dielectric layer 中文意思是什麼

dielectric layer 解釋
介電層
  • dielectric : adj. 非傳導性的，絕緣的，介電的。n. 電介質，電介體，絕緣體。
  • layer : n 1 放置者，鋪設者，計劃者。2 【賽馬】（一般）賭客。3 產卵的雞。4 【軍事】瞄準手。5 層；階層；地...
  1. When an inhomogeneous plane wave is introduced into a dense dielectric layer, it can bounce between the two boundaries.

    把一非均勻平面波引進折射率較高的介質層時，它會在上下界面間來回地「彈」射。
  2. Because of the restriction of the performances of the infrared materials, we decide that the hollow waveguide should have the structure of single layer dielectric coated metallic film according to the general analysis of process controllability and transmission capability. the dielectric we choose is silver iodide, made from silver and iodine, and the optimum thickness is about 0. 77um

    因材料性能的限制，通過傳輸性能以及工藝可控性綜合分析，確定製備的空芯光纖為單層電介質塗覆金屬膜結構，電介質膜定為碘化銀，理論厚度為0 . 77 m左右，由銀膜直接碘化得到。
  3. For the first time, we investigate the effects of the non - polarization layer on the polarization and the dielectric susceptibility of a ferroelectric multilayer

    我們首次研究了無極化雜質層對鐵電多層膜極化和介電極化率的作用。
  4. 3. by using the shack - hartmann wavefront sensor, the thermal distortion of the substrate, the single - layer dielectric thin films with different thickness, and the multilayer dielectric thin films with different multilayer thin films ( ybf3 / znse ) irradiated by co2 laser were studied experimentally. 4

    3 .利用夏克一哈特曼波前傳感器，對基底樣品以及不同厚度的介質單層膜樣品和不同膜系的ybf3 / znse介質多層膜樣品在c02激光輻照下的熱畸變進行了實驗研究。
  5. Both the dielectric layer and metal film were internally deposited on the fiber. it is found that ag is able to engender the highest ir reflectivity among the metal materials, so ag is ascertained as the metal layer material of the hollow waveguide, cop was used in this work as the dielectric material. based on countless calculations, optimum thickness for the deposited films were obtained, namely, 0. 2 / / m for ag layer and 1. 4 fan for the cop layer

    實驗用來制備空芯光纖的基管材料為石英基管；內徑為1mm ；通過理論推導與分析發現：相對于其它的金屬材料而言，金屬銀的紅外反射率最高，因此金屬銀最適合用做制備空芯光纖的金屬膜層的材料；通過比較幾種聚合物的性質確定選擇環烯聚合物cop為電介質層材料；通過理論推導與計算確定了金屬銀膜與電介質膜的最佳理論厚度，即銀膜為0 . 2 m ， cop膜的厚度為1 . 4 m 。
  6. The dissertation gives a comment on the field of energy - transmitting fibers for mid - infrared laser, an introduction to the mechanism of infrared - transmitting fibers in view of radiations and waveguides, and a theoretical analyze of the layer - selecting method for the fibers with multi - layer dielectric films. in view of the properties of sic in the region of mid - infrared, the author has done many works about the energy - transmitting fibers with sic, and summarized as follows : first, it is found that sic is a very good material for the fabrication of power - transmitting fibers for mid - infrared laser, especially for co2 laser that works at 10. 6um wavelength, and sic / sio2 hollow fibers has not been studied in the world for the first time to our knowledge. second, it is pointed out, for the first time to our knowledge, that the hollow fibers with a structure like si / sic / sio2 or ge / sic / sio2 have very good properties for the mid - infrared laser power transmitting, especially for co2 laser

    本論文評述了關于中紅外傳能光纖的國內外進展，從光射線理論和波導理論出發介紹了紅外傳能光纖的傳輸機理，從薄膜光學出發分析了多層介質膜傳能光纖的膜層選擇機理等基礎理論，針對碳化硅（ sic ）在中紅外區的特點，在導師侯藍田教授領導的科研組已有成果的基礎上進行了以下幾個方面的研究：發現了sic是制備紅外傳能光纖的良好的紅外材料， sic sio _ 2空芯傳能光纖在國際上還沒有人進行研究：提出了具有si sic sio _ 2和ge sic sio _ 2膜結構的空芯傳能光纖，據我們所知，這種光纖目前在國內外還沒有人進行研究，並對其傳輸性能進行了可行性分析。
  7. A triple - layer radar absorbing coatings composed of dielectric and magnetic materials were prepared according to resistance matching principal, which is then further coated with an infrared and visible light camouflage coatings

    摘要依據阻抗匹配原理制備了一種3層雷達吸波塗層，並在吸波塗層表面噴塗一定厚度的可見光、紅外偽裝塗料，比較了噴塗偽裝塗料前後塗層吸波性能的變化。
  8. Cbb88 are non - inductively wound with electrode of double - layer metallized polyester film and dielectric of polypropylene. wrapped with polyester tape and sealed with wpoxy resin, usetinned copper leads

