electromagnetic interference 中文意思是什麼

electromagnetic interference 解釋
電磁干擾試驗
  • electromagnetic : adj. 電磁的。
  • interference : n. 1. 沖突，抵觸。2. 干涉，干預。3. 妨礙，打擾，阻礙物。4. 【物理學】干擾；干涉。
  1. Shielding ground planes are provided for the isolation of devices to prevent electromagnetic interference

    隔離接地面用來將元件隔離以避免電磁的干擾。
  2. The electromagnetic interference tolerance is discussed in this paper, the radio spectrum assignment and the sensitivity of interference measurement equipment are described

    摘要討論了日像儀的干擾容限，列出了干擾源分佈，估算出干擾測試儀靈敏度。
  3. Measuring methods of electromagnetic interference for the vsat earth station in the satellite communication

    衛星通信vsat地球站電磁干擾的測量方法
  4. Standard specification for autocatalytic nickel over autocatalytic copper for electromagnetic interference shielding

    電磁干擾屏蔽用自催化銅上的自催化鎳的標準規范
  5. With soft - switching technology, inverter spot - welding power source has lower switching dissipation, lower electromagnetic interference and lower sensitivity to parasitic parameters of power circuit, contribute to inverter output characteristics and circuit efficiency, stability and reliability

    採用軟開關技術的點焊逆變電源，可減小開關損耗、電磁干擾及對電路寄生參數的敏感性，並從根本上改善電路的輸出特性，提高電路的效率、穩定性和可靠性。
  6. Then, after the circuit is placed wholly into margin within the case of gyroscope, electromagnetic interference which affects circuit itself is analyzed, designing for board level electromagnetic compatibility is discussed, approaches with which reducing electromagnetic interference are bring forward, at same time, the request of every circuit routing is required, and a part of circuit layout is improved

    其次，分析了電路安裝在陀螺殼體內后的電磁干擾對電路本身的影響，探討了電路板級的電磁兼容性設計，提出了減小電磁干擾的途徑，在此基礎上提出了電路各模塊的布線要求，並改進了部分電路布局。
  7. The problem about neutral - point - grounding mode is an all - around technical problem which associated with not only power system reliability ， insulation coordination ， electromagnetic interference ， but assault safety 。 in china ， the neutral grounding modes of the 10kv net involved of none grounding, grounding by arc suppressing coils, resistance grounding or reactance grounding in the past 。 with the development of civic power network ， low resistance grounding mode was used to restrain the over voltage, particularly in guangzhou, shanghai ， beijing ， and zhuhai etc. it was reported that the over - voltage level of low resistance grounding mode is lower than that of arc suppressing coil mode, but the operation carried out the other way 。 at substations in guangzhou and shanghai it was found that the low resistance grounding mode is successful 。 but in some areas ， such as zhuhai ， substations grounding with low resistance revealed some problems ， including power supply reliability rapidly dropping ， transmitting line often tripping ； and person safety being threatened 。 so interiorly the grounding mode selection of the 10kv network was disputed, which mainly focused on the fault form of 10kv net grounding, the apply area of suppressing arcing coil grounding mode, power supply reliability level of the two modes, person safety, communication interfere and the workload of maintenance

    爭議點主要是在10kv電網接地故障的形式、消弧線圈接地的應用范圍、兩種運行方式供電可靠性的高低、人身安全、通訊干擾和運行維護工作量等諸多方面。 11 17本論文就是針對以電纜為主的城區10kv電網中性點接地方式的選擇問題進行研究。論文首先對10kv電網的中性點運行各種方式進行分析，比較各方式的特點，然後以重慶儲奇門變電站10kv電網的實際參數來建立數值計算模型，在考慮了電網接地電容電流變化、中性點電阻取值大小、接地點接地電阻值變化等多種影響因素的情況下，對中性點經消弧線圈接地和經小電阻接地方式下電網的過電壓水平和接地點短路電流大小進行了數值計算，其計算結果與電科院所作現場試驗進行了比較。
  8. This paper first analyses the chief consequences that electromagnetic interference interferes in scp application systems, then respectively introduces varieties of software anti - interference technology to enhance the reliability in scp application systems

