composite stress 中文意思是什麼

composite stress 解釋
復合應力
  • composite : adj 1 併合的,復合的,混成的,合成的,集成的。2 【建築】混合式的;【造船】鐵骨木殼的。3 【植物;...
  • stress : n 1 壓力,壓迫,緊迫,緊張。2 【語音】重音;重讀;【詩】揚音;語勢,著重點。3 重要(性),重點,...
  1. Based on the close analysis of the influence factors of the vertical bearing capacity, circular aperture extension theory is employed to establish the computing formulas for the pile vertical stress and the foundation vertical bearing capacity, respectively. moreover, with analyzing the features of the calculation parameters such as materials of gunite mortar, jet pressure, diameter of the jet pipe, pile length, pile layout, a design theory for chemical churning pile composite foundation is proposed. then, the variation of the pipe deformation with loads, the deformation coordination of pile and soil are studied

    在此基礎上深入探討了旋噴樁的樁土受力特性及其復合地基的加固機理,從影響旋噴樁復合地基豎向承載力的因素入手,基於圓孔擴張理論給出了樁體豎向應力及旋噴樁復合地基的豎向承載力計算公式;通過對噴射漿液、噴射壓力選取、噴射直徑估算、樁長及樁位設計等各種計算參數的深入分析和研究,提出了一套相應的旋噴樁復合地基設計計算方法;通過計算分析,深入探討了旋噴樁復合地基變形隨荷載變化規律、樁和樁間土變形協調關系、樁土應力比及復合地基壓縮模量的確定,並提出相應的設計方法和修正參數;此外,結合工程應用,對旋噴樁復合地基的施工技術及其現場質量檢測方法進行了較全面的探討。
  2. Stress redistribution around a broken fiber in an intermingled hybrid composite sheet

    層內混雜復合材料斷裂纖附近的應力重分佈
  3. With the wide application of carbon / phenolic composite in spacecrafts and missile hulls, the prediction of dynamic response or internal damage of structures subject to explosion, impact or the shock wave induced from the sediment of high - energy particle beam and the evaluation of capability of composite in defending stress wave, aroused the study of the constitutive relation and the characteristic of stress wave propagating

    隨著碳酚醛在航天飛行器結構及導彈殼體中日益廣泛的應用,預測結構受到爆炸作用、沖擊或由於高能粒子束在其表層大量沉積而產生的應力波所引起的動態響應及內部損傷,以及對其防護應力波的性能進行評估等,都需要對碳酚醛的本構關系以及應力波在其中的傳播特性開展研究。
  4. Finite element analysis of microscopic stress state of a plain weave glassfiber composite

    纖維織物增強復合材料微觀應力場的有限元分析
  5. Through the analysis we found that the effect will become more obviously with the increase of thickness or width of superstratum and the decrease of the coefficient of foundation bed ; ( 3 ) anisotropy and nonlinear elastic f. e. m. model has been established and the effect of stress dispersion in compound two - layer foundation was analyzed on the base of the model. from the analysis we can conclude that the coefficient of subsidiary stress dispersion will amplify with the increase of thickness or width or stiffness of back - up coat ; ( 4 ) the formula which can be used in conventional calculation has been deduced for calculating the coefficient of subsidiary stress dispersion and it also has been affirmed to be reasonable through the checking calculation ; the whole theory of compound two - layer foundation has been brought forward in this paper and it ' ll enrich the theory of composite foundation

    針對以上問題本文做了以下一些工作並得到若干結論: ( 1 )提出了「復合雙層地基」的概念,並通過工程實例證明此概念的提出有其合理性和必要性; ( 2 )用彈性地基梁理論證實了復合雙層地基確有應力擴散效應,且擴散效應隨上覆硬層厚度、剛度的增加而增大,隨下臥層基床系數的增大而減小; ( 3 )建立了非線彈性、各向異性有限元模型,並以此為基礎分析了復合雙層地基的應力擴散效應,得到附加應力系數隨加固層厚度、寬度、剛度的增加而增大的結論; ( 4 )推導了可用於常規計算的復合雙層地基應力擴散系數公式,並代入工程實例進行了驗證。
  6. Based on the result of the comparision static penetrat ion test and field vane shear test before and after the treatment of soft founda tions for a experimental section, and based on four static loading tests for two single piles and two composite foundation, behaviors of soil among piles before and after the construction of powder - spray piles and the pattern of the ch ange of the stress ratio between piles and soil are studied, a new determination met hod for bearing capacities of cement powder - spray piles and composite foundati on is proposed, and the formula for calculation of composite foundation bearing capacity are revised

    基於某試驗路段軟基處理前後靜力觸探、十字板試驗的對比測試和對兩根單樁、兩處單樁復合地基進行的4次靜載試驗,研究了樁間土性狀在施工水泥粉噴樁前後的變化和樁土應力比的變化規律,提出了根據靜載試驗確定粉噴樁及其復合地基承載力新的取值方法,並修正了復合地基承載力的計算公式。
  7. Abstract : based on the result of the comparision static penetrat ion test and field vane shear test before and after the treatment of soft founda tions for a experimental section, and based on four static loading tests for two single piles and two composite foundation, behaviors of soil among piles before and after the construction of powder - spray piles and the pattern of the ch ange of the stress ratio between piles and soil are studied, a new determination met hod for bearing capacities of cement powder - spray piles and composite foundati on is proposed, and the formula for calculation of composite foundation bearing capacity are revised

