compressive reinforcement 中文意思是什麼

compressive reinforcement 解釋
抗壓鋼筋
  • compressive : adj. 有壓力的，壓縮的，壓榨的。adv. -ly ,-ness n.
  • reinforcement : n. 1. 增強，加固；補強物，強化物；補給品。2. 增援，支援；〈pl. 〉增援部隊，援軍；救援艦。
  1. Specimens ’ cracking load under dead - load, fatigue failure characteristic, fatigue life, deflection of span - centre, fatigue flexural rigidity, maximal crack width, development of cracks and strain of concrete and steel bars have been investigated. the influence of fatigue cycle characteristic, ratio of reinforcement, kinds of aggregate and concrete compressive strength on the specimens ’ fatigue behavior has been also investigated

    對試件的靜載下開裂荷載、疲勞破壞特徵、疲勞壽命、疲勞荷載作用下的跨中撓度、截面疲勞抗彎剛度、裂縫開展情況及最大裂縫寬度、鋼筋及混凝土在循環荷載作用下應變等內容進行了研究，分析了疲勞循環特徵值、縱筋配筋率、骨料種類、混凝土抗壓強度等因素對試件疲勞性能的影響。
  2. With the prerequisite of meeting requirement of its working performance, the mix design of common grades can be concluded though strength test if we check various property of the said concrete with the certain mix design, such as compressive strength, tensile strength, elastic modulus, reinforcement wrapping strength, leakage resistance, shrink property and charring resistance, and compare them with property of ordinary concrete, we will find that the various dynamic property of self - densifying high performance concrete is very satisfactory and the durability is quite ideal

    在滿足自密實高性能混凝土工作性能的前提下，通過強度試驗得出常用強度等級混凝土的配合比，檢測該配合比下的自密實高性能混凝土的抗壓強度、劈裂抗拉強度、彈性模量、鋼筋握裹力性能、抗滲性、收縮性、抗炭化性等性能，以及各種性能與普通混凝土的比較，驗證自密實高性能混凝土硬化后的各方面力學性能是完全能夠符合要求的，並且具有較高的耐久性。
  3. In order to reveal load mechanism and failure mode of thick pile caps, by means of the test of 1 / 4 - scale models of thick pile caps with six piles and post - handling study of 3 - dimensional non - linear finite element adina, this paper points out the shortage, which is that the design of pile caps is carried out by flexural strength in chinese technical code for building pile foundations jgj94 - 94 and american reinforcement concrete building construction code aci318 - 02, promulgates that the failure mode of thick pile caps is punching failure and load transfer mechanism is the strut - and - tie, which is that zones of concrete with primarily unidirectional compressive stresses are modeled by compress struts, while tension ties are used to model longitudinal reinforcement over pile

    摘要為揭示厚承臺的傳力機理和破壞形式，通過對4個1 : 5比例的六樁厚承臺的模型試驗研究與三維非線性有限元adina的后處理研究，指出中國建築樁基技術規范jgj94 - 94與美國鋼筋砼房屋建築規范aci318 - 02規范中，承臺以彎曲強度進行配筋計算的設計方法之不足，揭示出厚承臺的破壞模式是沖切破壞，傳力機理是以帶有主要單向壓應力的砼區域作斜壓桿，樁頂區域的縱筋作拉桿的空間桁架。
  4. In this model the anisotropic constitutive models of concrete are introduced according to its different behaviors under compressive stress and tensile stress, and it is considered that a certain amount of rust product is carried away from the rust layer around the reinforcement and deposited within the open cracks after the cover cracked, which will reduce the expansive pressures

    由於混凝土拉壓性能的不同，應用各向異性本構關系，並考慮保護層開裂以後，鋼筋的銹蝕產物會有部分滲透到裂縫中，降低銹蝕產物對保護層的膨脹壓力，對鋼筋銹蝕膨脹應力進行了計算。
  5. In static test, t - shaped and l - shaped specimens were respectively divided into four groups according to concrete strength grades, sectional height to thickness ratio, reinforcement ratio and ratio of axial compressive force to axial compressive ultimate capacity of section. how these factors affect the load - carrying and deformation of short - leg shear wall is known by analysis the result

    在擬靜力試驗中對t形和l形短肢剪力墻分別進行了四組試驗，通過對試驗結果的分析，揭示了混凝土等級、截面配筋率、軸壓比和墻肢截面高厚比等因素對短肢剪力墻承載力和變形的影響。
  6. Problems are often occurred : cross - section of frame columns depends upon the limit of axial compressive ratio, the constructional reinforcement ratio becomes the ratio of longitudinal reinforcing steel bar of frame columns, such problems are not reasonable

    經常出現的情況是：框架柱的斷面由軸壓比限值確定，而框架柱的配筋由構造配筋率決定，這其中存在著不合理的地方。
  7. Parameters considered are : concrete compressive strength, percentage of flexural reinforcement, bonded length, thickness and stiffness of cfrp laminate and soon

    這些參數包括：混凝土強度、配筋率、粘結長度、 crfp厚度及剛度等，在設計過程中正確選擇參數可以避免加固梁發生脆性破壞。
分享友人
分享到 Line

分享到臉書