double-current method 中文意思是什麼
double-current method
解釋
雙流式-
In this paper, ackerman steering linkage of double - wishbone suspension is taken as the study object, choosing the splitting joint and steering lever joint to carry out the design of optimization the mathematics models are established based on the multi - body system dynamics, applying its analysis method of kinematics to study the mechanism kinetic principles owing to more spatial factors considered, and calling off many hypotheses affecting the accuracy, compared with the traditional methods, the models are better to reflect the realistic motion principles, the results are more exact and applicable moreover, the force analysis is applied to the conduct mechanism the analysis method of dynamics in the multi - body dynamics is applied to study the forces applied on every component, working out the constraint reaction force of up and down ball joints, and developing the current computation program in the end, produce the upper wishbone geometry model in the ansys software package, meshing and carrying out the fea, testifying if the intensity of the wishbone meet with the requirements
本文以雙橫臂獨立懸架的轉向傳動機構作為研究對象，選擇對斷開點和節臂球銷的位置進行優化設計，在此基礎上建立了基於多體系統動力學的導向機構和轉向傳動機構的數學模型，運用該學科的運動學分析方法研究機構的運動規律，編制了通用優化設計軟體。由於考慮了更多的空間因素，取消許多影響準確性的假設，因此建立的數學模型與傳統的方法相比更能反映實際運動規律，得到的優化結果也更加精確實用。此外，本文還針對導向機構進行受力分析，在建立該機構的空間動力學模型后，運用多體動力學中的動力學分析方法研究各個桿件的受力，計算出上下球鉸的約束反力，並開發出了相應的通用計算程序。 -
Connection method includes single star and double star, relaying protection method includes open delta voltage protection, differential current protection, differential protection, neutral unbalance current protection etc
接線方式有單星或雙星接線，繼電保護方式有開口三角電壓保護、差流保護、差壓保護、中性點不平衡電流保護等幾種形式。 -
A method of fuzzy optimization design based on genetic algorithm is presented as a new method of parameter optimization design for dc double closed loop speed adjusting system. the method covers three steps. firstly, speed overshoot rate and settling time are chosen as performance indice according to the demand of engineering. these indice are normalized by using fuzzy membership function and then weighted to form objective function of optimization model of the system. secondly, the dynamic response curve of the system with corresponding parameters and peoformance indice are obtained by computerized numerical calculation and simulation. finally, parameters of engineering design are expanded as searching space ; and parameters of speed regulator and current regulator are taken as genes in chromosome. these genes in searching space are optimized to get best solution by way of genetic algorithm. as shown by experimental results, the parameters designed by this method are capable of significantly improving performance indice of the system, which proves that it is a practical and effective method
提出一種基於遺傳演算法的直流雙閉環調速系統參數優化設計方法.根據工程技術的要求，選用速度超調量和過渡時間作為參數優化性能指標.將該指標用模糊隸屬度函數歸一化，再加權平均形成系統優化模型的目標函數.採用計算機數值計算方法，通過模擬獲得系統對應參數的動態響應曲線及其性能指標.最後以工程設計的參數為搜索范圍，以速度調節器和電流調節器的參數為染色體中的基因，通過遺傳演算法在搜索范圍中優化這些基因，獲得優化解.實驗結果表明，所設計的參數能使系統性能指標有顯著提高 -
Based on the magnetic field data, this paper presents a double - frequency method to separate eddy current lossand hysteresis loss from iron loss, then different methods are used to calculate the two losses separately
在磁場計算所得數據的基礎上，本文提出了採用雙頻法分離出sr電機鐵損中的渦流損耗與磁滯損耗，並分別採用不同的方法計算出這兩種損耗。 -
The integral method is adopted caculate and analyze to amf three - dimension distruction which is the structure of coil type four - pole and the structure of coil type double - pole and study the size of two kind of electrode structure axial magnetic flux density distribution and its fielduniformity. the finite - element method is used simulate that eddy current has effect on amf when contact tray of douple - pole amf structure is slotted or no
本文採用積分方法對本文設計的線圈式兩極縱向磁場觸頭結構和線圈式四級縱向磁場觸頭結構的縱向磁場三維分佈進行了計算分析。研究了電弧燃燒期間兩種觸頭結構縱向磁場強度的大小、均勻性，利用有限元法模擬線圈式兩極縱向磁場觸頭結構的觸頭盤開槽和不開槽時渦流對縱向磁場的影響。 -
