electric scanning 中文意思是什麼

electric scanning 解釋
電掃描
  • electric : adj. 1. 電的；帶電的；起電的，導電的，發電的，電動的。2. 令人激動的，緊張的，驚人的。3. 〈美口〉（樂曲的）用電吉他演奏的。n. 〈口語〉1. 帶電物體。2. 電動車輛。
  • scanning : n. 1. 細看，細察，審視。2. 【電視】掃描，掃掠,搜索。
  1. The chemical composition and microstructures of the insulating thin films prepared by different methods were analyzed by x - ray diffraction ( xrd ) and scanning electron micrograph ( sem ) ; other properties such as electric resistance, the breakdown field strength and dielectric properties were evaluated using high resistance meter, voltage resistance meter and precision impedance analyzer respectively

    採用x射線衍射儀（ xrd ）對表面絕緣薄膜的物相組成進行了分析，掃描電子顯微鏡（ sem ）對表面絕緣薄膜的微觀結構進行了研究，並用絕緣電阻測試儀、耐壓測試儀和精密阻抗分析儀分別對絕緣膜進行絕緣電阻率、擊穿場強和介電性能的測試。
  2. Fixed camera fastening its interior is loaded with an electric motor, on installs the good camera after the level to be possible to adjust the angle which the camera deals with, after achieved the best surveillance effect may accept the automatic control regulator by the electric motor the signal precisely to move the localization in under the control signal function, the camera already may automatically carry on the horizontal scanning to monitor the region, also may in under the monitoring center attendant s operation the moving surveillance object input voltage : ac 24v 50 60hz, 110v 60hz, 220v 50 60hz external dimensions : 119mm 115mm is high the weight : 0. 9kg material : abs high strength casts takes shape the degrees rotation : level biggest : 350, vertical 90 may adjust the velocity of whirl : 5 second 4 seconds revolve the spacing : exterior spacing card tunable load : 7kg function input plug : 1

    Kl - 306室內水平雲臺是安裝，固定攝像機的支撐設備.它內部裝有一電動機，在水平雲臺上安裝好攝像機后可調整攝像機俯仰的角度，達到最好的監視效果后可由電動機接受來自控制器的信號精確地運行定位.在控制信號的作用下，雲臺攝像機既可自動進行水平掃描監視區域，也可在監控中心值班人員的操縱下跟蹤監視對象
  3. Gamma knife lack of physiological experiment used in operations or electric stimulation check. so before curing it should be strictly examined by order of procedure as medical history collection, resonance scanning of magnetism, image video synchronization monitor electroencephalogram and ect comprehensive check to cautiously confirm the epilepsy and choose the right target

    伽瑪刀缺乏術中電生理驗證或電刺激檢查，因此，治療前更應嚴格按程序進行診斷檢查，如病史採集，磁共振掃描視頻同步監測腦電圖及ect等綜合檢查，謹慎地確定致癇灶和選擇合適的治療靶點。
  4. Kinetics of 8 " phase precipitation and influence of electric field applying during solution process are studied by differential scanning calorimetry ( dsc ) technique

    以示差量熱分析技術（ dsc ）研究相析出的動力學及固溶電場的影響。
  5. It analyses the causes to bright image movement, studies principle to compensate image movement, conforms project to compensate image movement, and designs framework to compensate image movement in the article ; to analyze and design configuration of the scanning mirror, to select matters of mirror and its support structures on the principle of consistent line expansion coefficient ; to ascertain type of moment electromotor by most rotating angle speed and most rotating moment which are required by loads in the period to take pictures, as well as by figuration size of electromotor ; to design retarder according as the electromotor parameters ; to design and optimize lightweighted mirror shapes, because the mirror is key part ; to design flexure support structure, to analyze static and dynamic characteristics of the support structure by name of patran program for validating desig n rationality ; to study function of the scanning mirror electric control system ; to test precision of the system, the results indicate the rationality of design of the scanning mirror system

