elastic-plastic deformation 中文意思是什麼

elastic-plastic deformation 解釋
彈塑性變形
  • elastic : adj. 1. 有彈力[彈性]的。2. 伸縮自如的，靈活的。3. 機變的，輕快的。n. 橡皮線，松緊帶，橡皮圈。adv. -ally
  • plastic : adj 1 造型的；塑造的；給與形態的。2 可塑的，塑性的，受范的；柔軟的；〈比喻〉溫順的，肯聽話的。3 ...
  • deformation : 變形,走樣
  1. In order to use structure ' s ability of elastic - plastic deformation to consume the earthquake energy, decrease the reaction in the earthquake, ferroconcrete frame structure should be designed into ductile one

    為了利用結構的彈塑性變形能力耗散地震能量，減輕地震作用下結構的反應，應將鋼筋混凝土框架結構設計成延性框架結構。
  2. The content of this thesis, through the deformation destruction process of th e typical nanlidu landslide along the national highway 318, uses the finite unit a nalysis of computation, revealing the elastic, plastic stress and displacement of each joint inside the slide area pointing out the distribution range of the tension stress and the plastic deformation range, computering the stability safety factor of the slide area, gaining the fixed quantity, quota that evaluates the stability of the slide area, revealing the position of the slide area which is most likely to los e its stability, thus, it can provide theoretic proof for the programs which renova te landslides

    本文的研究內容是通過318國道南里渡典型滑坡的變形破壞過程，採用有限元計算分析，揭示滑體內部每個節點上的彈、塑性應力及位移，找出拉應力分佈區和塑性變形區，計算滑體穩定安全系數，得出衡量滑體穩定的定量指標，揭示滑體最可能失穩的部位，從而為滑坡整治方案提供理論依據。
  3. This paper demonstrates ultimate stress increment of unbonded tendons can be composed of approximate elastic deformation along the elements and local plastic deformation by nonlinear analysis on the unbonded partially prestressed concrete continuous structures. referring to the rule of ultimate stress increment of unbonded tendons at every load case, a regression formula of ultimate stress increment of unbonded tendons based on elastic - perfectly plastic model has been presented for engineers to calculate ultimate stresses of unbonded tendons in prestressed concrete multi - span continuous structures

    考慮在各種荷載工況作用下無粘結筋極限應力增量的變化規律，並與理想的彈塑性模型相比較，最終得出以理想彈塑性模型計算各種荷載工況作用下無粘結筋極限應力增量的回歸公式，從而為預應力混凝土多跨連續結構的無粘結筋應力設計計算提供有益的參考。
  4. A void growth equation is derived for elastic - plastic deformation process by means of representative volume element ( rve )

    摘要採用體胞模型的分析方法推導了材料在彈塑性變形階段的孔洞增長方程。
  5. A structured clay in this model is regarded as an assembly of lumps of different sizes, and it is assumed that the total deformation consists of 3 parts, i. e. elastic deformation of lumps, plastic deformation due to sliding between lumps and irrecoverable deformation due to crushing of lumps

    這一模型把變形過程中的結構性土看作不同大小土塊的集合體，總的變形將由土塊的彈性變形、土塊之間滑動引起的塑性變形和土塊破碎引起的損傷變形三部分組成。
  6. In order to study the deformation and rolling force during finishing of steel flats, an analytical model based on elastic plastic finite element method was established to simulate systematically the whole finishing process

    摘要為研究扁鋼精整過程中的變形和軋制力的變化規律，利用彈塑性有限元方法建立了扁鋼精整過程的分析模型，系統地模擬了扁鋼精整的全過程。
  7. Based on thermodynamics laws, inner - variable theory and analysis of conventional tn - axial tests data and breakage characteristics of loess, this paper proposed that the loess would produce elastic, plastic and nonreversible damage deformation during loading

    從熱力學定律和內變量理論出發，在對常規三軸試驗數據和土樣的破壞特性分析的基礎上，認為土體在受力過程中將產生彈性變形、塑性變形和不可逆損傷變形。
  8. Secondly, in view of the limitation and shortage of traditional simulation of finite element approaches for bolt, a new composite grouted bolt element including nonlinear contacting relation will be built based on the above study of the mechanics mechanism of fully grouted bolt. then, an elastic - plastic finite element program will be developed for the analyses of tunnel stability, in which the composite grouted bolt element and nonlinear finite element analysis method will be used ; the patterns and the affect of main design parameters on the support effect of bolt will be analysed using the program, and conclusions of guidance importance for tunnel support design will be drawn. finally, simulation compution for the excavation and support of a highway tunnel will be made out using the above production, and the method of application of the program will be discussed ; analysis of the deformation, stress and distribution of plastic range will be done, and rational support plan will be worked out, which is of guidance importance for tunnel support design and the thery and technique of fully grouted bolt used in tunneling will be perfected further

    首先，本文在綜合分析隧道穩定性影響因素及失穩破壞模式的基礎上，對全長粘結式砂漿錨桿作用力學機理進行了深入研究，為全長粘結式砂漿錨桿的有限元模擬分析奠定了基礎;其次，針對傳統錨桿有限元模擬方法的局限性與不足，在上述全長粘結式砂漿錨桿作用力學機理研究基礎上，建立出能反映界面非線性粘結的新型復合砂漿錨桿有限單元模型;然後，運用上述復合砂漿錨桿單元模型，引進非線性有限元分析手段，開發了隧道支護穩定性分析的有限元程序，並就全長粘結式砂漿錨桿的型式與設計參數對支護效果的影響進行了深入探討，得到了對隧道支護設計具有指導意義的結論;最後，運用本文研究成果對某公路隧道工程實例進行了開挖與支護的模擬計算，探討了其應用方法，並就隧道變形與應力及塑性區分佈規律進行了分析，從而提出了合理的支護方案，為隧道支護設計提供了參考依據，完善了隧道全長粘結式砂漿錨桿支護的理論與方法。
  9. The result showed that plastic deformation during pre - strain played an restrained role on the growth of martensite ( especially in the direction of lath width ) and increase the nucleation rate indirectly ; the elastic energy induced by plastic deformation restrain the transformation of primary martensite but accelerate the transformation of after martensite

