direct current control voltage 中文意思是什麼
direct current control voltage
解釋
直流控制電壓-
The modulating signals of firing delay angle at the rectifier and firing lead angle at the inverter, and the excitation voltage are chosen to be control variables. the offset of the current of dc line and the extinction angle and the power angle of generator are chosen to be control outputs. then a nonlinear controller is designed for the system under study according to direct feedback linearization theory
以整流側觸發延遲角的調節信號、逆變側觸發超前角的調節信號以及發電機勵磁電壓作為控制變量，以直流線路電流、逆變側關斷角以及發電機功角的偏移量作為目標輸出，用直接反饋線性化方法設計了系統的非線性控制器。 -
The control tactics of space voltage vector are investigated, and the simplified algorithm which judges the sector location of reference vector and calculates switch operation time is put forward. by analyzing the current hysteresis control, the relation between switch frequency, and hysteresis bandwidth and input inductance of pwm rectifier is deduced. by applying instantaneous power theory, the principle of pwm rectifier power control is analyzed, and the direct power control by matlab toolbox through estimating active power and reactive power with virtual flux is realized, and the simulation results prove that it is correct
對常用空間電壓矢量控制策略進行分析，提出了給定參考矢量所在區間判斷的簡化方法，以及電壓矢量作用時間的求取方法；分析了電流滯環控制策略，推導出開關頻率與滯環帶寬以及整流器輸入電感之間的關系；應用瞬時功率理論分析pwm整流器功率控制原理，通過虛擬磁鏈估計有功功率和無功功率，用matlab實現了直接功率控制，並驗證了該控制方法的正確性。 -
The author of the dissertation pay a lot efforts to focus on designing the dual - loop control circuit based on optimized psm, include : 1 ). researched the relationship of input and output voltage and output valtage ripple, when psm operate in continuous current mode and discontinuous current mode respectively. what we have done will direct psm apply to converter
本文在psm調制理論的基礎上，設計基於優化psm調制模式的雙環控制電路，主要包括以下幾個方面內容: 1 ）對psm調制模式分別在連續和斷續工作模式下的輸入輸出電壓關系以及輸出電壓紋波進行研究，以期指導psm調制模式在變換器中的應用。 -
Considering the practicality in specific design, the two different drive system has been designed in the electrical control system, this is, the hoist and gantry uses a set of the ac ( alternating current ) frequency conversion timing drive system, the trolley and boom uses a set of the dc ( direct current ) adjusting voltage and timing system
在具體設計時考慮到實用性，設計的電氣控制系統中採用了兩類不同的驅動系統，即起升與大車共用一套交流變頻調速驅動系統，小車與臂架俯仰共用一套直流調壓調速驅動系統。 -
Considering the practicality in specific design, two different drive systems are designed in the electrical control system, that is, the hoist and gantry share a set of alternating current frequency conversion timing driving system, and the trolley and boom share a set of direct current adjusting voltage and timing system
考慮到實用性，設計的電氣控制系統採用兩類不同的驅動系統，即起升與大車共用1套交流變頻調速驅動系統，小車與臂架俯仰共用1套直流調壓調速驅動系統。 -
Second, a direct torque control for pmsm based on stepping spwm is analyzed. in classic dtc system, the torque and current ripples are larger because of the restriction of the number of voltage vectors. by means of the vectors subdividing theory, using a new method of dividing voltage vectors based on stepping spwm, more voltage vectors on a circle in space can be achieved
其次考慮到上述的經典的dtc演算法中，由於電壓矢量個數（六個）的限制，使得轉矩波動和電流波動都比較大；針對於此，本文利用矢量細分原理，提出了新的基於階梯spwm的電壓矢量生成方法，得到了更多的空間上均勻分佈的電壓矢量，可對電壓矢量進行更加有效的選擇。 -
