crystalline content 中文意思是什麼
crystalline content
解釋
晶體含量- crystalline : adj. 水晶的，由水晶做成的；結晶的，【化、礦】結晶質的；透明的。n. 結晶質，結晶體，晶態；（眼球）水晶體。
- content : n 1 容積，容量，含量，【數學】容度；收容量。2 【哲學】內容 （opp form）；要旨，真意。3 〈pl 〉內...
-
Environmental scanning electron microscopy ( esem ) observation of f2 mycelium cultured in liquid medium with 100mg / l of cadmium showed that there were crystalline precipitations attached to the surface of f2. transmission electron microscopy ( tem ) and energy - dispersive analysis microscope ( edam ) examination revealed that there were many granules with high content of cadmium around the cell wall
F2在100mg l鎘濃度下培養后，經環境掃描電鏡（ esem ）觀察顯示，菌體表面有較大晶體狀沉澱物；透射電鏡（ tem ）和能譜分析（ edam ）表明，細胞壁周圍形成大量細小的高鎘含量沉澱物。 -
This paper emphasizes the effect of the dissolution of aluminosilicate during diagenesis may provide more radiogenic strontium which would result in a high content of strontium in carbonate rocks. so we should avoid the vein of carbonate and select the samples with less terrigenous clastic, less grain content and lacking calcite cementation collected as analysis samples. the microcrystalline limestone and micro - to fine - crystalline dolomite are rather fairly whole rock samples
作者還強調了成巖過程中由長石等鋁硅酸鹽溶解提供殼源sr所造成的碳酸鹽礦物成巖蝕變可能表現為較高的sr含量；因此，在用全巖樣品進行旨在反映海水組成的各種分析時，應迴避碳酸鹽脈，選擇含陸源碎屑低、顆粒數量少、缺乏方解石膠結物的樣品，微晶灰巖或微?粉晶白雲巖是較為理想的全巖樣品。 -
Test methods of crystalline layered sodium disilicate - potassium fluosilicate volumetric methods for determination of silica dioxide content
層狀結晶二硅酸鈉試驗方法氟硅酸鉀容量法測定二氧化硅含量 -
By contrasting the dimension and appearance of fe of different precursors, verified it is true that the dimension and appearance of precursor affect these facets of fe. modern measures, for instance xrd, tem, sem, laser and infrared technique etc. are used to research the technique indexes of sfp of fe, such as crystalline, dimensions and its distribution, shape and appearance, assemble status and its oxygen content
對所制備的超微fe粉，採用x射線衍射法（ xrd ） 、透射電鏡法（ tem ） 、掃描電鏡法（ sem ） 、激光衍射粒度分佈測定法以及紅外測氧法等現代分析測試手段，詳細考察了超微fe粉的晶態、尺寸、粒度分佈、形貌與團聚狀態、氧含量等多項技術指標。 -
With plating time going on, the nano - polycrystal gathering grows in two dimensions, and the new nano - polycrystal layer appears simultaneously on the formerly formed nano - polycrystal surface. because the boundary and defect densities in quenched and tempered 45 steel is higher than those in annealed steel, the nano - polycrystal gatherings formed at its surface at the beginning of electro - deposition are more concentrated, and then their size is smaller. the microstructure of the ni - p alloy coating has closed relation with its phosphorus content with the increase of phosphorus content, the microstructure of coating turns from nano - crystalline to the amorphous
隨著施鍍時間的延長，納米晶聚晶體在橫向二維生長的同時，在納米晶聚晶體的表面上也進行著三維方向的新的一層聚晶體的生長；在調質態45鋼表面，由於其具有比較高的晶界和缺陷密度，因此在沉積初期，納米晶聚晶體的成核密度也較大，從而在二維方向聚晶體的尺度較小，鍍層沉積初期表現為緻密細小的鱗片狀組織。 -
