deposited coating 中文意思是什麼
deposited coating
解釋
積附塗層-
Particles deposited in the alveoli are immediately subjected to coating by surface active lipid materials.
當粒子沉澱到肺泡中時，立刻會遭到表面活性的脂質物質的覆蓋。 -
Liberation of hydrogen gas would be increased rapidly and sic particles on the surface might be dispersed if the current density exceed the upper limit. furthermore, nickelous hydroxide would be deposited because the ph of plating solution nearby the surface rapidly increased. all of above might result in coating deterioration
若電流密度過大，超過所允許的上限值，會析出大量的氫氣，可能沖散表面覆蓋的sic微粒，而且易使磨頭表面鍍液ph值急劇上升而形成氫氧化鎳沉澱，導致鍍層質量惡化。 -
Anti - oxidation performance of electro - pulse deposited aluminum coating on cr2mo boiler steel
鍋爐鋼電脈沖沉積鋁塗層的氧化行為 -
Seen from the experiment result, it is clear that the deposited coating obtained with the trivalent chromium electrodepositing method we use is smooth, homogeneous, dense, and has good unti - erosive ability, high stiffness. the color ol ihe deposited coaling ol irivalent chromium is similar with that of hexavalent chromium. further more, this process has a good ability of homogeneous and deep depositing with simple facility, high current efficiency, and wide working current flow and even more it avoids environmental pollution
實驗結果表明，本文採用的三價鉻鍍鉻方法能電鍍出鍍層光滑、均勻、緻密、抗蝕性好、硬度高的鍍層，而且解決了鍍層顏色的問題，使三價鉻鍍層不僅具有現行六價鉻鍍層的天藍色光澤，同時還具有電流效率高、均鍍能力與深鍍能力好、工作電流密度寬、設備簡單、無環境污染等特點。 -
In the research on the physical and chemical properties of chromium, afm was first used to explore the effect of technological conduction to the topography of coating deposited, the size of crystal grain and the regularity of the growth of crystal grain
在對鍍鉻層理化性能研究方面，論文採用afm首次觀察到電鍍工藝條件與鍍層形貌、晶粒尺寸、晶粒生長規律之間的關系。 -
With the combination of xrf and xrd, we studied the rule of component, structure, crystal grain feature of chromium deposited coating. the law of trivalent chromium electrodepositing were extracted and contrasted with that of hexavalent chromium, laying a foundation stone for the deeper research on the process of trivalent chromium electrodeposition and it ' s industrialization
並結合xrf 、 xrd等研究手段，對不同工藝條件下所得鍍層的成份、結構、品粒特徵規律進行研究，提出了三價鉻鍍鉻的電鍍機理，為深入研究三價鉻鍍鉻工藝及工業化應用奠定了基礎。 -
And the field emission measurement was carried out at a pressure of 10 - 4pa. diamond powders coated with sliver are deposited on ito glass using electrophoresis coating method, through a solution of powders in isopropyl alcohol
利用葡萄糖的還原性將銀鹽中的銀還原出來，在超聲的條件下，還原出的銀將包覆在分散於溶液中的金剛石顆粒上。 -
Structure analysis of mechanical deposited zinc coating
機械鍍鋅層的結構分析 -
This paper describes the theory of oxide vacuum coating and the form mechanism of film. it is discussed the technique that nonmetal is conated on polymer. the barrier performance of this new material that is produce by using different deposited method and raw materials is compared
論述了非金屬真空鍍膜的蒸發理論和鍍層的形成機理，討論了非金屬鍍膜的技術方法與工藝，比較了不同蒸鍍原料與方法對材料阻隔性能的影響與效果。 -
The proper temperature is felt about from the substrate of p ( 100 ) cz - si, and it is found that the solar cell conversion efficiency has been improved from 8. 85 % to 11. 45 % for the annealing process. suitable processing conditions for cells " fabrication, hydrogen passivation, sinx anti - reflection coating deposited by plasma enhanced chemical deposition ( pecvd ) are also studied
將太陽電池樣品分別用pecvd （ plasmaenhancedchemicalvapordeposition ）做減反射膜，用fg （ forminggas ）燒結，測試電池性能，發現用pecvd處理后電池效率有所提高，用fg燒結后同樣有所改善。 -
