coupling rigid 中文意思是什麼

coupling rigid 解釋
剛性聯軸節
  • coupling : n. 聯結;交尾;【機械工程】管箍;聯結器;軸接;(火車的)車鉤,【電學】耦合。
  • rigid : adj 1 堅硬的,強直的,硬性的,僵硬的 (opp flexible elastic)。2 堅定的,固定不動的。3 嚴格的,嚴...
  1. Across the rigid - flexible coupling dynamic analysis, we acquired the coupled effects between the three - dimensional attitude motion of the satellite and the flexible vibration of the antenna ' s supporting beam, and got the dynamic behaviors of the system. and we found the change pattern of the antenna ' s structure parameters, which decide the system ' s connatural characteristic and its dynamic response

    通過對衛星?天線形成的剛柔耦合系統進行動力學分析,獲得了衛星的剛體運動與天線的彈性振動之間的耦合影響規律及其真實的動力學行為,得到了天線結構參數對衛星?天線系統的固有特性及其動力學響應的影響規律,為衛星姿態控制和天線結構優化設計奠定了基礎。
  2. A study on vehicle handling and stability based on rigid - flexible coupling multi - body model

    剛柔耦合多體車輛操縱穩定性研究
  3. Rigid - flexible coupling system ; rotating flexible beam ; active vibration control ; positive position feedback ; piezoelectric ceramic

    剛柔耦合系統旋轉柔性梁振動主動控制位置正反饋壓電陶瓷
  4. Study on dynamic modeling theory of rigid - flexible coupling systems

    多柔體系統動力學建模理論及其應用
  5. Experiment validation on modeling theory for rigid - flexible coupling systems

    剛柔耦合建模理論的實驗驗證
  6. From above analysis, the thesis gets conclusions as following : ( 1 ) the frequencies of multi - tower building are so dense and the coupling in each mode is so evident that the cqc method instead of srss should be used to calculate the seismic action effect ; ( 2 ) torsion effects is distinct between the modes of asymmetry multi - tower structure and it is necessary to take translation - torsion coupling into account ; ( 3 ) the effect of the enlarged base rigid on the seismic properties is very big, the rigid ratio of the enlarged base to towers in asymmetry multi - tower structure should be designed in a proper range ; ( 4 ) the distribution of plane rigid is asymmetry because of the asymmetry layout of towers. the torsion effects of structure not only result in large torsion internal force in vertical element resisting lateral displacement, but also make large influences on the stress of transfer plate and near floors, thus it is necessary to strengthen those floors

    通過上述分析,得出以下主要結論:多塔樓結構存在頻率密集現象,各振型間耦聯效應明顯,地震作用計算應採用cqc組合原則而不能簡單地採用srss組合原則;非對稱多塔結構的振型中,扭轉作用明顯,平扭耦聯效應值得考慮;裙樓剛度對整體結構的抗震性能影響很大,非對稱多塔結構宜控制裙樓與塔樓剛度比在適宜的范圍;非對稱多塔易導致平面剛度分佈不均勻,結構扭轉效應不僅在豎向抗側構件中引起較大的扭轉內力,對轉換層樓板應力有較大的影響,且延續至相鄰樓層,對相應樓層均應採取相應的加強措施。
  7. Gram - schmidt method for zernike polynomials fit and singular value decomposition ( svd ) are concerned. the direction question for zernike polynomials fit is discussed and the surface error in the normal direction is deduced. to solve - the coupling and mixture of zernike polynomials fit method, rigid - body displacement is removed with coordinate transformation and then fitted with zernike polynomials

    介紹了zernike擬合的gram - schmidt以及奇異值分解兩種方法;論述了zernike擬合時的方向問題,計算了法線方向的面形誤差;針對zernike擬合時的藕合與混淆,採用先用齊次坐標變換去除剛體位移,再用奇異值分解進行zernike擬合。
  8. Compared with the rigid - flexible coupling dynamic models that had been constructed in other published papers, comprehension about the equation of rotating flexible beam based on the method of small element is presented, and some fuzzy understanding are clarified. numerical simulations on the vibration control of rotating flexible beam with positive position feedback are carried out. more over, using piezoelectric ceramic as sensors and actuators, several experiments are performed, their results are shown and discussed

