control load 中文意思是什麼
control load
解釋
控制載荷-
The load character and control object for a parallel inverter is analyzed, the conclusion that series and parallel resonant circuit are two antithetic circuits is pointed out, this provides a theoretical guide to the control circuit design for these two inverters
分析了並聯諧振逆變器的負載特性及控制目標，指出串並聯諧振逆變電路是兩種對偶電路，為這兩種逆變器控制電路的設計提供了理論指導。 -
Also a refined - pulp quality predictive model, with specific energy, specific load as the model inputs, and beating degree, wet weight as the model outputs, is presented. simulation results show that the models can be acted as theoretical bases for the automatic control of high - consistence pulp refining process
即，建立了以原漿流量、白水流量、盤磨機功率為輸入變量，比能量、比負荷、濃縮機漿位為輸出變量的動態模型，以及基於比能量、比負荷的成漿質量預報模型。 -
Engine load simulated control system was consisted of two unattached parts of work resistance simulated control subsystem and electric bow wave dynamometer control subsystem. with the mathematic models of engine load simulation controller, which transferred the work resistance ' s change to engine load change immediately, the system can met the need of the simulation control system
發動機負荷模擬加載控制系統包括彼此獨立的作業阻力模擬控制子系統和電渦流測功機控制子系統兩部分，應用發動機負荷模擬控制器數學模型，使作業阻力的變化及時轉換為發動機負荷的變化，能夠滿足模擬系統的控制要求。 -
Probe into bulldozer ' s ultimate load control system
推土機極限載荷控制系統的探討 -
At supersonic speeds the control load acts mainly on the deflected surface itself, and hence has its centroid even farther to the rear.
超音速時操縱載荷主要作用在偏轉面本身上，因此它的作用中心甚至更加靠後。 -
Based on the past results, seismic behavior of r. c. frame structure with special - shaped column is studied, according to the members to the structure in sequence in this paper. the main contents are as follows aspects : first of all, aiming at the characteristics of special - shaped column, various control parameters including allowable value of drift angle, axial load ratio etc, are studied
本文在前人研究成果的基礎之上，就鋼筋混凝土異形柱框架結構的抗震性能，按照從構件到結構的順序展開研究，主要內容如下：第一，針對異形柱的特點，對影響結構抗震性能的主要參數，如層間位移角、軸壓比等進行研究。 -
Then following reality constituent of engine and connecting component interface, a nonlinear signal cylinder engine model has been created, though fire interval and fire order, a control - oriented four cylinders engine is build. following dynamometer is seen as load, performance of engine is simulated and researched under the condition of constant torque and speed, validation of the math and simulation model have been confirmed by comparison result between simulation with test result of engine performance simulation software dyno
按照發動機的實際組成，根據各部件的介面類型連接模型庫中的部件，建立了單缸發動機非線性模型，在此基礎上，依據發動機實際發火間隔和順序，建立了面向控制的四缸汽油機模型，並以測功器為負載，通過恆轉矩和恆轉速方式進行了發動機性能模擬和研究，模擬結果和發動機動力性能模擬軟體dyno測試結果的對比驗證了數學模型和模擬模型的正確性。 -
Multiple electric circuits may be employed to provide incremental control to meet load requirements.
為了適應負荷增加需要，可採用復接電路提供增量控制。 -
In the research, a set of simulation equipment is developed to examine the drivers " static and dynamic fatigue. recur to the apparatus, contrast and control experiment are made among different ages, workload intension and workload factors group. the endings summarize as following : ( 1 ) driving sensation fatigue investigation ( investigation of psychological and physiologic index and contrast investigation of fatigue ) ; continuous driving load and discrete driving load investigation of fatigue
? ?門）駕駛疲勞平衡穩定性是通過在力檢測臺上描繪人體重心軌跡的方法，提出檢測駕駛員疲勞平衡穩定指數，在不同狀態下（傾斜度15 30 『以及閉目等狀態下）對不同負荷、不同年齡分別進行測試，建立駕駛疲勞客觀測試評價體系； n ）經實驗室研究與現場調查，通過對駕駛疲勞與駕駛時間、駕駛速度等關系的研究，提出了不同年齡、不同條件下的最大連續安全駕駛時間標準，日駕駛時間標準，最大安全行車速度標準等。 -
When testing begins, the computer of the tested uav flight control system will be connected into the network as a slave. the master of the system will diagnose faults should there be any ; otherwise it will set flight parameters and load flight course data for the slave
檢測時，無人機的飛控系統計算機作為從機連入網路，如果從機的飛控系統沒有故障，主機將為從機設置飛行參數和裝定航線數據；如果有故障，則主機為從機飛控系統診斷故障。 -
