crystallization heat 中文意思是什麼

crystallization heat 解釋
結晶熱
  • crystallization : n. 晶化，結晶（作用，過程）；結晶體；具體化，明朗化。
  • heat : n 1 熱；熱力；熱度；熱量。2 體溫；發燒。3 （氣候的）高溫，暑氣。4 【冶金】熔煉的爐次；裝爐量；一...
  1. The meltable liquid touches with the rotary drum of cooling that form material film in rotary drum appearance. the heat exchange between material film and drum wall makes material film cooling and crystallization. the crystal material film is cut by scraper which forms piece product

    轉鼓結片是一個冷卻結晶過程，料盤中熔融料液與冷卻的轉鼓接觸，在轉鼓表面形成料膜，通過料膜與鼓壁間的換熱，使料膜冷卻結晶，結晶的料膜被刮刀刮下，成為片狀產品。
  2. Effects of heat - treatment on the crystallization and thermal expansion coefficient of li2o - al2o3 - sio2 system glass

    2系統玻璃析晶及熱膨脹系數的影響
  3. Combining the unstable heat conduction in crystal layer with heat transfer of undeveloped slug flow in a vertical tube, a time - progression model of crystal layer growth in the bubble column crystallizer pipe is proposed, the calculation results from the numerical method agree well with the experimental data. under certain operating conditions, the periodical arrival of gas plugs can cause crystallization and partial re - melting occur in the crystal - melt interface

    結合未充分發展彈狀流的傳遞特徵和晶層內不穩定導熱，提出了鼓泡塔結晶器管內晶層生長的時間級聯模型，與實驗值吻合良好.特定操作條件下，隨彈狀泡的到來和離去，結晶界面可發生結晶-部分重熔
  4. The surface of ce02 - ti02 films were very smooth and difficulty to crystallization. the ceo2 - tio2 complex films were nanocrystalline microstructure or microcrystalline even if to heat the substrates or to anneal the films. the ceo2 and tio2 nanocrystalline were not easy congregate and bigger because of heterogeneity interface disturb and have many defect

    組成ceo _ 2 - tio _ 2混合薄膜顆粒粒徑在納米尺度范圍3 ? 50nm ，與純ceo _ 2 、 tio _ 2薄膜相比，具有更小的表面粗糙度和更難結晶，這是由於異質材料晶界的相互干擾，使同質顆粒之間難于聚集而結晶長大，薄膜處于納米晶或雛晶態，即使加熱基片或薄膜進行熱處理也無明顯變化。
  5. The heat treatment process and effects of the nucleation agent on the nucleation and crystallization were explored

    探討了微晶玻璃的熱處理工藝制度及晶核劑對核化、晶化的影響。
  6. Polynitropolyphenylene ( pnp ), as binder, has high heat - resistance, with three nitryl groups at 1 -, 3 -, 5 - position in a phenyl ring. pnp, distinguished by property of low crystallization, which can be compatible with plasticizer, has a formation heat of 164. 3j / g and high oxygen content

    它不容易結晶，易於成膜，能與多種增塑劑相容； pnp的生成熱為164 . 3j g ，具有較高的氧含量， pnp能很好的解決火炸藥能量和安全性能之間的矛盾。
  7. Two coating approaches were adopted, one was to do next coating after 550 ? heat - treatment ( called a coating technique ) ; the other was to do next coating after 100 ? drying, the films coated by several times were heated at 550 ? ( calied b coating technique ). xrd, sem, tem and afm were used to characterize the crystallization behavior, orientation and surface morphology of the zno thin films

    運用xrd 、 sem 、 tem以及afm等對所得的樣品進行了分析和研究，結果表明：採用不同的旋塗工藝得到不同的薄膜厚度，而採用每次塗膜形成氧化物膜后再進下一次塗膜的方式能更好的保持zno薄膜的c軸擇優取向生長。
  8. 3. for encapsulated pcms with less than 10 m in their average diameter, their temperature and heat of phase transition seldom change as their average diameter decreasing ; however, their crystallization peaks vary dramatically and the super - cooling becomes worse

    3 、對于平均粒徑小於10 m的相變材料膠囊，膠囊的相變溫度以及相變熱基本不隨粒徑變化，而結晶峰變化較大，其過冷現象隨著粒徑的減小而加劇。
  9. In this work, zno thin films were prepared by sol - gel method on the glass substrate in order to study the influence of the preparation techniques on the crystallization, orientation and morphology of the films. we adopted a two - step heat treatment technique to optimize the micrcjstructure of the films, and subsequently discussed the forming process of the zno thin films

    本論文研究了在載波片和si （ 001 ）上溶膠凝膠旋塗法的制備工藝對薄膜的結晶、取向狀況以及薄膜形貌的影響，探討了溶膠凝膠旋塗法制備的氧化鋅薄膜的形成過程，同時引入兩步熱處理方法來優化薄膜的結構。
  10. The result shows that the content and the thickness of the microcapsule wall can be obtained by using the melting heat or the crystallization heat analysis in case that the wall materials is no heat effect in the temperature range of phase change of the core materials

    實驗表明：對于在芯材發生相變的溫度區間內壁材沒有熱效應的微膠囊，用熔融熱和結晶熱能夠計算出微膠囊的壁材含量和厚度。
  11. An ammonia separator is added, and the byproduct low - pressure steam from the shift section is used to heat and decompose the ammonium salt and ammonia is stripped, resulting in the effective elimination of crystallization of the ammonium salt

    增設氨分離裝置，利用變換工序副產的低壓蒸汽加熱分解銨鹽並汽提氨，可以有效解決銨鹽結晶問題。
  12. And generally speaking, the grain sizes were all less than 100nm. the average grain sizes of nd2fe14b and - fe reached a minimum of sizes after crystallization treatment ( temperature of crystallization : 650 ; heat preservation time : 5 hours )

    對球磨5小時的合金粉末進行晶化處理，可以發現，在晶化過程中，隨晶化溫度的增加晶粒尺寸逐漸長大，但總體來說，都在100nm以下。
分享友人
分享到 Line

分享到臉書