displacement experiment 中文意思是什麼

displacement experiment 解釋
驅替試驗
  • displacement : n 1 轉位，移動；取代，置換；（人的）流離失所。2 撤換，免職。3 【機械工程】（活塞）排氣量；【航海...
  • experiment : n 實驗；試驗；嘗試 （of） a scientific experiment 科學試驗，科學儀器設備。 a new experiment in ed...
  1. Rock resistivity displacement experiment of core on clastic reservoir

    碎屑巖儲層巖石電性水驅實驗
  2. Several semi - active control algorithms used in the semi - active suspension system with mr dampers are proposed and developed including the " on - off " voltage controller, the continuously linear variable voltage controller, the modulated continuously linear variable voltage controller based on " sky - hook " damping concept and the hybrid controller based on the combination of " sky - hook " damping concept and " ground - hook " damping concept and the fuzzy logic controllers using measurements of the relative displacement between the sprung and unsprung mass or the absolute acceleration of the sprung mass as the input variables of fuzzy logic controllers. the simulation models were prepared in matlab ? simulink ? fuzzy toolbox programs. the experiment setup of the semi - active suspension system with mr dampers in the lab has been designed and developed

    根據磁流變阻尼器特性和對懸架系統動力學特性的規律性研究，為磁流變阻尼器設計了基於「天棚」阻尼控制概念的「 on - off 」 、線性連續和修正的線性連續控制策略，基於「地棚」阻尼控制概念的磁流變阻尼線性連續控制策略， 「天棚」阻尼和「地棚」阻尼控制概念線性組合起來的磁流變阻尼混合控制策略，根據模糊控制原理設計了以簧載質量和非簧載質量間相對位移或簧載質量加速度分別作為輸入變量的模糊邏輯控制器用於磁流變阻尼半主動懸架的智能控制。
  3. With the method of accumulation in the gray theory, a group of experiment data of crack tip opening displacement ( ctod ) at different temperatures was accumulated two times, and then the data became a smooth curve

    摘要把不同溫度下的裂紋張開位移（ ctod ）試驗數據，用灰色理論中的累加方法，進行二次累加。
  4. The experiment procedure and analysis result about exteriorly extended end - plate connection with high strength bolt are introduced primarily ; each sample ' s dimension is given. the adding load equipment, measuring apparatus placed, measuring point established is detailed. adding load measure load and m - curve is produced ; the single span gabled frames horizontal displacement formula is deduced when the horizontal concentrated force is applied to it

    重點介紹了外伸端板高強螺栓連接的實驗過程及實驗分析結果，介紹了各組試件的形狀尺寸、加載裝置、測量儀器安放、測點的布置等；給出加載方式及測出的m -曲線；計算出試驗節點的初始剛度；推導水平集中力作用下單跨門式剛架考慮節點半剛性的側移計算公式。
  5. The dynamic data of displacement, strain and impetus force acquired from the experimental collection system are also well analyzed for measuring precision and errors. based on the underlying work and experimental features, the thesis proposes a simple, practical and well accurate impetus resultant force fitting method, weighted factor fitting method. a line - off data processing software system for bird - impact experiment, named as cadabie, is well designed under the principle of software engineering, and has been applied, with high praise, in bird - impact laboratory in the factory numbered 320 and esfahan bird - impact laboratory of iran

    本文系統總結了鳥撞實驗的全部過程、主要儀器設備的工作原理與性能參數，分析了鳥撞實驗動態數據採集系統中位移、應變與撞擊壓力傳感器測量系統的測量范圍、測量精度及其工作特點，提出了一種更適合鳥撞實驗的撞擊合力計算擬合方法：加權因子法，同時應用軟體工程原理編制了「鳥撞實驗計算西北工業大學博士論文機數據分析系統」 （ caoabie ） ，目前該軟體己經在320廠鳥撞實驗室以及
  6. Thirdly, it simulated the pumping circuit & dividing circuit with the widely used software matlab / simulink. the displacement of the rod piston and the impact of hydraulic are analyzed in the different input flow ( frequency of pump ) and different reversing time. it found out the cause of hydraulic impact ( one - to - one incorrespondence between the response time of dividing circuit and the operation time of rod piston ), and gave some methods to weaken hydraulic impact. in the final part of the paper, the reliability of the theory analysis is further verified by the experiment of hydraulic system

    首先在流變學原理的基礎上，深入分析混凝土在輸送管道內的流動狀態，得出混凝土泵的負載特性方程；然後根據功率鍵合圖的建模方法，建立泵送迴路和分配迴路的數學模型，並運用模擬軟體matlab simulink對泵送和分配迴路模型進行了模擬，分析了在不同的輸入流量（泵送頻率）和換向時間下，活塞桿的位移和系統的液壓沖擊情況，找到了引起液壓沖擊的根本原因（即分配迴路的響應時間（固定值）與活塞桿的運動時間（變化值）不相匹配） ，並提出了相應的改進方法。
  7. Through the pull - out experiment, the load displacement curve was obtained. contrasting the test results under the different condition to post - installed bar, it was clear about the mechanism of the inorganically post - installed bars. the test results of inorganically post - installed bars was compared especially with the traditional organically post ? installed bars

    通過拉拔試驗，得到了荷載位移曲線，對比了不同條件下植筋的試驗結果，明確了無機植筋的受力過程，特別同有機植筋進行對比，並提出了帶錐頭無機植筋的施工工藝。
  8. The diversiform non - contact measuring sensor is analyzed and compared in this paper mainly. much experiment and analysis is done to the lk081 ccd laser displacement sensor made in keyence, japan, and data is processed with matlab, then the style of the sensor and optimal measuring range being tit for this system is confirmed

