conductivity cell 中文意思是什麼

conductivity cell 解釋
傳導性電池
  • conductivity : n. 【物理學】傳導性[力]，傳導率；導電率[性，系數]。
  • cell : n 1 小室，單室；隔間，艙；〈詩〉茅舍；（單個的）蜂窩，蜂房。2 〈詩〉墓穴，墓。3 （大修道院附屬的...
  1. More recently, the perovskite manganite compounds, la1 - xsrxmno3 have been used as the cathode of the solid oxide fuel cell ( sofc ) because of their electro - ion conductivity properties. in manganite perovskites, substitution of divalent ions ( alkaline earth metals viz

    近幾年來， la _ （ 1 - x ） sr _ xmno _ 3這類鈣鈦礦型結構的氧化物材料因為其具有混合電子-離子導電特性而被廣泛的應用於固體氧化物燃料電池陰極材料。
  2. The membrane properties were found to be dependent upon the content of styrene. the membrane physic - chemical properties compare to nafion 117 except that their chemical stability has to be further improved to make them acceptable for practical use in the proton exchange membrane fuel cell. the proton transport through the membrane follows the " liquid - like " proton conductivity mechanism y and the water balance is important for the working condition of the fuel cell

    對磺化膜的研究分析表明：膜的性能參數如離子交換容量、吸水率、水合系數、形體穩定性、導電性能、化學與熱穩定性等依賴于膜中苯乙烯含量，且接枝苯乙烯相互間的位阻效應對膜性能影響很大；膜的性能可與nafion膜相比較；質子在膜中的傳導遵循「似液體」質子傳導機理；電滲析與擴散作用使膜保持水平衡。
  3. The effect of thermal conductivity of membrane on the distribution of temperature in the fuel cell is discussed, and the effect of inlet velocity and porosity of porous diffusion layers on the fuel cell performance are analyzed

    討論了質子膜的導熱率對電池內溫度分佈的影響。分析了進料速度和多孔擴散層孔隙率對電池性能的影響，結果表明較快的進料速度和較大的擴散層孔隙率都能有效提高電池的性能。
  4. After chromosome doubling and electric conductivity measuring, 9 variants with higher stability of cell membrane to heat stress than the original varieties were selected

    經過染色體加倍后，通過熱脅迫條件下電導率的測定，篩選出9份細胞膜熱穩定性比原始品種明顯提高的變異體材料。
  5. The research of the new and high conductivity material of lithium ionic conductor is always an interesting issue in the material field due to its low potential, light weight and providing high cell voltage and energy density

    由於鋰具有較負的電極電勢和較輕的重量，可以為電化學器件提供高的電池電壓和能量密度，所以鋰離子導體高電導率新材料的研究一直是材料研究領域倍受關注的課題之一。
  6. Abstract : this paper reports the observation and analysis results on three kinds of impurity in - al2o3 by using epma - eds. we studied the differences of electric conductivity between the area containing inmpurity and the normal area by ion transport method. the effects of impurity in - al2o3 on cycle life of the na - s cell were also discussed

    文摘:用epma - eds組合儀，對氧化鋁中的三種典型雜質進行了形貌觀察和成分分析，並用電子束誘導離子遷移法，研究了雜質區及正常區的離子電導差異，討論了不同雜質的特點及對氧化鋁作用中的危害。
  7. By using a cell equivalent method, the present model can deal with the face - center square structure of erf. combining the scheme of the classical conductivity model for the single - chain structure, a new formula for the prediction of the shear yield stress of erf is set up. the influences of the separation distance of the particles, the volume fraction of the particles and the applied electric field on the shear yield stress are investigated

    在電導模型的基礎上，建立在電流變液體在外加電場的作用下，粒子之間會形成某種特定的微觀結構，利用等效胞元的方法，將這微觀結構等效成一個平板，建立了等效的微觀結構平板模型，通過計算電流變液體內部的局部電場，對電流變液體的工作機理和剪切屈服應力進行了預測，並且分別考慮了在不同的粒子間距、不同的粒子濃度、不同的外加電場的情況下，對剪切屈服應力的影響。
  8. The properties of the membranes such as proton conductivity, water uptake, swelling degree and thermal stability were measured. results show that the sulfonated sbs membranes had good proton conductivity, at the same time, the water uptake and the swelling degree could meet the need of fuel cell

    通過對不同磺化度的質子交換膜的電性能、吸水率、溶脹率以及熱穩定性等性能進行了研究，表明磺化sbs膜具有了比較好的質子傳導能力，吸水率與溶脹率也能滿足燃料電池的工作需求。
  9. Tow types of fuel - cell models can be distinguished : microscopic and macroscopic. this paper adopt agglomerate microscopic model to analyze the fuel cell ' s performance. according to the computation, it can be concluded that the performances are determined by the thickness of the electrode, the effective ionic conductivity, the radius of agglomerate and other parameters

    對燃料電池單體，建立了微觀的數學模型? ?聚塊模型，用nenmanbandj方法計算熔融碳酸鹽燃料電池陽極和陰極的過電位，分析了各種參數的影響，對電極的制備，提高單電池的性能，有一定的指導意義。
  10. Mixed oxygen ion - electron conducting ( miec ) oxides have both the oxygen ion and electron conductivity at elevated temperatures, and have shown promising applications in oxygen separation, membrane reactors and solid oxide fuel cell

    摘要混合導體透氧膜材料在高溫下具有氧離子電子混合導電性能，在純氧制備、膜反應器以及固體燃料電池等方面展現出廣闊的應用前景。
  11. The intermediate - temperature sofc ( solid oxide fuel cell ) ’ s electrolyte with perovskite - type lsgm ( la _ ( 0. 9 ) sr _ ( 0. 1 ) ga _ ( 0. 8 ) mg _ ( 0. 2 ) o _ ( 3 - ) ) was synthesized using advanced pechini method and solidification method. the thermal and electrical properties of the sintered samples ( synthesized by two different methods ) were measured and compared by thermal expansion and ac impedance spectroscopy ; the phase transformation process and inner structure were measured and compared by xrd, dta - tg and ac impedance spectroscopy. the research results show that the electrolyte synthesized by advanced pechini method has several advantages, such as fine pre - powders, low sintering temperature, reduced or eliminated impurity phases and high conductivity etc. so, the apm is ideal method to synthesize lsgm

    採用改進的檸檬酸法（以檸檬酸和edta乙二氨四乙酸為復合絡和劑，檸檬酸為燃料）和固相法分別制備了具有鈣鈦礦結構的中溫固體氧化物燃料電池的電解質材料lsgm （ la _ （ 0 . 9 ） sr _ （ 0 . 1 ） ga _ （ 0 . 8 ） mg _ （ 0 . 2 ） o _ （ 3 - ） ） ，用差熱?熱重分析（ dta / tg ） 、 x光衍射分析（ xrd ） 、交流阻抗譜技術（ ac - impedancespectra ） 、比表面積分析（ bet ）和燒結收縮率曲線等手段對產物的熱分解過程、物相轉變和內部結構等進行了表徵，並對由這些粉體燒結而成的固體氧化物燃料電池的電解質材料的電導率進行了檢測。
分享友人
分享到 Line

分享到臉書