dispersed phase 中文意思是什麼
dispersed phase
解釋
分散內相-
When the dispersed phase droplet initial diameter was relatively small, the coalescence rate varied sharply as the dispersed phase droplet initial diameter changed, the coalescence effect was dominating with increasing the screw rotation speed and decreasing the output
當液滴初始直徑較小時，其集聚變化率隨著初始直徑的變化而急劇變化；提高螺桿轉速和降低擠出機產量有利於集聚的發生，分散效果較差。 -
The cause of this phenomenon probably is mg ^ si phase dispersed first and then ancu and al2cumg phase
可能是合金時效過程中， mgzsi首先析出，然後再析出川2c2及川2c2的緣故。 -
By means of a detailed analysis to the interaction between droplet and its carrying fluid for horizontal stratified / atomization two - phase flow, a theoretical model is proposed to calculate the droplet axial velocity profile and the relative slip between dispersed phase and continuous phase
摘要通過對水平分層霧化流中液滴和其攜帶流體間交互作用的分析，提出了一個預則水平分層霧化流中軸向液滴速度分佈以及彌散相和連續相之間相對滑移的理論模型，通過計算獲得了兩相速度參數及相對滑移參數。 -
Using digital image processing technique to process the solid - gas - water three - phase flow image and separate dispersed phase from the three - phase flow image, author calculated the bubble number, particle number in instantaneous image, area of bubble image and other parameters, and analyzed the effect of image enhancement, image segmentation, image analysis and other problems existed in bubble image processing
應用數字圖像處理方法對水氣固三相流圖像進行處理，將其中的分散相分別提取出來，計算得出瞬時圖像范圍內的氣泡個數、粒子個數，氣相所佔流動截面比等參數；分析了圖像增強、圖像分割、圖像分析等方法在多相流圖像測量上的作用以及氣泡圖像處理中存在的問題。 -
Electrorheological fluids based on metal and silica particles dispersed in silicone oil respectively are observed by means of an optic microscope. the fractal theory is adopted to characterize phase separation of electrorheological fluids and the fractal dimension ( df ) of an electrorheological fluid of 10 % particles in silicone oil is determined as 1. 78
模擬結果表明，電流變體的電致成鏈過程可分為三個階中文摘要段，即快速生長階段，緩慢生長階段和穩定階段；在成鏈過程中，小尺寸的微粒鏈和大尺寸的微粒鏈分別是流體的結構和其穩定性的重要決定因素。 -
Many researches have showed that the mechanical properties of al2o3 - matrix ceramics in which ti ( c, n ), tic or tin was dispersed could be improved a lot, which might be widely used in the field of machining. al2o3 - matrixed ceramics were fabricated by gas pressure sintering ( gps ) and gps with post - hip based on current techniques in this experiment. for al2o3 - ticn composite ceramics, the densitification process was controlled by the mechanism of solid phase sintering.
大量研究表明：採用ti （ c ， n ） 、 tic或tin作為第二相彌散顆粒所制備的氧化鋁基復相陶瓷相對al _ 2o _ 3單相陶瓷而言，性能有了顯著的提高這類復相陶瓷性能優良，在機械加工領域有著廣泛的應用前景本實驗採用氣壓燒結（ gps ）以及gps結合熱等靜壓（ hip ）后處理兩種工藝制備氧化鋁基復相陶瓷。 -
When the proportion of polymer and cement is high, the continuous phase is made up of polymer, the inorganic particles are dispersed in the polymer phrase, so the films have good extensional performance and low temperature flexibility ; when its proportion is low, the hydrated cement forms the local rigid gel network, so extensional performance and low temperature flexibility of films reduce obviously, but the resistance to water, ultraviolet and thermal ageing of films is improved
高聚灰比時，聚合物構成了連續相，水泥等以粒狀分散在聚合物中，塗膜具有優良的延伸性和低溫柔性；低聚灰比時，水泥水化形成了剛性的局部凝膠網路，使塗膜的延伸性和低溫柔性都顯著降低，但可提高塗膜的耐水、耐紫外老化和耐熱老化能力。 -
