discharge factor 中文意思是什麼

discharge factor 解釋
流量系數
  • discharge : vt 1 發射(炮等),打(槍),射(箭)。2 起,卸(貨)。3 排泄,排出,放出(水等)。4 釋放;解除,...
  • factor : n 1 〈英國〉經銷人;(代客買賣收取傭金的)經紀人;代理商;代辦人;〈蘇格蘭語〉 土地經管人。2 要素...
  1. So the uncertainty of flood hydrograph is really a important factor which contributes to the risk of flood discharge. for practical usage, c programs are written for dealing with so much data

    針對調洪演算重復、繁瑣、工作量大的特點,本文也編制了處理前期數據的計算程序。
  2. With experiments and theoretical analyzing, we find when the heat discharge is smaller than the entrainment limited, what influences the ability of heat - transmitting of work quality is the quantity of injection and dry limit fluid inventory, the optimum quantity of injection of the three working fluid is 8 ~ 14g ; and the delivering factor that transmission coefficient is determined by capillary limit, not the heat transmission ability of the thermal syphon. therefore, among the three working fluid, acetone is the best. low wind - speed has the obvious function in heat transmission of the thermal syphon

    本文通過實驗研究和理論分析,認為在熱流量小於攜帶極限時,影響工質傳熱能力的是cpu重力熱管的充液量和其乾涸極限,此次所實驗的三種工質,最佳充液量應當在8g ~ 14g ;傳輸因素主要決定普通熱管的毛細極限,而不是重力熱管傳熱能力的決定因素;三種工質中的最佳工質是丙酮;小風速時風速的變化對cpu重力熱管的傳熱有明顯的作用,但在風速大於1m / s以後,風速增加對于cpu重力熱管的傳熱能力的增加效果減緩。
  3. Also, the author ’ s design strategy and creativity has been given in this paper. specifically, it includes : based on the feasibility analysis of the fit selection of control parameters in the aeration process, the aeration process of wastewater treatment of the joint - constructional complete - mixed activated sludge process has been aimed at in this paper. then, the state equations of the aeration process have been proposed in this paper, which is on the base of dissolved oxygen concentration ( do ) and discharge quantity of sludge ( qw ) as control variables, the concentration of bod and sludge as state variables. based on the present study on optimization control of wastewater treatment, the multivariable optimal control model with restriction factor has been presented in the paper with introducing modern control theory and system analysis into the field of activated sludge wastewater treatment,

    具體包括:以完全混合、表面曝氣合建式活性污泥工藝的污水處理曝氣過程為研究對象,在闡述了曝氣過程式控制制參數選取可行性的基礎上,建立了以溶解氧濃度do和活性污泥排放量qw為控制變量,以曝氣池中有機物濃度s和微生物濃度x為狀態變量的活性污泥曝氣過程的基本狀態方程;運用現代控制理論的觀點和污水處理理論,在現有關于污水處理最優控制問題研究的基礎上,建立了有約束條件多變量能耗最小數學模型,該數學模型是以有機物排放總量和狀態變量的末值條件作為約束條件,曝氣過程的能耗最小作為目標泛函;採用增廣拉格朗日乘子法對最優控制問題進行轉化,並對應用極大值原理求解能耗最小這一最優控制問題進行了詳細的解析;引入約束運算元,應用具有控制約束的共軛梯度演算法對能耗最小這一最優控制問題進行求解,並進行模擬實驗驗證。
  4. The capacitor has advantages of low dissipation, high insulation resistance, good self - healing character, and steady electricity performance, anti - striking current, strong over - carrying capacity, etc. it is assembled sith inner hidden discharge resistance. it is applied in high or low pressure sodium lamp and mercury - arc lamp for the help of power factor compensation

    斷開電流允許時間:在0 . 5秒內的8個半周波前跳閘絕緣電壓ul1699第59節:線路與負載之間1000v , 1分鐘
  5. Discharge coefficient is the important factor of influencing sucker rod pump performance. the discharge coefficient is calculated, and the main influencing factors are analyzed

    本文對有桿抽油泵的排量系數進行了詳細的計算,系統地分析了影響排量系數的主要因素。
  6. The selling engineer of our company has comprehensive professional knowledge to the production processes of users, before you order, we can sieve the medium according to users ' sieve machine type, production capacity, discharge demand of supplies factor is it analyse demand of you to come, so you can choose the rubber or the polyurethane ( pu ) to sift the surface material, we can also determine the grain size of sieving and sift the hole form accurately, this means screen mesh material of the company of square garden can produce the good economic benefits and social benefit

    我公司的銷售工程師對于用戶的生產過程具有綜合的專業知識,在您定購前,我們可以根據用戶的篩機類型,篩分介質,生產能力,排出物料的要求等因素來分析您的要求,因此您可以選擇橡膠或聚氨酯( pu )篩面材料,我們還可以精確測定篩分粒度和篩孔狀,這就意味著方園公司的篩網材料可產生良好的經濟效益和社會效益。
  7. Considering the influence of dynamical factor of sediment discharge as well as the difficulty of calculating number of input cell, the model is provided with strong nonlinear mapping capacity and applied to simulate and forecast monthly sediment discharge of longchuan river watershed, the outcome is reasonable with higher precision