According to the space vector modulation method of the equivalent structure of the ac - dc - ac transformation, the transformation relations of the matrix converter are deeply investigated. the ac - ac direct conversion control and the double - space - vector pwm scheme of the matrix converter are deduced, the four - step current commutation strategy of matrix converter is expatiated, the design method of input filter and over voltage protection circuit is analyzed, and the modeling and simulation of a three - phase matrix converter are implemented
從等效交-直-交變換的空間矢量調制方法出發，深入分析了矩陣式變頻器的變換關系，導出了交-交直接變換控制規律和雙空間矢量脈寬調制技術，闡述了矩陣式變頻器的換流控制策略，分析了輸入濾波器和過電壓保護電路的設計方法，實現了矩陣式變頻器的建模和運行分析。 -
After studying a lot of documents, we present a speed - estimating method for direct torque control system. this method is based on the theory of dtc, but it takes advantage of the convenient of both the theory of dtc and the theory of foc. we need only to sample the stator ' s current to estimate the speed of the rotor, at the same time the integration of the voltage is avoided
在研究大量文獻的基礎上提出了一種適用於交流電機dtc控制系統的轉速計算方法，該方法以dtc控制為中心，結合dtc和定子磁場定向和轉子磁場定向各自的特點，綜合利用各自的有利之處，只需測量定子電流，避免了對電壓積分，思路清晰，計算簡單。 -
The power circuit of the system adopts the voltage frequency conversion structure of ac - dc - ac, and is composed of the commutation circuit, filter circuit and intelligence power module ( pm15rsh120 ). control circuit takes the dsp chip tms320lf2407 as core, including the pwm signal occurrence circuit, detect circuit of stator current and direct current voltage of generatrix, drive circuit of intelligence power module, detect circuit of speed, protect circuit of system etc. all of this builds the full digital vector control system of asynchronous motor
該系統的功率電路採用電壓型的交-直-交變壓變頻結構，由整流電路、濾波電路及智能功率模塊ipm （ pm15rsh120 ）逆變電路構成;控制電路以dsp晶元tms320lf2407為核心，加上pwm信號發生電路、定子電流檢測電路、直流母線電壓檢測電路、智能功率模塊驅動電路、速度檢測電路、系統保護電路等，構成了功能齊全的異步電機全數字化矢量控制系統。 -
In this thesis, assembler language was applied to program to realize dsp algorithm controller, which can perform such main computing as data collecting, self - adaptable distortion current detecting based on linear nerve cell, capacity voltage controlling in the side of direct current based on fuzzy control, pwm pulse width computing based on unsymmetrical rule sampling, etc. quick control speed ( one work period is 50 s ) and high accurateness feature largely in the controller
本文採用匯編語言編程實現了dsp演算法控制器，它完成了數據採集、基於線性神經元的自適應畸變電流檢測、基於模糊控制的直流側電容電壓控制、基於非對稱規則采樣的pwm脈寬計算等主要演算法的運算。該控制器具有控制速度快（一個工作周期為50 ） ，精度高等特點。 -
This thesis studied the reason of the hysteresis and nonlinear characteristic of pzt thinner circle plate and cymbal transducer. using the charge control method, we designed a high voltage direct current power supply to control the transducer
分析了壓電陶瓷片及cymbal換能器的遲滯非線性成因，並運用電荷控制思路，自行設計了高壓可調直流電源對cymbal換能器進行控制。 -
High voltage direct current ( hvdc ) power transmission system is a typical nonlinear control system
高壓直流輸電系統（ hvdc ）是一個典型的非線性控制系統。 -
According to the following design theory : the dsp calculates in real time and produces three phases spwm waves to control the on or off of the 6 igbts in ipm respectively. ipm then inverts the commutated single phase direct current ( insulated gate bipolar transistor ) into three phases alternating current. when modulated signals of spwm are changed, the on - off time of switches also changes, so as to the voltage and frequency of output signals
本文提出了一種基於dsp （數字信號處理器tms320f240 ）的通用的三相間接變頻電源系統，利用分段同步調製法和混合查表法，實時計算不同頻率下的采樣周期、電壓幅值、輸出脈寬，產生雙極性spwm波形，經驅動放大後用于ipm （ intelligentpowermodule ）中的絕緣柵雙極型晶體管柵級驅動，以控制電源的輸出電壓和頻率，實現變頻電源的智能數字控制。 -
The control system is the core of high voltage direct current ( hvdc ) transmission system
控制系統是高壓直流輸電系統的核心。
分享友人