However, it exhibits very poor adhesion when mpcvd diamond deposited upon wc - co directly. so reliable tool performance is difficult to obtain for the problem of coating adhesion
但是，通常用mpcvd法直接在wc - co基體上沉積的金剛石薄膜的附著力很差，因而金剛石薄膜塗層硬質合金刀具的性能並不令人滿意。 -
The different kinds of pyroelectric sensors were prepared on the porous silicon dioxide, plastic film and bulk silicon substrates respectively. the nanocomposite pclttp ( vdf - trfe ) film was deposited by spin - coating used as the sensing film, and ni - cr film was chosen as upper electrode and absorb layer
分別在多孔氧化硅、 pet塑料和硅襯底上，制備納米陶瓷/ p （ vdf - trfe ）復合敏感膜的熱釋電單元傳感器。 -
The licoo2 coating is deposited by sol - gel process, which enhanced the uniformity of the surface coverage
陽離子（ co卜和zn入）摻雜在高溫下將使limno 。 -
This paper mainly discusses the performance specification of plasma source ( gis ), technology and quality of tio2 and sio2 coatings and the technology for large antireflection coatings deposited with plasma - iad. the research shows that the index of optical coating increases remarkably by using plasma ion assisted deposition and approach to the massive material further, the coating structure is more compacted than the one obtained through conventional deposition method and the adhesive power is high as well
研究了用於輔助鍍膜的等離子體源（ gis ）的結構原理及性能指標，並從光學特性、顯微特性和機械特性三方面著手，研究了使用等離子體源所做的單層tio _ 2膜和單層sio _ 2膜的成膜工藝與質量。 -
Experimental results show that the as - deposited coating mainly contained tin phase, also a small quantities of oxides of titanium were detected
試驗結果表明，反應等離子噴塗tin塗層主要由tin相以及極少量ti的氧化物組成。 -
In regard of the deposition coating way, the results of experiments show that ph value have no influence on the coat layer forming. under different ph value in these experiments, graphite surface ca n ' t be coated mostly. just on some surface of graphite, is there the flaky coat layer deposited
沉澱包覆工藝改性研究結果則表明：沉澱法對ph值的選擇性較小，在本試驗選擇的ph值范圍內，石墨表面大部分沒有被包覆，只有小部分表面有局部富集的絮狀覆層物質沉積，包覆均勻性差。 -
This work using negative bias to improve the nucleus density, and quartz glass was used as a kind of depositional substrate and diamond was deposited upon it in an mpcvd equipment. the diamond coating was characterized by xrd sem rama xps. the experimental results show that the mostly component of the film is diamond, and the results show that the sic is exist. it show that the diamond film not grow directly on the quartz glass, there exist the sic transition layer
在mpcvd制備得到了金剛石薄膜之後，分別用x衍射（ xrd ） 、掃描電鏡（ sem ） 、拉曼譜（ raman ）和光電子能譜（ xps ）等測試手段對金剛石薄膜進行了表徵，結果表明了生長出來的薄膜的主要成分是金剛石，同時發現了sic的存在，這表明了用mpcvd在石英玻璃上生長金剛石薄膜時，不是直接生長在sio _ 2上，而是有一個過渡層sic ，然後在過渡層上再生長一層金剛石薄膜。 -
Microstructure and properties of al2o3 ceramic gradient coating deposited by detonation gun spraying
3陶瓷梯度塗層的組織與性能 -
Meanwhile, the preparation of the carbon nanotubes composite coating was studied in this paper. the pure carbon nanotubes were deposited in the nickel coating by the chemical composite deposition method, and the influence of some factors in the process of the preparation was analyzed
採用化學復合沉積的方法，將純凈的碳納米管復合於鎳鍍層，制備出了碳納米管鎳基復合鍍層，並對制備過程中的影響因素進行了分析。 -
Testing of electrolytes used for electro - deposited metallic coatings ; test involving electro - deposition of a coating in the hull cell, general principles
電鍍金屬鍍層用電解液的檢驗.包括在薄膜電池中鍍層的
分享友人