dip treatment 中文意思是什麼

dip treatment 解釋
浸湯處理
  • dip : vt (dipped 〈古語〉 dipt; dipping)1 浸,泡,蘸;(微微)弄濕,濡濕;浸染。2 把(旗等)稍稍放下...
  • treatment : n 待遇;作業;處理,處置;討論,論述;【醫學】治療,療法;(種子的)消毒(處理)。 preferential t...
  1. Among various fabrication techniques of thin film, the sol - gel process has gained much interest for the preparation of pzt thin film, due to ihe advantages of good homogeneity, easy control of composition, low in - ill i reaving temperature, easy formation of large area thin films pb ( zrxti : - k ) 0 :, ( pzt ) films were prepared on the ito coated glass plates and low resistor silicon wafer in sol - gel dip - coating process associated wi di heat treatment : at different temperatures and characterized by x - ray diffraction ( xrd ) and transmission electron microscopy ( tem ). lt is shown that the pzt ferroelectric thin films with ( 110 ) preferred orientation and well - crystallized perovskite structure can be obtained after annealing at 680 ? for 30 minutes on ito substrate and at 800 " c for lornin on silicon substrate

    Pzt的制備方法有很多,其中溶膠?凝膠( sol - gel )方法可以和集成電路( ic )光刻工藝相互兼容,處理溫度低,有大面積塗敷性能,能精確地控制組分,無需復雜的真空設備,成本低廉,所以對于集成鐵電薄膜電容的應用這種方法有很廣闊的前景。本文利用sol - gel技術在摻錫的in _ 2o _ 3透明導電薄膜( ito )襯底和低阻硅襯底上成功地制備了pzt鐵電薄膜。運用了x射線衍射, sawyer - tower電路和lcr電橋分別對薄膜的晶化溫度,結構和電學性能進行了測試。
  2. Surface treatment of cold galvanizing, hot dip galvanized, plastic spraying, fire coatings, paint, and also produces aluminum alloy, stainless steel, glass steel, fire - retardant products such as cable tray

    產品表面處理有冷鍍鋅、熱鍍鋅、噴塑、防火塗料、烤漆等,並且還生產鋁合金、不銹鋼、玻璃鋼、阻燃等電纜橋架產品。
  3. Jin yuan wire mesh co., ltd. also provides barbed iron wire, pvc coated iron wire, black iron wire and different metal wire and wire mesh products, besides its traditional series welded wire mesh products. we use different weaving methods and processing methods to produce wire mesh products to meet specific applications. for example, we have electro galvanized welded wire mesh, hot - dip galvanized welded wire mesh and pvc coated welded wire mesh due to different processing and finish treatment

    主要生產:各種規格型號的電焊網重型電焊網塗塑電焊網六角網鍍鋅方眼網不銹鋼絲網窗紗網刺繩和金屬絲等系列產品,分為:超大絲號超寬幅重型電焊網及不銹鋼網鍍鋅方眼網鍍鋅六角網窗紗等幾大類。
  4. In a beauty treatment imported from turkey, bathers at " dr fish ", a new spa in the hot spring resort of hakone, dip their feet into a warm pool teeming with fish that nibble away at dead skin and bacteria

    在一個名為「魚醫生」的新溫泉區里,浴療者把他們的腳伸進一個暖水池中,池中的一條條小魚就會慢慢啃掉他們腳上的死皮和細菌。
  5. Prepared technical parameters were optimized by l9 ( 34 ) experiment analysis. a unique method for cleaning and drying of substrate - cleaning used by scour, drying used by infrared light was fished out by large numbers of experiment. chemical mechnism of zno thin film prepared by sol - gel technique was discussed by dta for the first time. by the measurements of sem, xrd and uvs, the thin film was analysed. the result proved that the thin film with strongly preferred orientation of c - axis perpendicular to the substrate surface which surface was homogenous, dense and crackfree was the crystalline phase of hexagonal wurtzite. the thin film was composed of plentiful asteroidal crystal which crystal dimension approximately 10 30nm. the average transmittance of thin film in visible region was above 90 %. the results of measurements else also proved that the thickness of single dip - coating was 75 240nm, this films resistivity was found to be 3. 105 102 3. 96 105 ? cm. the thickness and resistivity of thin film influenced by dope - content, withdrawal speed, pre - heat - treatment, anealing were reseached respectively

    利用xrd 、 sem以及uvs光譜儀等分析方法對薄膜進行了研究,結果顯示,所制備的薄膜為六方纖鋅礦型結構,具有高c軸擇優取向性;表面均勻、緻密,薄膜材料由許多星狀晶粒組成,晶粒尺寸大約為10 - 30nm左右;薄膜可見光透過率平均可達90 % ;對薄膜厚度以及電學性能進行了測定后發現:單次鍍膜厚度約為75 - 240nm , al ~ ( 3 + )離子摻雜型氧化鋅薄膜的電阻率在3 . 015 102 - 3 . 96 103 ? cm范圍內;分別研究了摻雜濃度、提拉速度、預燒溫度、退火溫度等工藝參數對薄膜厚度和電阻率的影響。
  6. The bonelike apatite is formed on the anodized substrate when it is subjected to alkali and heat treatment and then dip into the sbf solution. after 7 days the bond strength of bonelike apatite layer to the substrates can reach 36mpa

    當對氧化鈦膜進行適當的堿處理和熱處理,在人體仿生液sbf溶液中浸泡7天後表面形成的骨質磷灰石與基體的結合強度可達到36mpa 。
分享友人