    作者對多種非接觸測量傳感器進行了分析和比較：通過對日本keyence公司的lk081ccd激光位移傳感器進行大量實驗，應用matlab軟體對其實驗數據進行分析和處理，確定了滿足本測量系統要求的傳感器型號和最佳測量范圍。
  9. The average displacement can qualitatively explain the stepping movement of kinesin in experiment

    粒子平均位移定性解釋了驅動蛋白的梯跳實驗現象。
  10. ( 4 ) water flow model experiment is made and hydraulic pressure variation is observed, " the detainment and displacement " of semipervious aquifers in the process of decreasing water is also studied

    （四）模擬二元結構土層，進行土樣滲流試驗，觀測水壓的變化，研究弱透水層承壓水在降水過程中的「滯后和位差」現象和問題。
  11. Firstly, finite element model of lathe spindle using finite element technique is established, and supporting bearings are treated as springs, unknown physical parameters and partial vibration displacement make up of new solving vector through using method of combination of academic modeling and experiment, mathematic model of solving stiffness of beating of lathe spindle is established using inverse analysis method of response problem finally

    建立了機床主軸的有限元模型，將支承軸承簡化為支承彈簧，通過理論建模與實驗相結合的辦法，將待識別的物理參數和部分振動位移組成新的求解向量，利用響應問題的逆分析方法建立了求解主軸軸承剛度的數學模型。
  12. Cadmium ( cd ) is one of the mostly polluting heavy metal. first, to characterize the adsorption property of cadmium, cadmium adsorption isotherms in soils were determined by the batch experiment, and the adsorption parameters were obtained ; second, miscible displacement experiments were carried out in saturated homogeneous soil columns under steady - state water flow, and the dynamics of flux concentration of cadmium leached in soils were measured

    首先，用批量平衡法開展了鎘在砂質壤土、壤質砂土和粉壤土中的吸附特性的試驗研究，獲得吸附常數；其次，採用易混合置換實驗的方法，對其在穩定流場飽和土壤中的運移進行了室內研究，獲得了目標溶質鎘在定濃度輸入條件下的出流液濃度動態。
  13. In fatigue tests, the fatigue test was paused whenever fatigue life cycle was reached to 1500, then similar gradual cyclic experiment was re tried, the displacement distribution around the hole and the strains at the side of hole were measured

    在疲勞試驗過程中，每當疲勞循環1500次就停機，進行同樣的緩慢循環實驗，並測量出孔周的位移場及孔邊應變。
  14. Based on the experiment of full - sized cshb walls under lateral and vertical loads, initial crack - resisting stiffen formula was deduced by considering the influence of concrete beams, concrete core columns, structural columns, vertical pressure and window ( or door ). the results calculated from the formula were fit well with the experimental results. by the analysis of displacement at initial crazing, probability statistical mode and its parameters of relative displacement angle were presented

    在介紹和總結本課題的室內足尺寸單片墻抗側力性能試驗的基礎上，考慮了圈樑、芯柱、構造柱和墻體正壓力、開門窗洞等因素對抗側剛度的影響，提出了綜合各種因素的初裂抗側剛度公式，與試驗結果具有很好的一致性；結合試驗的初裂位移分析，給出了層間相對位移角的概率統計模式及相應的統計參數，提出了小砌塊建築層間位移角的控制標準。
  15. Experiment result shows that the displacement efficiency of foam flooding is 30 % higher than that of water flooding

    大量的室內驅油實驗結果表明，泡沫復合體系的驅油效率比水驅提高30以上，是一項很有前途的三次採油方法。
  16. Laboratory displacement experiment result shows that the displacement efficiency of foam complex system is 30 % ( ooip ) higher than water displacement

    室內驅油實驗結果表明，泡沫復合體系的驅油效率比水驅提高30 （ ooip ）以上。
  17. The water displacement experiment of carboniferous gas showed that under normal pressure natural gas in subsurface reservoir is difficult to migrate into minor pores and displaced water out the pores in reservoir

    石炭系儲層氣驅水實驗表明，巖石滲透率與驅替后殘余水飽和度呈負相關指數關系。
  18. Methods : this experiment used finite element analysis ( fen ) in the design of mesial and distal occlusal rest of distal - extension partial removable denture and to test the magnitude of stress and displacement of abutment teeth and soft tissue under the base when under the vertical force of two conditions

    方法：採用有限元法在末端游離缺損義齒的有限元模型上作遠中、近中（牙合）支托設計，分別在人工牙及修復后的牙列（包括義齒及基牙）上作垂直向加載，測試基牙及基托下軟組織的位移及應力值，通過測試結果作對比分析。
  19. Magnetic force pump magnet couplings " universal energy equation is educed by analyzing of demagnetization curve, ways of reverting force calculating are introduced according to the equation when inside magnet rotor have axial direction and radial displacement, circumferential moment of magnetic force has been given, magnetic force pump alnico ' s axial direction length, circumferential length, radial thickness amounts are summarized with the analyses of experiment results

    利用退磁曲線法，推導磁力泵聯軸器能量通用公式，導出內磁轉子在軸向偏移和徑向偏置下產生的回復力計算方法，周向傳動轉矩計算方法，結合試驗結果，總結推薦磁力泵磁鋼軸向長度、周向長度、徑向厚度、磁極數設計方法。
  20. In the experiment, the author get many conclusions on the fixed beam strengthend by the two means through analysing the experiment result, including strain, displacement, angle of rotation and damage character

    通過對試驗梁應變、撓度、轉角、破壞特徵等方面的分析研究得出了許多關于這兩種方法加固固支梁的結論。
分享友人
分享到 Line

分享到臉書