The seemingly mcnt content in pt can be controlled by repeating the coatings of the film and increasing the mcnt doped concentration of the sol. the heterogeneous nucleation at the interface between mcnt and pt was induced by the doption of mcnt. the films which were calcined at 500 ? had formed perovskite and large crystal content, means that perovskite formed at the lower temperature, in conclusion, the crystalline ability of pt was improved by the doption of tb and mcnt
納米碳管的引入，使得體系在納米碳管和pt之間的界面產生非均態核化，隨pt薄膜成核勢壘的降低，摻納米碳管的pt薄膜在較低溫度下即可形成鈣鈦礦相，在500的較低溫度，就可獲得結晶完整且己具有很大結晶量的薄膜。 -
Prepared technical parameters were optimized by l9 ( 34 ) experiment analysis. a unique method for cleaning and drying of substrate - cleaning used by scour, drying used by infrared light was fished out by large numbers of experiment. chemical mechnism of zno thin film prepared by sol - gel technique was discussed by dta for the first time. by the measurements of sem, xrd and uvs, the thin film was analysed. the result proved that the thin film with strongly preferred orientation of c - axis perpendicular to the substrate surface which surface was homogenous, dense and crackfree was the crystalline phase of hexagonal wurtzite. the thin film was composed of plentiful asteroidal crystal which crystal dimension approximately 10 30nm. the average transmittance of thin film in visible region was above 90 %. the results of measurements else also proved that the thickness of single dip - coating was 75 240nm, this films resistivity was found to be 3. 105 102 3. 96 105 ? cm. the thickness and resistivity of thin film influenced by dope - content, withdrawal speed, pre - heat - treatment, anealing were reseached respectively
利用xrd 、 sem以及uvs光譜儀等分析方法對薄膜進行了研究，結果顯示，所制備的薄膜為六方纖鋅礦型結構，具有高c軸擇優取向性；表面均勻、緻密，薄膜材料由許多星狀晶粒組成，晶粒尺寸大約為10 - 30nm左右；薄膜可見光透過率平均可達90 % ；對薄膜厚度以及電學性能進行了測定后發現：單次鍍膜厚度約為75 - 240nm ， al ~ （ 3 + ）離子摻雜型氧化鋅薄膜的電阻率在3 . 015 102 - 3 . 96 103 ? cm范圍內；分別研究了摻雜濃度、提拉速度、預燒溫度、退火溫度等工藝參數對薄膜厚度和電阻率的影響。 -
The results show that nano - particles affect the solution viscosity and crystalline properties of uhmwpe. owing to the strong interaction between nano - particles and pe molecules, the viscosity and e _ ( ) of uhmwpe solution increase with the increasing of nano - particles content
實驗表明，納米粒子的加入對溶液粘度和uhmwpe的結晶性能均有影響，由於納米粒子和pe大分子及溶劑間有強烈的相互作用，使溶液粘度及粘流活化能均隨納米粒子的加入量的增加而增加。 -
The a phase can change to b phase by stretching. in the range of low temperature the higher content of b crystalline was achieved during the higher drawing ratio and the higher drawing temperature
拉伸有利於pvdf纖維的相結晶向相結晶轉變，且拉伸倍數越高相含量越高；較低溫度區域內（ 100 ） ，溫度提高有利於相結晶向相轉變，較高溫度區域內（ 100 ） ，溫度提高對相向相轉變作用不大。 -
Test methods of crystalline layered sodium disilicate - potassium fluosilicate volumetric methods for determination of sodium oxide content
層狀結晶二硅酸鈉試驗方法容量法測定氧化鈉含量 -
Test methods of crystalline layered sodium disilicate - edta volumetric methods for determination of magnesium exchange capacity content
層狀結晶二硅酸鈉試驗方法edta容量法測定鎂交換能力 -
Test methods of crystalline layered sodium disilicate - phenanthroline photometric methods for determination of iron oxide content
層狀結晶二硅酸鈉試驗方法鄰菲羅啉比色法測定三氧化二鐵含量 -
Test methods of crystalline layered sodium disilicate - atomic absorption spectrophotometric methods for determination of calcium oxide content
