droplet particle 中文意思是什麼
droplet particle
解釋
粒狀粉粒-
According to the experimental data of droplet size 、 particle spectrum range 、 droplet cone shape 、 flow rate 、 cover area and cover area rate which obtained through changing the pressure of power sprayer and the nozzle diameter in greenhouse ， this paper made comparative analysis on atomizing performance in same pressure and different nozzle type between same nozzle type and different pressure. the conclusion is that : the ejection rate and the droplet cone shape change with the variation of pressure and nozzle diameter ， average particle diameter decreases obviously and particle quantity increases obviously with the increase of pressure and decrease of nozzle diameter. these results will lay experimental foundation for precise spraying 、 low pollution and highly effective operation
本文根據溫室內動力噴霧機壓力與噴嘴孔徑的變化影響霧滴大小、粒譜范圍、霧錐形狀、流量、覆蓋面積及覆蓋面積率的試驗數據，對相同壓力下不同噴嘴型號和相同噴嘴型號時壓力不同時的微粒化性能進行對比分析和研究，得到如下結論噴出量與霧錐形狀隨著壓力和噴嘴孔徑大小變化而變化；平均粒徑隨著壓力的增加和噴嘴孔徑的減小而明顯減小；粒數隨著壓力的增加和噴嘴孔徑的減小而明顯增多，為精噴量、低污染、高防效的防除作業奠定了實驗基礎。 -
4, the formation mechanism of the n - sic particles in the ceramic coating prepared by the nano - micrometer n - sic / al2o3 composite powder located within m - al2o3 grains is revealed : m - al2o3 would be well melted during spraying and form droplet, the n - sic particles existing on the surface of droplet, then the particle enter the droplet when it is impacted and flattened on the substrate
4 、提出了利用納米一微米n - sic al _ 2o _ 3包覆復合粉末所制的陶瓷塗層中n - sic粒子分佈於m - al _ 2o _ 3晶內的機理：在噴塗過程中微米級al _ 2o _ 3完全熔化形成液滴， n - sic粒子存於液滴表面，在液滴撞擊基材平鋪過程中n - sic粒子進入液滴內部形成。 -
Using three - dimensional particle trajectories dispersed droplet diameter at the outlet of screw element during compounding in a co - rotating intermeshing twin - screw extruder was computed
摘要用物料三維流動路徑結合分散模型計算了螺紋元件出口處分散相液滴的直徑，分析了螺桿轉速、擠出機產量和液滴初始直徑對末端分散相液滴直徑的影響。
分享友人