One such scheme involves an improved control method designed to automatically quarantine trouble spots and gerrymander the remaining grid into islands of balanced load and generation
可行方案之一是改良控制方法，自動將出錯的部份隔離起來，並將剩餘的電力輸送網重新劃分成數個供需平衡的獨立區域。 -
In order to eliminate the influence of the output filter capacitor current on the grid current, a novel control strategy for the grid - connected inverter in grid - tied and off - grid modes is proposed. the control strategy can also realize seamless transfer between grid - tied and off - gird modes. the grid - connected inverter can supply power to the critical load when the grid is off
本文針對傳統並網控制策略進網電流受輸出濾波電容電流影響的問題，提出了一種新的並網控制策略，該控制策略能基本消除輸出濾波電容對進網電流的影響，實現獨立與並網兩模式之間的無縫切換，對關鍵負載起不間斷供電的作用。 -
Ssr - dd series of dc solid relay is vastly applied to output joggle of computer and external equipments, it is also applied to control or switch dc load : dc relay 、 contactor 、 dc electrical motor 、 kinds of electric - heating apparatus 、 dc electromagnetic valve 、 electromagnetic iron 、 solenoid 、 filament lamp 、 indication lamp 、 plc logical electrical appliance and dc solid relay
Dd系列直流固態繼電器廣泛應用於計算機與外部設備的輸出介面，適用與控制或開關直流負載：直流繼電，接觸器、直流電動機、各類電熱器具；直流電磁閥，電磁鐵、螺線管、白熾燈、指示燈； plc邏輯電器。 -
Presents the steady - state programming with constant coolant average temperature and constant live steam pressure, an ideal programming for marine nuclear power plant ( npp ), under which, both the coolant average temperature and the live steam pressure of nuclear steam supply system ( nsss ) are constant when the steady state operating condition is varied, and points out that in comparison with the steadysate programming with constant coolant average temperature, the ideal programming can improve the overall operating performance of npp effectively, especially in low - load range, for instance, raise the heat efficiency of npp, decrease the operating noise of main coolant pump, and improve the conditions of design, operation and control of the secondary loop system
雙恆定運行方案是船用壓水堆核動力裝置的理想運行方案.在這種運行方案下，當裝置穩態功率變化時，冷卻劑平均溫度與蒸汽壓都保持不變，與通常採用的冷卻劑平均溫度恆定運行方案相比，有效地改善了核動力裝置的總體運行性能，特別是在低負荷運行時，可以提高裝置經濟性、降低主泵運行噪聲、改善二迴路系統的設計、運行和控制條件，這對于提高船用核動力裝置的運行可靠性和安全性具有實際意義 -
Turbine rotor raising character while load shedding is resulted in governor system and over - speed protection control system together
機組甩負荷后轉子的飛升特性是由調節系統和opc共同作用的結果。 -
Products examination with traditional method exist the following questions : long measure cycle, heavy work load, low efficiency. in order to make the agricultural products processing machines can reach the performance and requirement that the country stipulates before producing in enormous quantities and putting on market, this article adopts data acquisition technology and plc control technology to research and design the performance examination system about agricultural products processing machines in foundation the require live and systematic technical indicator
針對目前我國農產品加工設備品種繁多、規格復雜，產品鑒定採用傳統方法檢測周期長、工作量大、效率低的現狀，為了使農產品加工機械在大批量生產和投放市場之前達到國家規定的性能指標和要求，本文根據現場要求和系統技術指標，採用數據採集技術和plc控制技術研究和設計了農產品加工機械性能檢測系統。 -
A study on the characteristics of training load control of elite athletes of long and middle distance running
世界優秀中長跑運動員訓練負荷控制特徵的研究 -
Laminates of textile glass - reinforced unsaturated polyester and phenacrylic resins for load - bearing structural members gf - up, gf - pha ; tests and quality control
承載構件用玻璃纖維增強非飽和聚脂樹酯和苯甲酰甲基 -
Then a vsc controller using on - off valve and two potentiometers are designed for cushioning control system. it can realize the balanced, no shock, no reversing cushioning. experiments under different air pressure, load mass are carried out, and the results prove that the vsc controller can be used in pneumatic cushioning
第五章首先介紹了變結構控制的原理和應用發展情況，然後針對本實驗系統設計了一個使用開關閥和端位位移傳感器的變結構控制方案，實現緩沖過程的平穩無沖擊和無回彈要求，並在不同氣源壓力、不同負載質量下分析了控制性能的變化，實驗結果證明緩沖控制採用變結構控制是可行的，並具有很強的魯棒性。 -
The load case reckoned in horizontal earthquake action was design control load case
（ 3 ）從構造措施一上著，各類構件均有不滿足的情況。
分享友人