    本文通過分析像移產生原因、研究像移補償原理，確定像移補償方案，並根據像移補償原理設計補償機構；分析與設計掃描反射鏡系統結構，根據材料線膨脹系數一致原則，選擇反射鏡及其背部支撐的材料；由掃描反射鏡在擺掃周期內的最大擺掃角速度確定力矩電機的額定轉速，根據負載力矩確定電機的額定轉距，綜合電機外型尺寸等因素，確定執行元件? ?電機的型號；根據所選電機的參數指標，設計1 ： 6速比的減速器；利用patran軟體對掃描反射鏡系統中的關鍵件? ?反射鏡進行輕量化設計與優化；設計反射鏡柔性支撐結構，並通過軟體分析支撐結構的力學特性，驗證反射鏡柔性支撐結構設計的合理性；從原理上研究掃描反射鏡控制系統功能；進行系統精度測試，測試結果表明掃描反射鏡系統設計的合理性。
  6. In this thesis, scanning force microscopy ( sfm ) was used to study the nanoscale electric phenomena of the surface and interface properties of ferroelectric thin films. the experimental setup was calibrated by measuring potential distribution of the working resistance of integrated chip

    在實驗儀器的驗證方面，選用集成電路晶元測試單元中的埋置條形電阻作為檢測對象，在電阻兩端外加直流偏壓后檢測電阻的電勢分佈，在已知電阻上電勢分佈的前提下，驗證了開爾文力顯微鏡檢測微區表面電勢的可靠性。
  7. Some electro - optical crystals can result in birefringency when they are pressed by electric field, by controlling the intensity of the electric field, we can change the phase of the output optical beam, so the desired scanning direction can be got

    它主要是利用某些電光晶體在電場的作用下，可以產生雙折射的原理，通過控制加在光學相控陣中各相控單元兩極間的電場強度，可以改變出射光的相位，從而得到所需角度的掃描。
  8. Scanning electric microscope ( sem ) analysis was used to observe the morphology of the fabric during the pretreatment and cu / ni - p coating growing process

    採用掃描電鏡（ sem ）分析了不同的粗化時間對織物表面粗糙度的影響和化鍍銅和鎳過程中的表面形態變化。
  9. Orthogonal tests of waterproof and gas diffusion were taken to option the mass ratio of composition, and meticulous tests of each factor were taken too. scanning electric microscope was used to observe the surface pattern. finally the best composition was found

    實驗以正交試驗的方式確定了防水透氣層組成並對單因素進行了考察，並用sem觀察表面形貌，最終確定防水透氣層組成活性碳、 ptfe 、造孔劑、乙炔黑的質量比為5 . 00 : 2 . 00 : 6 . 00 : 5 . 00 。
  10. This machine has ten main functions which are spiral massage, healthy scanning cleaning blood resell, physiological balance, giving a new lease of functions on life, beauty and physiotherapy, sports with fresh air, electric qigong, super sense and keeping in good health, and magnetic curative effect

    具有螺旋按摩健康掃描清潔血管生理平衡性能再造美容理療有氣運動電子氣功超覺養生磁療效應等十大功能。
  11. In accordance with physical engineering and theory of life science, this machine has ten main functions which are spiral massage, healthy scanning cleaning blood resell, physiological balance, giving a new lease of functions on life, beauty and physiotherapy, sports with fresh air, electric qigong, super sense and keeping in good health, and magnetic curative effect

    根據人體工程學原理及生命科學理論而精心研發的氣血循環機，具有螺旋按摩健康掃描清潔血管生理平衡性能再造美容理療有氣運動電子氣功超覺養生磁療效應等十大功能。
  12. The lead zirconate titanate ( pzt ) / polymer composite presented large tan5 and dynamic modulus when the composites were exposed to higher polarization voltage and longer polarization time, because of the uniform dispersion of ceramic in polymer matrix and the strong interaction between grain and polymer. the morphology of the composites, namely the degree of the grains dispersion in polymer, can be observed through scanning electric microscope ( sem )

