demodulator filter 中文意思是什麼

demodulator filter 解釋
解調濾波器
  • demodulator : 反調器
  • filter : n 1 濾器，濾紙，過濾用料[砂、炭等]。2 【無線電】濾波器；【物理學】濾光鏡，濾色器。vt 過濾，用過濾...
  1. Signal channel is composed of photodetection preamplifier and filter circuit, reference channel and correlation demodulator are realized by labview

    信號通道由硬體實現，包括光電探測前置放大電路及濾波電路;參考通道及相關解調器部分則利用labview軟體編程實現。
  2. In this part the signal from the infrared sensor was amplified by common collector amplifier, and the demodulator was built by filter. in which the signal got demodulated. because we just need the frequency of the signal, filter may achieved

    通過信號通路，傳感器生成的調幅波信號轉變為與脈搏頻率相同的方波。先由運算放大器接共集電極電路完成信號放大，通過濾波得到脈搏信號的頻率，從而用濾波器電路完成了解調功能。
  3. In this scheme digital demodulator is used to detect ifog ' s signal, digital phase ramp modulator is used as feedback controlling and digital filter is used to limit noise and lower the bits of a / d ? d / a converters

    閉環方案中，採用數字解調方案進行信號檢測，採用數字相位階梯波調制技術進行反饋控制，採用數字濾波、數值濾波降低噪聲和消除a / d 、 d / a轉換死區誤差。
  4. Based on iec standards, the methods of designing square demodulator, bandpass - weighted filter, and smoothing filter are presented. besides, the signal conditioning circuits and online statistical analysis methods of instantaneous flicker value are given. matlab simulink is also used to simulate the measuring process of voltage fluctuation and flcker

    基於iec標準要求，設計了實現數字式電壓閃變測量的平方解調器、帶通加權濾波器、平滑濾波器等各環節，給出了信號調理電路和瞬時閃變值在線統計分析方法，並應用matlab系統模擬工具simulink對電壓波動和閃變測量全過程進行了數字化模擬。
  5. The receiver unit mainly consisted of the digital down converter, matched filter, integration and dump module, power detector, symbol tracking processor, differential demodulator, parallel - to - serial conversion module, output processor and afc module

    接收部分主要有數字下變頻、數字匹配濾波器、積分清洗、功率檢測、符號跟蹤處理、差分解調、並串處理、自動頻率跟蹤處理等模塊。
  6. Firstly, the theory and the architecture of hardware system are described, secondly, the steps of the signal processing are discussed in detail. based on the experiments and the characteristics of the signal, we pre - process the signals with band - pass filter, proportional amplifier and coherent demodulator. after sampling and analysis doppler information, we display the final results distinctly to alarm in time

    然後，結合系統中各主要部分的任務，詳細介紹了信號處理的各個步驟：通過實驗比較，並結合接收信號的特點，選用帶通濾波器、比例放大器、相干檢波等技術對信號進行預處理；然後對獲得的多卜勒信息進行采樣和頻譜分析；最後，用比較直觀的形式顯示數據結果，以及時準確地告警。
  7. To improve the performance of the system, some methods are introduced, such as photoelectric brightness modulating, amplification of the photoelectric ac signal and filter design. the circuitry of the demodulator is also presented. this work lays solid foundation for the future system integration

    最後，介紹了數字式加速度計的參考電路設計，其中重點介紹了數字式再平衡迴路的設計，包括脈寬調制、恆流源、極性開關等電路的設計。
分享友人
分享到 Line

分享到臉書