By the increasing of temperature, liyco3 - xo4 was further changed into licoo2 and lixco1 - xo, and then licoo2 formed by the reaction of lixco1 - xo with li2o. the reaction that produces licoo2 is almost completely done at 700, although some remaining li2o and li2co3 present as a partially amorphous film dispersed on the surface of licoo2, which can accelerate the growth of licoo2 crystallites. however, when temperature is higher than 850, some of licoo2 begin to decompose into the solid solution phase of liyco2 - yo2 and lixco1 - xo, and damaged its own crystal structure
制備licoo _ 2的合成反應中licoo _ 2的微結構不斷發生變化，隨著焙燒溫度升高， co _ 3o _ 4晶粒逐漸減小， licoo _ 2晶粒和顆粒逐漸長大，晶格內部缺陷減少， licoo _ 2晶格趨于完整，在焙燒溫度為850時licoo _ 2晶粒達到最大值；焙燒溫度低於700 ，晶胞參數a隨著焙燒溫度上升而減小，晶胞參數c隨著焙燒溫度上升而增大；而高於700則晶胞參數基本保持不變。 -
The results show that the a - phase - transformation of pure aach can be completed by heating at 1200 ? for two hours. but under this temperature, the alumina particles will be sintered together, which can lead to the formation of bough - like structures. and these bough - like structure will make the powder difficult to be dispersed
接著對碳酸鋁銨進行了焙燒實驗，研究了其在升溫過程中的相變行為，結果表明：純aach在1200保溫1 . 5h的情況下才能100轉變為氧化鋁，而在這樣高的溫度下，粒子之間會形成燒結頸，從而使粉體產物在形貌上出現所謂「樹枝狀」結構，給粉體使用時的分散帶來了困難。 -
Structure and properties of sialon aluminia matrix composite and the synthesis thermodynamics of high - quality dispersed phase
葉蠟石在碳熱還原氮化過程中的相變 -
Composite is one kind of multiphase material which consists of the consecutive matrix a, nd the reinforcement phase. large quantity of consecutive distributing - phase is called matrix - phase and the oblique distributing - phase is called dispersed - phase
復合材料是指有連續的基體與分散的增強材料組合的多相材料，其中呈連續分佈的相稱結合相，而間斷分佈的相稱增強相。 -
As a result 4 the rising annealing temperature induces si02 phase to form, also ivolves the formation of a si phase. in high - temperature - annealed sio ~, films the excess silicon atoms are present as si - si4 tetrahedra, randomly dispersed in the amorphous si02 matrix. photoluminescent spectra were observed for the samples excided by the laser whose wavelength is 365nm. the pl peak is located at about 445nm, which dose n ' t shift as the annealing temperature changes. as the annealing temperature is raised, the luminescent intensity increases. the phenomena suggest that the si - o - si bond as a defect center which is broken down by the stress at the si nc / si02 interface is the primary source of blue luminescence
這個陡的界面由於明顯的晶格結構的差別而有較大的應力。界面的形成伴隨著界面發光中心的增加，同時pl強度在l戶800有一個大的增強。這個結果提示我們，界面上h 0 s工鍵斷裂形成的nbohc應是藍光發射的主要原因。 -
Influence of motionless mixer on gas holdup and dispersed phase holdup
靜態混合器對氣含率及滯液率的影響 -
In this case, the continuous phase is aqueous and the dispersed phase is oil
就這種情況來說，雖然連續相是水，分散相是油。 -
The variation of the operating condition did not change the distributive range magnitude of the dispersed phase droplet
螺桿轉速和擠出機產量的變化對末端分散相液滴直徑的分佈范圍影響不大。 -
The results showed that when the dispersed phase droplet initial diameter was relatively large, the coalescence rate little varied as the dispersed phase droplet initial diameter changed and increasing the screw rotation speed and decreasing the output could obviously make for the dispersed effect
結果表明，當液滴初始直徑較大時，其集聚變化率隨著初始直徑的變化而變化較小；提高螺桿轉速和降低擠出機產量可以提高螺紋元件的分散效果。 -
The hiped beryllium material has higher mys value because of not only its lower consolidation temperature and higher consolidation pressure but also the more uniformly and finely dispersed distribution of its beo phase
靜壓鈹材由於其細小均勻beo的彌散分佈，加上在較低溫度和高壓下成形固結，從而_ （ mys ）較高。
分享友人