discharge line valve 中文意思是什麼
discharge line valve
解釋
排氣管線閥-
Must be installed to allow complete drainage of both the valve and discharge line
必須安裝到具有完全排泄能力的閥門和排泄管上。 -
Must not be smaller than the pipe size of the relief valve or have any reducing coupling installed in the discharge line
在安全閥和排泄管之間不要加蓋、閉塞、堵塞或包含任何閥門。 -
A discharge line should be piped from the air gap at the relief valve connection making sure that there is adequate drainage
應該在安全閥連接處的氣隙(或稱氣隙)接出排泄管,確保有充分的排泄。 -
To prevent water damage, the valve must be properly connected to a discharge line which terminates at an adequate drain
為了防止水的破壞,這些閥門必須與排水管道連接,以便能夠將水排到適當的排水口。 -
Temperature and pressure relief valve properly installed with a discharge line run to an open drain and protected from freezing
正確安裝降溫減壓安全閥,並配置排泄管引導至一個敞開的排水口,並確保不會被凍結。 -
Warning : reinspection of t & p relief valve : temperature and pressure relief valves should be inspected at least once every three years by a licensed plumbing contractor or authorized inspection agency, to ensure that the product has not been affected by corrosive water conditions and to ensure that the valve and discharge line have not been altered or tampered with illegally
警告:重新檢查溫度壓力安全閥:溫度壓力安全閥每年應該由有資格證書的管道承包商或經過批準的檢查機構來至少檢查一次,以確保這種產品不會受到腐蝕性水的影響,確保閥門和排泄管道不會被不合理的更換或損壞。 -
A drain line and air gap ( see literature es - ag / el / tc ) should be piped from the relief valve connection as shown, where evidence of discharge will be clearly visible and so that water damage will not occur
排泄管和氣隙(或稱氣隙,請參閱樣本es - ag / el / tc )應該根據圖示從安全閥連接處接出管道,要使得排泄物清晰可見,以避免發生水破壞事故。 -
The installation of a watts air gap with the drain line terminating above a floor drain will handle any normal discharge or nuisance spitting through the relief valve
連接通向地漏的排泄管的美國瓦茨氣隙的安裝將有助於處理通過安全閥排出的任何正常排放或有害的泄漏。 -
Temperature and pressure relief valve properly installed with a discharge line plumbed to an open drain and protected from freezing
正確安裝降溫減壓安全閥,並配置排泄管引導至一個敞開的排水口,並確保不會被凍結。 -
Line discharge valve design problem research
線性流量閥的內筒設計問題研究
分享友人