    實驗結果表明：預應變過程中造成的塑性變形對馬氏體生長（尤其是寬度方向）有約束作用，起間接提高馬氏體形核率的作用，所儲備的彈性應變能對初生馬氏體的轉變有抑制作用，但對繼生馬氏體的轉變卻有促進作用。
  10. According to the deformation of elastic - plastic theory, the finite element analysis model of metal diaphragm for tank of propulsion system in satellite was established in this paper

    本文建立了衛星推進系統貯箱金屬膜片變形的有限元分析模型。用彈塑性有限變形有限元法，模擬了貯箱金屬膜片的翻轉變形過程。
  11. Then at the elastic - plastic state taking advantage of the brace and eccentric distant, we can control the inelastic deformation of the braced frame. the reinforced concrete frames with eccentric brace conform with the earthquake - resistant principle and its seismic properties have improved remarkably. during the lowly circular and repeated loading, the load - bearing, deformation, and ductility of the eccentrically braced reinforced concerete frames were measured

    偏心支撐鋼筋砼框架的設計意圖是當結構在抵抗外力作用時，在彈性階段結構有較高的抗側剛度，而當結構進入彈塑性階段時，利用支撐和耗能段梁的變形使結構的非彈性變形可控，體現了抗震結構「先剛后柔」的原則，使鋼筋砼框架的抗震性能得到有效地改善。
  12. The effect of plastic deformation and elastic strain energy induced by pre - strain on the nucleation of martensitic transformation of low alloy ultra - strength steel sosimncrmov had been studied by pre - strain quenching in austenite state. the control over deformation magnitude and deformation temperate as well as loading pattern was performed to adjust the storage of elastic strain energy in steel before martensitic transformation, using the type of geeble - 1500 thermal analogue test machine

    使用gleeble - 1500型熱模擬機，對低合金超高強度鋼30simncrmov實施奧氏體預應變淬火處理，通過控制形變量、形變溫度和加載方式，調整鋼中馬氏體相變前的彈性應變能儲備，研究了預應變所造成的塑性變形與彈性應變能對馬氏體相變的影響。
  13. To ensure the safety of the dam and provide the technology for the decision during the process of construction and store water. in this article, the elastic - plastic stress - deformation of dam is calculated and the consolidation is analyzed. including the rock - fill dam, the stress and deformation distribution of cut - off wall, the deformation of sloping core, the incresment and subduction of pore water pressure and the effective stress situation calculation

    為確保大壩安全，並為大壩施工期和蓄水期運行決策提供必要的技術支持，本論文根據上壩土料的應力一應變一強度特性、滲透和固結等特性，對壩體進行了彈塑性應力變形計算和固結分析，包括大壩堆石體、防滲墻的應力及變形分佈和斜心墻的變形、孔隙水壓力增長及消散和有效應力狀態計算等。
  14. This method can account for the effect of elastic and plastic deformation

    這種方法的優點在於可以同時考慮零件裝配過程中的彈塑性變形。
  15. Based on the idea of the measured displacement can be divided into elastic and plastic parts, elastic parameters can back analyzed by the elastic displacement, which is the measured instant after blasting excavation. the strength parameter can be got by plastic deformation, which is the measured during the period of construction loop without blasting excavation. lastly, depending on fenner formula, a new and valid evaluating criterion for tunnel stability is presented and the effect of deformation modulus, cohesion, internal friction angle and overburden can be considered

    以解析理論為基礎提出一種實用而簡便的圓形洞室彈性反分析方法，且將其應用推廣到其它洞型、分步位移等不同情況；提出一種圍巖強度參數反演方法，並對其可靠性進行了初步研究； （ 4 ）依據芬納公式提出了能夠考慮圍巖變形模量、強度參數、埋深等主要因素的、新的、有效的圍巖穩定性評判方法。
  16. The respective linear and nonlinear model parameters are determined according to these isochrones " elastic - plastic deformation segment

    分別根據該曲線的彈、塑性變形段確定相應的線性、非線性模型參數。
  17. Pore deformation of low - permeability gas reservoirs is characteristic of elastic plastic deformation

    低滲透氣藏孔隙變形具有彈塑性變形的特徵。
  18. A geometrical model for finite elastic - plastic deformation

    有限彈塑性變形的幾何模型
  19. And the theoretical a nalyses done in this paper are listed below : first, the experimental data on the members of varied parameters under torsion demonstrate the general rule of the deformation while the tubular is under torsion. the paper establishes three phases of the deformation of the tubular under torsion, namely, the elastic deformation, the elastic - plastic deformation, and ultimate failure. through regression analysis, a simplified method is proposed for calculating the capabilities of the tubular under elastoplastic torsion, and the formulary for bearing value, is also recommended as a reference in engineering design

    本文根據不同參數的構件受扭性能試驗結果，研究了該結構受力變形全過程的基本規律，提出了受鈕全過程的三個工作價段，即彈性變形階段，彈塑性變形階段和極限破壞階段，經分析回歸得到扭轉全過程彈塑性的簡化分析方法及承載力計算公式，可供工程設計參考；同時根據本文的彎扭試驗結果以及對離心鋼管混凝土構件進行的理論分析，推導了彎扭試驗相關承載力的關系。
  20. Elastic plastic deformation

    彈塑性形變
分享友人
分享到 Line

分享到臉書