constructional reinforcement 中文意思是什麼
constructional reinforcement
解釋
構造鋼筋- constructional : 構造上的
- reinforcement : n. 1. 增強，加固；補強物，強化物；補給品。2. 增援，支援；〈pl. 〉增援部隊，援軍；救援艦。
-
In light of the simulative research results, three methods are applied to analyze some controversial problems in this kind of structural system ( such as the concrete pouring sequence of continuous ends, the applying sequence of pretensioned force, the removal of the temporary supports, the concrete pouring style of continuous ends, the optimization of constructional reinforcement and prestressed reinforcement ). some important conclusions are drawn : the concrete pouring sequence of continuous ends should be in accordance with the principle of " interval end " ; the removal of temporary supports is also on this principle ( opposite to traditional opinions ). at the same time, other problems such as the shrinkage and creep effects of concrete, the c racking and failure pattern, the optimization of reinforced bars and prestressed bars are also analyzed in detail
在此基礎上，對于目前先簡支后連續結構體系中存在的一些有爭議的問題（如后連續端部澆築和后連續預應力張拉的順序、體系轉換中的臨時支座拆除順序、后連續端部澆築方式、后連續端部的預應力筋及普通鋼筋的優化等） ，我們分別運用三種方法進行了細致的模擬分析、研究，並得出了一些具有重要工程意義的結論：后連續端部的澆築順序和后連續預應力張拉的「隔跨」原則，臨時支座拆除的「隔跨」原則（此前人們一直認為「對稱澆注和對稱張拉」是最為合理的施工工序） ，混凝土的收縮、徐變對先簡支后連續結構體系的影響一般較小等。 -
The constructional technics of post - inserted the steel reinforcement cage in bored pile and associated equipment
長螺旋鉆機成孔壓灌砼樁后插鋼筋籠施工工藝及配套裝置的應用 -
Problems are often occurred : cross - section of frame columns depends upon the limit of axial compressive ratio, the constructional reinforcement ratio becomes the ratio of longitudinal reinforcing steel bar of frame columns, such problems are not reasonable
經常出現的情況是：框架柱的斷面由軸壓比限值確定，而框架柱的配筋由構造配筋率決定，這其中存在著不合理的地方。 -
It is found by comparison that as the structural forms of special - shaped columns and short - shear walls are used, the structures should be arranged reasonably so as to meet the needs of lateral stiffness, and axial compression ratio should be controlled strictly so as to meet the needs of constructional reinforcement to prevent the probably curling and shear failure for the purpose of meeting the needs of the construction of small high - buildings
對比討論發現：採用鋼筋混凝土異形柱和短肢剪力墻的結構形式時，應當進行合理的結構布置以滿足結構整體抗側移剛度的要求，同時嚴格控制豎向構件軸壓比並滿足配筋構造以防止構件可能出現的翹曲和剪切破壞，這樣才能同時滿足小高層住宅對建築和結構的需要。
分享友人