    在綜合比較已有文獻所建立的剛體-柔性附件耦合系統動力學模型的基礎上,以微元法為根據提出對旋轉柔性梁運動方程中各項的理解,澄清了某些文獻中模糊的認識。利用位置正反饋控制律,對旋轉耦合系統中柔性梁的振動控制進行了數值模擬。
  9. When the radian of rigid line reaches extensive magnitude, the presence of interfacial rigid line inclusion can change not only attraction force on dislocation arisen by soft inhomogeneity into repulsion force, but also the interaction effects between screw dislocation and soft matrix. soft inhomogeneity can repel screw dislocation in piezoelectric material due to their intrinsic electromechanical coupling behavior

    當界面裂紋達到一定弧度時,可以將硬夾雜對位錯的排斥作用改變為吸引;當剛性線夾雜達到一定弧度時,不但可以將軟夾雜對位錯的吸引改變為排斥,也可以改變軟基體對位錯的作用性質。
  10. Virtual prototyping for rigid - flexible - coupling crawler crane

    柔耦合的履帶起重機虛擬樣機建模技術
  11. At present, the research on dynamics of solid - fluid interaction is generally based on the assumption that the containers are rigid which cannot meet the truth. meanwhile, there is only little research on the dynamic behaviors of the coupling system under different external excitations

    目前,國內外關于貯箱類流固耦合動力學研究一般都建立在充液貯箱為剛性這一假設的基礎上,這與實際情況尚有偏頗;同時,對系統在不同外激勵作用下的動力學行為的研究還相當少。
  12. Setup of experimental system and experiment research first, coupling characteristic between flexible appendages and central rigid body is theoretically analyzed. based on simplifying the object studied, its theoretical model is derived by applying lagrange equation, and the coupling characteristic is analyzed. the control modals of flexible appendages are determined through calculating rolling couple coefficient and simulation of real coupling structure

    將研究對象簡化為帶有對稱柔性梁的剛性體,分析了柔性附件與中心剛體的運動耦合模式,並對影響中心剛體姿態角的反對稱耦合模式建立了動力學方程,通過對實際結構轉動耦合系數的計算和模擬分析,確定了柔性附件振動控制的重點模態。
  13. Moreover, low vibration modals is derived with finite element method. then, control strategy of central rigid base - - - foldable flexible appendages coupling structures is studied

    用有限元計算了研究對象的低階模態,為振動主動控制中傳感器和執行器的優化配置提供參考。
  14. Fourthly, the linear programming technique is combined with efg - fe coupling method to solve the elasto - plastic contact problems. a cylinder in contact with a rigid plane is implemented to show how to choose some of the parameters of efg - fe coupling method in solving the contact problems. an elasto - plastic contact of rough surfaces is also carried out

    通過編程對光滑表面圓柱體與剛性平面的彈塑性接觸問題以及粗糙表面與剛性平面的彈塑性接觸進行求解,在對無網格區域相關參數研究的基礎上,指出了用無網格伽遼金-有限元方法求解接觸問題時的合理參數范圍。
  15. Taking 2050 mill hot strip continuous rolling process as an object, a coupling thermal, mechanical and microstructural simulation model on hot continuous rolling was built by using nonlinear rigid - plastic finite element method ( fem )

    結合某廠2050熱帶鋼連軋工藝過程,利用非線性剛塑性有限元法,建立熱連軋過程熱、力、組織的多參量耦合模擬模型。
  16. Based on optimal control theory and equivalent optimal control theory, the optimal control method of elastic floating raft under shock and stochastic load is studied and the optimal control method and optimal parameter design method of the nonautonomous rigid - elastic coupling floating raft system are established

    摘要在理想最優控制理論和準最優控制理論的基礎上,對沖擊和隨機荷載聯合作用下,彈性浮筏系統的最優控制方法進行研究,建立了剛彈耦合非自治浮筏系統的最優控制方法和最優參數設計方法。
  17. Analysis of coupling characteristic between central rigid body and its flexible appendages 3. study on control architecture of the coupled structure 4. similar human intelligent control of the central rigid body 5

    按照這個研究思路,本文開展了以下幾方面的研究工作:首先,對柔性結構與中心剛體間的耦合特性進行了理論分析。
分享友人