    顆粒結構性高的壓電陶瓷，其復合體系內耗大；在高極化電壓、長極化時間下，壓電陶瓷顆粒在聚合物中分散比較均勻，與聚合物接觸面大，相互間作用強；在外力作用時，體系tanb 、 g ， ， g ?呈現大的值。
  13. For adapting to the need of industrialization and improving the properties of materials, the method of mechanical activation has introduced on the basis of traditional calcinations at high temperature. the stardard spinel limn204 is prepared by the mechanical activation - high temperature solid synthesis method. the thermodynamic property, the physical - chemistry performance and the producing techniques of. battery have been studied by means of thermogravimetry ( tg ), differential scanning calorimetry ( dsc ), x - ray diffraction ( xrd ), scanning electric microscopy ( sem ) as well as various electrochemical analysis methods. studies show that synthesis temperature, calcinations time, recipe of raw materials, heat treatment and particle size of products are main factors affecting the performances of limn204 cathode materials. with the increment of synthesis temperature and time, the structure and crystal of products are getting to perfect

    隨著合成溫度和時間的增加，產物的結構和晶型越趨于完善，但在1100得到的產物有燒結和晶粒增大的現象，恆溫時間超過24h后對材料的性能影響不是很大； li mn比在0 . 95 1 . 05 2的條件下都可得到標準的尖晶石limn _ 2o _ 4 ，尤其當li mn比為1 . 05 2時，所合成的材料具有較好的電化學性能；通過兩段合成法制備的產物性能要比一段合成法法制備的產物性能好，而兩段間隔合成法比兩段連續合成法處理的材料性能更佳；顆粒的粒度隨著球磨時間的延長而減小，比表面昆明理工大學碩士學位論文摘要卻增大，粒度小且分佈范圍窄的材料有利於鏗離子的擴散。
  14. Abstract : in experimental conditions, simulating reducing atmosphere in blast furnace, the samples of al2o3 - c brick is heated at high temperature. the microscopic structure of al2o3 - c brick is observed by scanning electric telescope before and after heating and compressive strength and rupture strength are measured. on the base of them, the reason resulting in the changes is analyzed

    文摘:在實驗室條件下模擬高爐還原氣氛高溫處理鋁碳磚試樣，觀察處理前、后鋁碳磚的顯微組織形貌的變化，並測定其抗壓、抗折強度，分析引起這種組織變化的原因
  15. The microstructures of the c60 films were studied with scanning electric microscope ( sem ) ; and the optical constants ( including absorption spectrunu refractive index and dielectric function ) of c60 films were measured with the ellipsometer

    常溫和77k溫度8襯底上c60膜的制備，以及這兩種薄膜的表面結構及光學性質的比較研究。光學參數主要由橢偏儀測量。
  16. The influence factors on the pl intensities of the ps suspension, such as deposition time and applied electric field intensity, were examined in detail. the morphology of the deposited ps films and as - prepared ps has been measured using scanning electron microscope ( sem )

    然後以zn zno仔s電極作正極，鋅片作負極，置於納米zno的懸浮體系中，在電場強度為300v cm時電泳20min ，這樣形成了zno ps zno夾心結構。
  17. Scanning electric microscope ( sem ) photographs were used to examine the structure of surface soil experienced a rainstorm, for the purpose of understanding the mechanism of soil crusting. it approved that soil crusting consists of depositional crust and structural crust. the curves of infiltration with time revealed four stages of crust formation

    用電子掃描顯微鏡（ sem ）照片對比了土壤表面結構，分析了土壤的結皮機理，可以認為土壤結皮是由結構結皮和沉積結皮構成，入滲量與時間的歷時曲線反映了結皮的四個形成過程。
分享友人
分享到 Line

分享到臉書