cracking test 中文意思是什麼

cracking test 解釋
龜裂試驗
  • cracking : adj 分裂的，分解的；〈美俚〉極快的，猛烈的。 cracking distillation 【化學】裂解蒸餾（法）。 crack...
  • test : n 1 檢驗，檢查；考查；測驗；考試；考驗。2 檢驗用品；試金石；【化學】試藥；（判斷的）標準。3 【化...
  1. Standard test method for evaluating stress - corrosion cracking of stainless alloys with different nickel content in boiling acidified sodium chloride solution

    沸騰酸化氯化鈉溶液中不同鎳合量不銹鋼合金應力腐蝕裂紋評定的標準試驗方法
  2. Abstract : based on the analysis of the main failures discovered in pavement on steel deck plate and the demanding service condition of the pavement on steel deck, high - temperature rutting test, low - temperature bending test and controlled stress flexural fatigue test are used to study the performance of asphalt mixtures modified by epoxy resin including high - temperature stability, low - temperature cracking - resistance, and fatigue cracking - resistance, which are served to evaluate the modification effect of epoxy resin of different contents. with the addition of epoxy resin, all the three performances are improved greatly. however, when the amount of epoxy resin added is over a certain value, the modification effect will be stable with no extra benefit detected. finally, in terms of the properties of the three respects, 20 ?, 30 ?, 30 ? are given separately as the proposal adding contents

    文摘:在分析鋼橋面鋪裝層主要病害和特殊工作環境的前提下，分別採用高溫車轍試驗、低溫小梁彎曲試驗和控制應力小梁彎拉疲勞試驗，研究了不同環氧樹脂摻量下的環氧樹脂改性瀝青混合料的高溫穩定性、低溫抗裂性和抗疲勞性能.試驗結果表明:環氧樹脂對這3個方面都有很大的改進效果，但改性效果和樹脂的添加量並不是一個無限遞增的關系，當添加量超過一定數值以後，改性的效果將趨于平穩.最後就高溫、低溫、疲勞3個方面分別提出環氧樹脂添加量為20 ? ， 30 ? ， 30 ?的建議值
  3. Based on the analysis of the main failures discovered in pavement on steel deck plate and the demanding service condition of the pavement on steel deck, high - temperature rutting test, low - temperature bending test and controlled stress flexural fatigue test are used to study the performance of asphalt mixtures modified by epoxy resin including high - temperature stability, low - temperature cracking - resistance, and fatigue cracking - resistance, which are served to evaluate the modification effect of epoxy resin of different contents. with the addition of epoxy resin, all the three performances are improved greatly. however, when the amount of epoxy resin added is over a certain value, the modification effect will be stable with no extra benefit detected. finally, in terms of the properties of the three respects, 20 ?, 30 ?, 30 ? are given separately as the proposal adding contents

    在分析鋼橋面鋪裝層主要病害和特殊工作環境的前提下，分別採用高溫車轍試驗、低溫小梁彎曲試驗和控制應力小梁彎拉疲勞試驗，研究了不同環氧樹脂摻量下的環氧樹脂改性瀝青混合料的高溫穩定性、低溫抗裂性和抗疲勞性能.試驗結果表明:環氧樹脂對這3個方面都有很大的改進效果，但改性效果和樹脂的添加量並不是一個無限遞增的關系，當添加量超過一定數值以後，改性的效果將趨于平穩.最後就高溫、低溫、疲勞3個方面分別提出環氧樹脂添加量為20 ? ， 30 ? ， 30 ?的建議值
  4. Analyzed the reason of stress corrosion cracking on u shape brass tube bundle when it is having penetrative test with ammonia, improved technology of test and gave out the method should be paid attention to during the process of brass tube exchanger

    摘要對黃銅管換熱器管束在氨滲試驗過程中發生應力腐蝕，導致銅管破裂的原因進行了分析，改進了施工方案，並提出了黃銅管換熱器製造過程中對管束進行耐壓試驗時的注意事項。
  5. Standard test method for outdoor evaluation of tire sidewall component cracking resistance

    輪胎側壁組件抗斷裂性能的室外評定標準試驗方法
  6. Bead weld cracking test

    焊縫開裂試驗
  7. Tga. insulating and sheathing materials of electric and optical cables - common test methods - part 4 - 1 : methods specific to polyethylene and polypropylene compounds - resistance to environmental stress cracking - measurement of the melt flow index - carbon black and or mineral filler content measurement in polyethylene by direct combustion - measurement of carbon black content by termogravimetric analysis - assessment of carbon black dispersion in polyethylene using a microscope

    電纜和光纜的絕緣和護套材料.通用試驗方法.第4 - 1部分:聚乙烯和聚丙烯化合物專用方法.抗環境應力致裂.熔化流動指數測量.通過直接燃燒測量聚乙烯中炭黑和或礦物填料含量.通過熱重分析法
  8. Extensive experiment on tar cracking was performed on bench - scale tar catalytic cracking test system in itpe. cold trapping was used for tar sampling and gravimetric analysis of tar samples was performed to achieve tar content in flue gas

    在分析該領域研究現狀的基礎上，建立了實驗室規模生物質氣化焦油催化裂解實驗系統，採用冷態捕集方法進行焦油取樣，採用重度分析方法對焦油樣品進行分析以確定煤氣中焦油含量。
  9. Method of t - joint weld cracking test

    T型接頭焊縫裂紋試驗方法
  10. Weldability testing - method of cracking test for welded tee joint

    型接頭焊接裂紋試驗方法
  11. Stress corrosion cracking test for stainless steels

    不銹鋼的應力腐蝕斷裂試驗
  12. Weldability testing - method of y - groove cracking test

    型坡口焊接裂紋試驗方法
  13. Method of controlled thermal severity weld cracking test

    受控的熱嚴酷焊接裂紋試驗方法
  14. Method of h - type restrained weld cracking test

    H形限制焊接裂紋試驗方法
  15. Weldability testing - method of fisco cracking test

    焊接裂紋試驗方法
  16. Method of u - groove weld cracking test

    U形坡口焊接裂紋試驗方法
  17. Method of y - groove weld cracking test

    Y型坡口焊接裂紋試驗方法
  18. Testing of copper alloys ; stress corrosion cracking test using ammonia ; testing of components

    銅合金的檢驗.用氨作應力腐蝕裂紋試驗.成分的檢驗
  19. Testing of copper alloys ; stress corrosion cracking test in ammonia, testing of tubes, rods and profiles

    銅合金的檢驗.管材棒材和型材氨中應力腐蝕裂紋試驗
  20. Environmental stress cracking test

    環境應力龜裂試驗
分享友人
分享到 Line

分享到臉書