    首先分析了電磁干擾對單片機應用系統造成干擾的主要後果，然後分別介紹了提高單片機應用系統可靠性的各種軟體抗干擾技術。
  9. The methods that can efficiently suppress the disturbance on gate of switching component of the inverter - bridge are synthesized. a dual - inductor output filter is employed to improve electromagnetic interference ( emi ), due to turn - on or turn - off of the power switches of the inverter, which may be lead loads into trouble

    本文詳細論述了1kva25hz新型鐵路信號電源和2kva高頻在線式ups的設計和調試工作，總結了幾種能夠有效抑制逆變橋功率開關管門極干擾的措施，並且運用一種雙電感結構的輸出濾波器來改善由逆變器功率管在開關過程中產生的、影響負載設備正常工作的電磁干擾。
  10. The criteria for site selection were very strict. because of the sensor s high sensitivity, there should not be electromagnetic interference and building obstructions around the site. there is also the need for appropriate communication lines at the site

    閃電監測站之選址要求嚴格：由於探測儀器非常靈敏，附近不能有電磁噪音干擾，四周必須極少阻擋，並且要有相應的通信線路配合等。
  11. Withstand capability of relay systems to radiated electromagnetic interference from transceivers

    中繼系統對無線電收發信機輻射電磁干擾的抵抗能力
  12. The surface resistance and electromagnetic interference ( emi ) shielding effectiveness of the conductive fabrics were measured by four point probe method ( astmf 390 ) and the coaxial transmission line method ( astm d4935 - 99 ), respectively

    分別用四探針法和雙軸傳輸線法測量了導電滌綸織物的表面電阻和電磁屏蔽效能。
  13. Fixed inductors for electromagnetic interference suppression - blank detail specification - inductors for which safety tests are required - blank detail specification - fixed inductors for electromagnetic interference suppression for which electrical shock hazard protection tests are required

    抑制電磁干擾用固定電感器.空白詳細規范.僅要求做安全性試驗的電感器.空白詳細規范.僅要求做電沖擊危害防護試驗的電磁干擾抑制用固定電感器
  14. Fixed inductors for electromagnetic interference suppression - blank detail specification - inductors for which safety tests are required - assessment level d. blank detail specification : fixed inductors for electromagnetic interference suppression for which electrical shock hazard protection tests are required - assessment level d

    抑制電磁干擾用固定電感器.空白詳細規范.要求做安全性試驗的電感器.評定等級d .空白詳細規范:要求做電沖擊危害防護試驗的電磁干擾抑制用固定電感器.評定等級d
  15. Road vehicles - electromagnetic compatibility test procedure of motor vehicles - part 2 : qualification of the immunity to electromagnetic interference in a semi - anechoic chamber

    道路車輛.汽車的電磁兼容性試驗程序.第2部分:半隔音室的抗電磁干擾的合格鑒定
  16. Standard for withstand capability of relay systems to radiated electromagnetic interference from transceivers

    中繼系統對無線電收發機輻射電磁干擾的抵抗能力標準
  17. Hexavalent chromium in corrosion preventive coatings of unpainted metal sheetings and fasteners used for corrosion protection and electromagnetic interference shielding in equipment falling under category three of directive 2002 / 96 / ec ( it and telecommunications equipment )

    用於防腐或屏蔽電磁干擾，塗在特定儀器設備中（歐盟指令2002 / 96 / ec條款3規定為it和電信設備）的金屬片或金屬扣件上防腐塗層中的六價鉻。
  18. No electromagnetic interference

    無刷發電機爪極
  19. One approach to minimize this impact is to filter the harmonic currents and the electromagnetic interference ( emi ) produced by the power electronic loads

    減小這種影響的一個辦法是，將由電力電子負載產生的諧波電流或者電磁干擾濾除。
  20. When zero sequence or high secondary harmonic current component appear in the circuit, the total current in the shield is zero, no electromagnetic interference with outside

    當線路出現零序或高次諧波電流分量時，屏蔽層內電流總和為零，不對外界產生電磁干擾。
分享友人
分享到 Line

分享到臉書