    模型既能考慮到影響輸沙量時間序列的動力因子,又能解決網路的輸入單元數確定的困難和利用神經網路超強的非線性映射功能,通過對龍川江流域控制站月輸沙量的擬合與預測表明其結果合理,預測精度較高。
  8. The definitions and the conditions of cavitation erosion and flash vaporization have been discussed in detail ; the paper also shows examples of different definitions in different books, which cause the complexity of calculating discharge factor and the damage to control valve ; suggests relevant measures to avoid the damage in real working condition

    摘要對氣蝕和閃蒸的定義、產生的條件進行了詳細論述,以規范不同版本書籍在概念上的模糊不清,以及由此造成的調節閥流量系數計算的復雜性和對調節閥的損害,以便採取相應措施,在實際工況條件下加以避免。
  9. The high voltage windings is made by sectional aluminium foil with glass fiber and resin casting, the voltage between turns is very low, the partial discharge is very low, there is no cracking, since the expansion factor of conductor and insulation material is similar, it also has the advantages of no corrosion, no pollution, low losses, low noise level, anti - vibration, fire protection, maintenance free, long operating life and high reliability

    低壓繞組為銅箔繞制,半干nomex紙做層間和外層絕緣,經乾燥與銅箔固化為一體,散熱好強度高。高壓繞組為分段鋁箔繞制,玻璃絲網架環氧樹脂澆注,層間電壓低,局部放電小,導體和絕緣體膨脹系數相似,不裂壽命長無腐蝕無污染損耗小噪音低抗震阻燃免維護運行安全可靠。
  10. Alkaline zinc - manganese battery is widely used all over the world it has good performance of storage , low cost , stable discharge and convenience of carrying the sealing of the battery is a crucial factor to the performance of the battery due to the disadvantages of present sealants , leakage of electrolyte often happens what ’ s more , the sealing capability affects the performance of the battery the way to raise the sealing capability is to search for a good additive , which can improve the sealing capability through adding according to chemical principles , this article picks out ptfe and nylon66 as additive adding ptfe or nylon66 into the pitch can improve the sealing capability of the pitch at the same time , the temperature , the time , the amount of addictive , the way to drop temperature and the time of churning all should be considered by testing the constitutions , softening point , moving degree and length of needle of various pitch samples , we can compare the properties of different sealants can be studied by using of x - ray, the constitutions of the pitch can be indicated which can help us to explain these changes this article includes : testing the constitutions , soften point , moving viscosity and needle penetration of various pitches ; raising the sealing capability by adding ptfe nylon66 into the pitches ; testing the constitutions , soften point , moving viscosity and needle penetration of raised samples ; analyzing and discussing the basic principles of this method it is showed that soften point , moving viscosity and needle penetration of pitches are increased by adding ptfe nylon66 and the discharge time , initial voltage , capacity of battery with pitch raised by nylon66 are good and get to the requirement of gb t7 1 1 2 in a11 the method proposed in this article is available in practical industry use

    通過測定改進瀝青的軟化點、運動粘度和針入度等指標參數來比較不同的添加劑及不同的添加條件對瀝青封口性能的影響。本論文的主要研究結果為:系統測試了多種瀝青樣品的組成、軟化點、運動粘度、針入度;對市售瀝青分別添加聚四氟乙烯乳液、有機硅樹脂和尼龍66進行改進,制備了改進產品;對改進瀝青的組成、軟化點、運動粘度、針入度進行了測試和比較;使用改進瀝青組裝成電池並對電池進行恆電流放電測試、短路電流測試和電池漏氣、漏液性能的測試;對瀝青改進的原理進行了分析和討論。實驗結果表明:在瀝青中添加尼龍66和聚四氟乙烯乳液對瀝青的封口性能有明顯的提高;通過對工藝條件的不斷改進,目前的工藝條件已完全可以用於實際生產操作;以添加尼龍66改進的瀝青為封口劑組裝成的電池完全滿足堿錳電池生產的需要,且電池電容量、短路電流等指標均達到gb t7112標準要求;本文提出的改進方案,通過驗證是一種效果好、實用性強的方法。
  11. Electric insulation plays a very important role in high voltage electrical equipment. the insulation state directly determines the stability of electrical system. partial discharge is a very important factor resulting in insulation deterioration

    電氣絕緣在高壓電力設備中起著極其重要的作用,絕緣系統的狀況直接決定著電力主設備運行的可靠性。
  12. In the past years, people generally considered that the effect of the uncertainty of the flood hydrograph is not the main reason that result in the flood discharge risk and even ignore its effect. in the paper, this factor is take into account during analyzing and calculating flood discharge risk

    在已有的對施工導流及泄洪風險的研究中,人們普遍認為水文因子中的洪峰流量的不確定性是造成風險的主要風險因素,認為洪水過程的不確定性所帶來的影響很小,可以忽略不計。
分享友人