The results show that if n - dbr is neglected, the theoretical calculations are in good agreement with the references. but our results also indicate that n - dbr has very important influences on the properties of vcsels and if it is not considered, there must be some errors. and double oxide - confining regions offer a method of decreasing threshold current and controlling high order modes
結果表明，當不考慮n - dbr的影響時，我們的理論計算結果與文獻報道相符；但通過計算可知n - dbr對vcsel特性有較大影響，如果不考慮會帶來誤差；同時雙氧化限制層為vcsel器件提供了一種降低閾值，抑制高階橫模的方法。 -
Obtained by emtp program and the egm, this paper studies on lightning protection performance on 500kv double circuit transmission line the distributed parameter model of tower is built when analyzing the back stroking lightning protection performance for double circuit line, it can truly reflect the spreading course of lightning current on the tower, furthermore, considering the randomness of working voltage ' s phase when lightning strokes the top tower and supposing the probability of lightning appearing arbitrary phase in a cycle of ac is equal, this paper brings forward the statistical method to calculate the rate of back stroking on double circuit line
本文利用emtp程序、擊距法對500kv同桿雙回線路的耐雷性能進行了研究。在分析同桿雙回線路的反擊耐雷性能時，建立了桿塔的分佈參數計算模型，此模型可以真實地反映雷電流在桿塔上的傳播過程。並針對雷擊塔頂時，導線運行電壓相位角的隨機性，本文假定雷擊出現于交流一周期的任一角度區間內的概率相等，提出了利用統計法計算同桿雙回線路的反擊跳閘率。 -
With the finite - difference method, self - consistent solutions for the possion ' s equation, injected current density, carrier concentration, optical field and thermal conduction equations have been realized to study the thermal - field properties, the coupling of electricity, thermal and optical - fields, and the influences of n - dbr and double oxide - confining regions on the characteristics of vcsels
本文建立了一個直接耦合的準三維理論模型，通過有限差分法求解泊松方程、載流子擴散方程、熱傳導方程和光場方程的自洽解，研究了vcsel的熱場分佈特性，並實現了電、熱和光場的耦合，同時考慮了n - dbr及雙氧化限制層對vcsel特性的影響。 -
The paper analyzed the basic theory and mathematic model of three phase voltage pwm inverter and proposed one kind of control strategy based on the voltage - current double - loop. it used the exterior loop to control the voltage the eps outputted, and used the inner loop to control the current. simulation testified that the control method could improve the dynamic response character and interference rejection ability
在建立三相電壓型pwm逆變器在兩相同步旋轉坐標系下的數學模型的基礎上，提出了一種三相電壓型pwm逆變器基於電壓電流雙閉環的控制方法，利用電壓外環實現對輸出電壓的穩定控制，電流內環實現對輸出電流的控制，模擬證明該方法有效地改善了系統的動態響應及抗干擾能力。 -
According to the space vector modulation method of the equivalent structure of the ac - dc - ac transformation, the transformation relations of the matrix converter are deeply investigated. the ac - ac direct conversion control and the double - space - vector pwm scheme of the matrix converter are deduced, the four - step current commutation strategy of matrix converter is expatiated, the design method of input filter and over voltage protection circuit is analyzed, and the modeling and simulation of a three - phase matrix converter are implemented
從等效交-直-交變換的空間矢量調制方法出發，深入分析了矩陣式變頻器的變換關系，導出了交-交直接變換控制規律和雙空間矢量脈寬調制技術，闡述了矩陣式變頻器的換流控制策略，分析了輸入濾波器和過電壓保護電路的設計方法，實現了矩陣式變頻器的建模和運行分析。 -
In this paper, according to current practical requirement of information technology and sales management, a new conception putting the idea of customer relationship management into sales management system of erp is put forward, and the contents and methods of their integration are studied. then a method of customization - oriented quotation is proposed. by means of the model of double - layer construction combining c / s and b / s, the sales management system based on erp is researched and developed
本文結合當前信息技術和銷售管理的實際需要，提出了將客戶關系管理的理念融入erp銷售管理系統的構想，研究了它們的集成內容和方法；探討了面向客戶化定製的產品報價方法；並採用c s與b s相結合的雙層架構模式設計和開發了基於erp解決方案的銷售管理系統。 -
The paper research small - signal model of pfc circuit and build the simplified average - small - signal model of the system. the thesis develop design method of pi regulators which are applied in double closed - loops system. furthermore, the sampling algorithm of votage and current variables is also analysed in this paper
文中對pfc電路的小信號模型進行了研究，並建立了系統的簡化平均小信號模型，在此基礎上，以系統的動態特性和穩定性為設計指標，具體給出了雙閉環系統中pi調節器的設計方法。
分享友人