    Cbb20為無感結構，用聚丙稀膜作為電介質和鋁箔作為電極繞制而成，導線採用鍍錫銅線，外層用聚酯膠帶包裹，兩端使用環氧樹脂密封。
  9. The experiments showed us : firstly, mediums with different magnetic and dielectric properties had different influence on the microwave - absorbing properties of spinel ferrite ; secondly, magnetic texture treatment greatly affected the microwave - absorbing properties of the spinel ferrite - based mixed material which contained single - domain particles of hexagonal ferrite, changing the matching thickness, the density of area and the position of absorption peaks and increasing the absorption quantity and the 10db bandwidth ; thirdly, the coupling effect between different layers affected the microwave - absorbing properties of the double - layer spinel ferrite - based mixed material, decreasing its matching thickness and density of area and increasing the position of absorption peaks

    實驗發現： （ 1 ）不同磁性與電性的介質對尖晶石型鐵氧體吸波特性的影響不同； （ 2 ）磁織構化處理對含有六角晶系鐵氧體單疇顆粒的尖晶石型鐵氧體基混合吸波材料的性能影響很大，可以改變匹配厚度、面密度與吸收峰峰位，提高吸收量與10db帶寬； （ 3 ）對于雙層材料，層間耦合作用會影響其吸波性能，降低匹配厚度與面密度，提高吸收峰峰位。
  10. Development and mass production of targets for lcd - tft and for dielectric layer in optical data storage application

    介電層靶材升級與顯示器靶材之開發與量產化
  11. The outcome suggest that, firstly, the change of light transmission with the continuous change of parameters is periodic ; secondly, as far as the degree of effect is concerned, the light transmission of air - spaced prisms is much more sensitive to the change of the parameters than that of the glue spaced ones ; thirdly, as to the prisms glued with the same dielectric, the effect of prisms whose optical axis parallels to the glued layer is intense than those whose optical axis parallels to the plane determines by the normal of incident face and that of the cut face

    研究認為，激光偏光棱鏡的光強透射比隨各參量的連續變化都呈現出一定的周期性；各參量對空氣隙型偏光棱鏡的影響要比對膠合型棱鏡的影響大的多；同種介質膠合的棱鏡，各參量對光軸平行於切割斜面的設計類型比光軸平行於切割面的法線和入射端面的法線所組成的平面的設計類型的影響要大。
  12. A reflective polarizer based on a double - layer subwavelength metal - dielectric grating structure is presented here. numerical simulations show that at normal incidence, this polarizer reflects light polarized perpendicular to the grating lines ( transverse magnetic polarization ), but strongly absorbs parallel - polarized light ( transverse electric polarization ). the polarization extinction ratio is very high

    理論計算表明，零角度入射時，該光柵結構在可見波段對tm波有很高的反射率，而對te波強烈吸收，即可獲得很高的反射光偏振比，可以作為理想的集成偏振器件。
  13. The blocking - layer and the dielectric mirror separate the write beam and the read beam, and the dielectric mirror reflects the read light also. in order to separating the write beam and the read beam quietly, and reflecting the read bean in the most limit

    液晶光閥的阻光層和介質鏡層起著隔離寫入光和讀出光的作用，介質鏡層還起著反射讀出光的作用。
  14. Detail specification capacitors, chip, multiple layer, fixed, unencapsulated, ceramic dielectric, established reliability type ctk4103

    Ctk4103型有可靠性指標的非密封多層片狀瓷介固定電容器詳細規范
  15. Detail specification capacitors, chip, multiple layer, fixed, unencapsulated, ceramic dielectric, established reliability type cck4104

    Cck4104型有可靠性指標的非密封多層片狀瓷介固定電容器詳細規范
  16. Detail specification capacitors, chip, multiple layer, fixed, unencapsulated, ceramic dielectric, established reliability type cck4103

    Cck4103型有可靠性指標的非密封多層片狀瓷介固定電容器詳細規范
  17. Detail specification capacitors, chip, multiple layer, fixed, unencapsulated, ceramic dielectric, established reliability type ctk4104

    Ctk4104型有可靠性指標的非密封多層片狀瓷介固定電容器詳細規范
  18. Detail specification capacitors, chip, multiple layer, fixed, unencapsulated, ceramic dielectric, established reliability type ctk4102

    Ctk4102型有可靠性指標的非密封多層片狀瓷介固定電容器詳細規范
  19. Half - wave dielectric layer

    半波介質層
  20. Thin - film area : the area to deposit " dielectric layer " and " metal layer " as the conducted or insulated films, also has cmp ( chemical - mechanical _ polish ) to planarize the chips on the wafer ' s surface and add high ( low ) temprature rtp ( rapid - thermal - process ) to the wafer

    薄膜區：專門沉積「介電層」 ， 「金屬層」等導電或不導電薄膜的區域，併兼做晶圓表面器件之平坦化及高（低）溫快速熱退火製程。
分享友人
分享到 Line

分享到臉書