ，充放電效率為50 % 。 -
The fifth chapter determines integrities of some special kinds of graphs such as grid, tori, line graph, composite graph and gives a relationship between the edge - integrity of a graph and integrity of its line graph, and then like the study of integrity, some relationships between the edge - integrity and some other parameters are given, then the maximum network is determined on the basis of order and edge - integrity are given
給出了幾類特殊圖，如格子圖、線圖、復合圖等的邊完整度；研究了圖的邊完整度與其線圖的完整度之間的關系；研究了圖的邊完整度與圖的其它參數之間的關系；研究了邊完整度給定條件下的最大網路圖。
分享友人