energy reflectivity 中文意思是什麼

energy reflectivity 解釋
能量反射率
  • energy : n. 1. 干勁，活力。2. （語言、行為等的）生動。3. 〈pl. 〉 （個人的）精力；能力。4. 【物理學】能，能量。
  • reflectivity : 反射比
  1. Thus, 21mj of single pulse energy has been obtained. in the case of 10 % reflectivity, less than 3. 7ns with 8. 6 : 1 pulse - compression ratio has been observed

    應用200 m光纖獲得了21mj的四通放大輸出能量並在能量反射率10的情況下獲得了高達8 . 6倍的脈沖壓縮比。
  2. When the energy converters and the thickness of the steel plate are settled, the attenuation speed of the repetitious pulse reflected wave from the underside is only related to the reflectivity of the reinforced concrete interface

    在鋼板厚度和換能器確定的情況下，多次脈沖底面反射波的衰減速度只與鋼-混凝土界面的反射率有關。
  3. Absorptivity, reflectivity and transmissivity depend upon the wave length of the radiant energy striking the surface and also upon the temperature of the surface.

    吸收率，反射率和透射率取決于打在物體表面上的輻射能的波長，也和物體表面的溫度有關。
  4. The conclusions are as follows : the ultrasonic intensity is proportion to the laser intensity ; the ultrasonic induced by a laser line source has much more advantages than by a laser point source, such as stronger energy, higher snr, more directivity and shape ; the intensity of cfpi ' s output signal is linear with ultrasonic vibration velocity, and is effected by incidence angle and scattered angle ; snr will increase by reducing cfpi ' s bandwidth, reducing incidence angle, increasing cavity ' s length and reflectivity

    在分析點光源激勵聲表面波機理的基礎上，求出了線光源激勵的超聲振動的位移表達式，發現線光源激勵的近場區表面波具有波形好，信噪比高，指向性好，幅度強等特點。通過理論推導，得出共焦fabry - perot干涉儀的輸出光強除了與樣品表面的振動速度成正比，並與入射角和散射角有關；適當減小cfpi的帶寬，增加腔長，增大鏡面反射率，或者減小檢測入射角都可以提高系統的信噪比。
  5. In this paper, some investigation and design as following. have been carried out on er - yb codoped phosphate glass waveguide laser first, three primary performance parameters of er - yb waveguide laser pump threshold power ; output power and slope efficiency have been commulated and analysed theoretically based on er ~ ( 3 + ) - yb ~ ( 3 + ) energy configuration ; rate equation of stable state and transmitting equation. the influences of er - yb ions concentration ; enabled waveguide length ; light dot radius of signal light and pump light ; reflectivity of output lens on three above parameters have been researched

    首先，從er ~ （ 3 + ） - yb ~ （ 3 + ）能級結構出發，結合激光穩態速率方程與傳輸方程，對鉺鐿波導激光器的三個主要性能參數:閾值功率、輸出功率、斜率效率作了理論計算分析，並研究了鉺、鐿離子濃度、光波導激活長度、信號光與泵浦光光斑半徑比例、輸出耦合鏡反射率對這三個關鍵性能參數的影響。
  6. With the development of infrared tunable opo, its application is more and more wide. lt is possible for us to estimate the quality of resonant mirrors in laser with high energy and to improve the output energy of laser, by measuring the reflectivity of resonant mirrors of coil and df laser by cavity - ring - down which use output wave of opo as the laser source, instead of coil and df laser with high price and huge space

    用opo紅外輸出激光作為光腔衰蕩的光源代替價格昂貴、體積龐大的氧碘和氟化氖激光器，對其諧振腔鏡的高反射率進行測量，以達到對高功率激光器腔鏡高反膜質量的評價，為改進膜系設計、鍍膜工藝優化和提高激光器的輸出能量提供理論依據。
  7. The gradient films and the modification of the microstructure can be realized by the post - heating. then the novel antireflecting energy saving coating glass is achieved. it is also found when the temperature and time of the post - heating increases, the average reflectivity will decrease and the average transmission will increase

    實驗結果表明，隨著退火處理溫度的升高和退火時間的延長，鍍膜玻璃的平均反射比呈線性下降的趨勢，而其平均透射比則呈現增大的趨勢，不過前者的下降趨勢更加劇烈和明顯。
分享友人
分享到 Line

分享到臉書