    文摘:基於某試驗路段軟基處理前後靜力觸探、十字板試驗的對比測試和對兩根單樁、兩處單樁復合地基進行的4次靜載試驗,研究了樁間土性狀在施工水泥粉噴樁前後的變化和樁土應力比的變化規律,提出了根據靜載試驗確定粉噴樁及其復合地基承載力新的取值方法,並修正了復合地基承載力的計算公式。
  8. Study on stress concentrations in an intraply hybrid composite sheet

    層內混雜復合材料應力集中問題的研究
  9. The sort, material composite, structure properties and conduction mechanisms of eca ( electrical conductive adhesive ) were discussed in this paper. then three types of ega specimens were designed and made, on which temperature cycles test from - 55 ? to + 125 ? and thermal aging at + 125 ? were carried out. changes of the adhesive strength, eca ' s bulk resistance and contact resistance under the environment stress were summarized and a detailed evaluation on these specimens was given

    本文在全面闡述導電膠的分類組成、物理結構、導電機理的基礎上,設計並製作了三批導電膠樣品,通過對樣品進行長時間的- 55 ? ? + 125溫度循環和125高溫存儲試驗,總結了導電膠粘接強度、體電阻和接觸電阻在環境應力下的變化規律,對三類樣品的長期可靠性做出了全面的評價,並結合導電膠電阻率和「穿流閾值」的計算機模擬,給出了提高導電膠可靠性和電導率的建議,介紹了國內外在高電導率高可靠性導電膠研製方面的一些最新進展。
  10. Corresponding mathematics model was developed, hole - edge stress analysis on composite material plate with multiform holes was carried out, accurate boundary conditions was founded by conformal mapping method, boundary problems of the two stress functions could be treated by affine transformation in the same way synchronously

    建立了相應的數學模型,對含不同孔型復合材料板進行了孔邊應力分析,通過保角映射方法建立精確的邊界條件,解決了復雜孔型的邊界條件問題,藉助仿射變換能同時並且同方法的處理這兩個應力函數在邊界上的問題。
  11. The result reveals that the stress control tube comprising a composite structure of the nonlinear resistive and capacitive material shows the best performance in improving electric field distributions in cable terminations

    分析結果表明,採用由電容性和非線性電阻性材料復合絕緣結構的應力控制管時,電纜終端的電場分佈最為均勻。
  12. The result reveals that the stress control tube comprising a composite structure of the nonlinear resistive and capacitive material shows the best performance in uniforming the electric field distributions in cable terminations under impulse voltage

    分析結果表明,在沖擊電壓下電纜終端採用由電容性和非線性電阻性材料復合絕緣結構的應力控制管時,電場分佈最為均勻。
  13. The conclusions obtained as follows : firstly, the structure ' s free frequency is decreased by the reduction of the mechanical property of the material with the increasing temperature ; secondly the thermal stress produced by the temperature gradient may decrease or enlarge the structures natural frequency ; thirdly, the variety of natural frequency of the alloy structures effected by the heat effect apparently higher than that of the composite material structures

    最後,採用ansys程序分析了合金材料、復合材料的板、彈體結構的熱振動特性。在不同的熱載條件下,取得以下結論:升溫導致的材料機械性能下降都會降低結構固有頻率,而溫度梯度產生的熱應力可能降低也可能提高結構的固有頻率;金屬材料結構的固有頻率受溫度的影響要比復合材料結構的固有頻率受溫度的影響要明顯。
  14. Analysis of stress and strain on the composite foundation of the gravel piles

    碎石樁復合地基應力應變分析
  15. Fgm has many superior properties such as eliminating interface crack between the two materials, reducing the thermal and residual stress, thermal barrier, thermal shock resistance, anti - corrosion, increasing the bonding strength and toughness, high - temperature strength ( to 2000 c ) etc., as compared with traditional composite materials

    它較目前廣泛使用的隔熱性耐熱復合材料有許多優點,如可以消除材料間的界面,緩和熱應力,具有較高的機械強度,抗熱沖擊性和耐高溫性(達2000 )等。
  16. Interlaminar stress and damage mechanism of thermoplastic composite laminates

    熱塑性復合材料層合板的層間應力與損傷機理
  17. Interlaminar stress analysis of composite laminates subjected to in - plane loading

    受面內載荷的層壓復合材料的層間應力分析
  18. Interlaminar stress analysis of the thick thermoplastic as4 peek angle - ply composite laminates

    角鋪設層合板的層間應力分析
  19. Based on the temperature field obtained by the thermal analysis, a parametric analysis is conducted to investigate the interlaminar stress at the interface between the composite and the thermal barrier in the cross - section of the inlet duct, using the commercial finite element software ansys

    在熱分析的基礎上,採用ansys有限元軟體計算了復合材料進氣道截面在假設工況下的應力場,為碳纖維纏繞復合材料進氣道熱防護方案的設計提供了實用的參考依據。
  20. Then discuss the stress concentration problem of the honeycomb structure to use the model of “ laminated composite structure with circular hole. then discuss the thermal control technique of the mfs, and built the model of heat transfer

    考慮到在蜂窩結構板上開設埋孔會引起應力集中的現象,所以還進行了對復合材料板應力集中問題的理論分析,得出了「帶圓孔的復合材料層板」應力集中系數的表達式。
分享友人