層狀結晶二硅酸鈉試驗方法原子吸收分光光度法測定氧化鈣含量 -
It was found that the introduction of ca2 + enhanced the sinterability of the material. the relative density of sintered specimens increase with the content of ca2 + in the composition range of 0 < x < 0. 3. it was confirmed that a high relative density can be obtained at relatively low sintering temperatures by using uniform, high surface area la1 - xcaxcro3 powders, which modifies the crystalline structure and microstructure of ceramic specimens
研究結果表明， a位ca ~ （ 2 + ）的引入在一定程度上能夠降低材料的燒結緻密化溫度：細小、均勻、高比表面積的粉料能夠有效降低材料的燒結緻密化溫度；燒結溫度的降低可以減少la _ （ 1 - x ） ca _ xcro _ 3中液相含量和鉻氧化物的揮發，有利於材料晶體結構、顯微結構的改善。 -
The properties of crystalline carbon nitride films ( cn ) on silicon substrate have been explored experimentally by the pe - pld and pe - cvd method. the relation between different deposition parameter and the structure properties of cn compound films is analyzed ; the deposition mechanism of the cn films is studied. cn thin films with up to 21at % nitrogen content have been prepared by pld method
本論文採用pe - pld技術和pe - cvd技術，以si基片為襯底對晶態cn薄膜制備進行了實驗探索，主要探討不同工藝條件和cn化合物薄膜的結構特性之間的關系，研究晶態si基cn薄膜的生長機理。 -
Abstract : the influence of re - addition way and sintering temperature on such physical and chemical characteristics as the ability of enameling glaze has been investigated in this paper. and the research has shown that the structure of glaze will be transformed from amorphous state into crystalline state and the grains will be refined while the sintering temperature and re content are increased
文摘:本文研究了在瓷釉中加入稀土的方式、燒結溫度對瓷釉的塗搪性等物理性能以及化學性能的影響，並發現，隨著燒結溫度和稀土含量的增加，瓷層結構由非晶態向晶態轉變，晶粒細化。 -
Where coupler kh570 plays interconnecting role between nanoparticles and polymer. ( 2 ) dsc and xrd tests also reveal that : untreated nanoparticles and alkylated nanoparticles have no significant effect on the crystallization behavior of pp matrix, whereas composited naonparticles induce the formation p - form crystalline of pp, moreover, the content of p - form crystalline amounts to 69. 3 %
（ 2 ） dsc和xrd測試同時顯示：未經處理的納米粒子與烷基化納米粒子與pp復合后對pp基體的結晶行為影響不大；而復合納米粒子與pp基體復合后誘發了- pp晶的形成，而且- pp晶的含量竟高達69 . 3 。 -
The resulting polymers were characterized by " h - nmr, ir, dsc, pom, gel permention chromatography ( gpc ). the relations between structures and properties were studied systemtically. the influences of the lateral rod content on the polymers " solubility and the stability of liquid crystalline states and chemical structures were discussed in detail
經過凝膠色譜（ gpc ） 、偏光顯微鏡（ pom ） 、差示掃描量熱（ dsc ） 、 ~ 1h - nmr和ir對聚合物的化學結構和液晶性進行了表徵，系統研究了聚合物結構和性質之間的關系。 -
With the addition of nucleating agent, the crystallinity increased, resulted in higher rigidity and lower impact strength than those of pure pp ; while with the addition of - nucleating agent, the relative content of crystalline form of special sheaf - like structure increased and resulted in increase of impact strength and the toughness
成核劑的加入使聚丙烯結晶度增大，從而使剛性增加，但抗沖擊強度有所下降；成核劑的加入使聚丙烯中晶含量大幅度地提高，從而使聚丙烯抗沖擊強度提高，即韌性增加。
分享友人