droplet model 中文意思是什麼

droplet model 解釋
小液滴模型
  • droplet : 帶菌飛沫
  • model : n 1 模型,雛型;原型;設計圖;模範;(畫家、雕刻家的)模特兒;樣板。2 典型,模範。3 (女服裝店僱...
  1. As to the simulation, three - dimensional n - s equations and two - phase flow model, in which the liquid toluene spray as discrete particles was considered, were employed to describe the turbulent combustion processes in the combustion chamber. the mass and energy transfer between the two phases were calculated by the droplet evaporation model, and the arrehnius model was used to obtain the gas chemical reaction rate. the details of 3d flow field, the distributions of temperature and compounds were obtained by solving the equations

    數值模擬方面,應用三維湍流n - s方程以及顆粒軌道模型描述了激光器燃燒室內部的噴霧兩相燃燒流動過程,兩相之間的質量、能量交換由液滴蒸發模型計算,氣相化學反應速率由arrhnius公式計算,通過耦合求解氣液兩相模型方程,模擬了燃燒室三維流場,得到了燃燒室內的溫度和組分濃度分佈。
  2. Relating to oily water separation, chapter four builds mathematic model takes into account the tractive character of oil droplet and collision polymerization process during the separation, and compares to traditional separating mathematic model

    第四章針對油艙污水的油水分離,考慮了油滴的曳力和碰撞聚合,建立了油水分離的數學模型,並和傳統的分離模型做了比較。
  3. Thermodynamic analysis on wet compression process is done in this thesis and studies are done on ideal wet compression process, actual wet compression process, water droplet evaporative rate, wet compression work, inlet evaporative cooling, wet compression efficiencies and water droplet breaking. and thermodynamic model of wet compression process is established, which gives out rules of and methods to calculate wet compression parameters

    本文從熱力學的角度對濕壓縮過程進行了分析,分別對理想濕壓縮過程、實際濕壓縮過程、水滴的蒸發速率、濕壓縮功、進氣蒸發冷卻、濕壓縮效率和水滴的破碎等進行了研究,建立了濕壓縮過程的熱力學模型,給出了濕壓縮過程狀態參數的變化規律和計算方法。
  4. By means of a detailed analysis to the interaction between droplet and its carrying fluid for horizontal stratified / atomization two - phase flow, a theoretical model is proposed to calculate the droplet axial velocity profile and the relative slip between dispersed phase and continuous phase

    摘要通過對水平分層霧化流中液滴和其攜帶流體間交互作用的分析,提出了一個預則水平分層霧化流中軸向液滴速度分佈以及彌散相和連續相之間相對滑移的理論模型,通過計算獲得了兩相速度參數及相對滑移參數。
  5. The fuel diffusion and vaporization model in the intake port of small gasoline engine are analyzed, and the key factors affecting the formation of droplet and film are generalized

    本文對小型汽油機進氣道內燃油霧化和蒸發模型進行了分析,總結出了影響油滴油膜形成和蒸發的主要因素。
  6. In theoretically flow - levitation method can prepare the nanoparticle of a series of different metal element and different size. through a course imitate for preparation of nanometal powders in inert gas by flow - levitation method, have established the mathematics model of the metal droplet surface evaporate to form suspension nanoparticles in inert gas, the calculation of this model shows as a result, the major factor of affect nanometer

    研究表明,自懸浮定向流法制備的納米金屬間化合物微粒其相組成與蒸發源母料的成分有一定的對應關系,適當條件下得到的產物顆粒中,主要組成相的cu 、 al原子比基本接近或盡量與蒸發源母料的cu 、 al原子比趨於一致,換言之,可以通過
  7. At high pressures, the combustion model should include droplet heating as well as phase change.

    在高壓下,燃燒模型應當包括液滴加熱和相變。
  8. The three basic steps are as follows : firstly, the flow field is computed. secondly, the droplet trajectory equation is solved in order to determinate the limiting droplet trajectories and local collection coefficient. thirdly, a new iced shape is defined according to ice accretion model

    其基本步驟一般分三步:計算物體的繞流流場;求解水滴軌跡方程以確定極限水滴軌跡和收集系數;根據冰增長模型來確定新的結冰翼型形狀。
  9. A model in which second atomization and collision among droplets was considered, for the droplet size distribution of energetic liquid jet was established on the basis of primary breakup model

    在此基礎上,考慮二次霧化以及液滴之間的碰撞,建立了含能液體噴霧場液滴尺寸分佈的數學模型,並進行了數值模擬。
  10. Methods using biocompatible alginate as microsphere material and hemoglobin as drug model, protein - loaded microspheres were prepared by an improved technology based on electrostatic droplet generation via designing components of gelation solution

    方法以生物相容性優良的海藻酸鹽為載體材料,以血紅蛋白為藥物模型,通過設計凝膠浴配方,採用靜電液滴形成工藝制備包封蛋白質藥物的微球載體。
  11. Both qualitative analysis to the changing trend of droplet axial velocity profile and quantitative comparison with experimental data demonstrate the rationality of this model

    計算與實驗結果表明:無論是從液滴軸向速度分佈變化趨勢的定性分析,還是從與實驗數據的定量比較來看,建立的模型都是合理的。
分享友人