deformation defect 中文意思是什麼
deformation defect
解釋
變形缺陷- deformation : 變形,走樣
- defect : n. 1. 缺陷，缺點，弱點；短處。2. 不足，缺乏。vi. 叛變；逃走。 He defected to the West. 他叛逃到西方。
-
In order to detect the bottom thickness, cavity, leak and deformation of steel meshes in secondary lining of concrete in tunnel construction, the authors evaluate the wave character and the detected result in the second lining of the tunnel using surveying radar technology and conclude the wave character in the tunnel lining which has mass defect and tested the accuracy and reliability of this technique
摘要為檢明隧道混凝土二次襯砌中的底界厚度、空洞、漏水、鋼筋網變形等質量問題，利用探地雷達技術，通過對檢測方法及工程檢測實驗的研究，進行隧道二次襯砌中雷達波形特徵參數及檢測結果評價，總結了隧道襯砌質量問題的雷達波形特徵，驗證檢測方法的精度和可靠性。 -
Drawing piece unfold size is one basic condition under the calculation on coefficient, number of drawing, handbooks or books of press are not given, practice press production, die designer designs drawing die by experience calculation, after testing, according to deformation, state, defect shape of testing blank, shape and unfold size is revising, finally, unfold size and shape of blank are determined, designing period is longer, cost of die and work piece is to raise, economic benefit is to reduce
拉深件展開尺寸是拉深可行性分析中計算拉深系數與拉深次數的前提條件，現有沖壓手冊或教材對于復雜拉深件的展開尺寸計算尚未論述。復雜拉深件的沖壓生產中，模具設計者憑經驗估計拉深可行性，設計製造拉深模進行反復試壓，根據試壓件的形變狀態，缺陷形貌，制定坯料展開尺寸和形狀，周期較長，因而生產成本高，經濟效益不佳。 -
Relationship has been studied on defect to deformation degree, friction factor and relative length of mould plastic section
同時，研究了表面缺陷產生與變形程度、摩擦因數及模具整形段相對長度的關系。 -
( 4 ) which deformation behavior of cementite lamellae in pearlite colonies is closely related to the stress state of cementite which significantly depends on cementite thickness and orientation, especially on cementite thickness. ( 5 ) the lamellar cementite undergoes partial dissolution on the present deformation. the thermodynamical destability of cementite is attributed to a large number of defect in cementite introduced by severe plastic deformation providing evidence for cementite dissolution
而滲碳體的應力狀態主要是與滲碳體的片層厚度和取向密切相關的，其中滲碳體的厚度起決定性作用； （ 5 ）本實驗變形條件下，滲碳體出現了部分溶解的現象，這是由於強烈塑性變形而在滲碳體中引入大量的缺陷導致其處于高能不穩定狀態從而促使了滲碳體溶解。
分享友人