environmental temperature 中文意思是什麼

environmental temperature 解釋
環境溫度
  • environmental : adj. 1. 環境的，環境產生的。2. 環境藝術的。adv. -ly
  • temperature : n. 1. 溫度，氣溫。2. 體溫。3. 〈口語〉發燒，高燒。
  1. Environmental-temperature variations contribute to uneven air pressures due to density variations of the air in the bellows.

    環境溫度的變化將引起波紋管內空氣密度的變化，造成氣體壓力不穩定。
  2. The temperature of surface concrete varies with environmental temperature, but the conductibility of inner concrete is very poor. as a result, a quick decrease of environmental temperature will lead to large temperature gradient and then tensile stress develop soon in the thick direction, which will probably occur on the entire cross - section

    混凝土表面溫度隨外界溫度波動而波動，但內部的導溫性能很差，所以在外界溫度驟降時將引起很大的溫度梯度，從而在厚度方向上拉應力發展很快，這極易引起全斷面拉應力發生。
  3. Main reason is : the first, avian flu virus is more sensitive to temperature, as environmental temperature elevatory, virus surviving time shortens

    主要原因是：第一，禽流感病毒對溫度比較敏感，隨著環境溫度的升高，病毒存活時間縮短。
  4. Exposure to high environmental temperature can cause heat stroke

    暴露于高溫環境下可導致中暑。
  5. Stiffness analysis of controllable stiffness hydropneumatic spring shows that controllable stiffness hydropneumatic spring can be used to improve riding comfort and environmental temperature adaptability of vehicles

    剛度特性分析表明，可控剛度油氣彈簧的車輛應用可以改善行駛平順性和環境溫度適應性。
  6. It may be caused by malfuncton of the temperature regulating center, the response of the center to a pyrogen, exposure to a very high environmental temperature, or impaired dissipation

    其原因可能是體溫調節中樞功能紊亂、熱源刺刺激，氣溫過高或體溫逸散功能受損。
  7. Environmental temperature : - 40 for fixed laying, - 15 for unfixed laying

    最低環境溫度：固定敷設- 40非固定敷設- 15
  8. Lowest environmental temperature : - 60 for fixed laying, - 20 for unfixed laying

    最低環境溫度：固定敷設- 60非固定敷設- 20
  9. If the surface is covered or watered after casting of concrete, the influence resulted from change of environmental temperature and relative humidity on concrete will decrease to some extent. then the shrinkage stress will also decrease and the probability of cracking will be reduced as well

    混凝土澆注完后對表面進行覆蓋或澆水養護，可以很大程度上地減少外界溫濕度變化對混凝土內部的影響，減小了混凝土的收縮應力，從而降低混凝土開裂的可能性。
  10. As the experiment results show, multiple reasons led to the offset of oscillating frequency, including diode ’ s nonlinear characteristic, fluctuation of electrical source voltage, traction of load impedance, change of environmental temperature and humidity and the design of circuit

    實驗結果表明多種因素引起了振蕩頻率的偏移，包括二極體的非線性、電源電壓的波動、負載的牽引、環境溫度濕度變化以及電路板設計方面的因素等。
  11. Test method of environmental temperature for aircraft tyre

    航空輪胎環境溫度試驗方法
  12. The environmental temperature is less than 5

    環境溫度低於5的條件下。
  13. The time required for primmorph formation, primmorph size distribution, and the proliferating capability were microscopically documented. for a successful formation of primmorphs, it is mandatory to use healthy sponge tissues and a minimum inoculate cell density is required. culture temperature will need to be adapted to the environmental temperature where the sponges are collected

    對mcp - primmorph的生長，增殖和代謝特徵進行5天連續培養考察，發現海綿細胞團離體培養方法的建立及其成團增殖和代謝規律研究了mcp一prllnmorph培養中存在有絲分裂細胞，但增殖細胞比例僅為巧%左右，且上述培養基對增殖無顯著影響。
  14. Based on theoretical analysis and computational model, a three - dimension numerical simulation software 3c3d ( concrete cracking control 3d ) was finished in which finite element and finite difference method were both hired. compared with the known data, good agreement proved it reliable and practicable. finally, by means of the software, with variant of environmental temperature and relative humidity and different curing conditions, the variety regulation of temperature and humidity and the stress due to them within concrete were analyzed

    然後針對收縮開裂的本質因素即混凝土內部的溫度梯度和濕度梯度，進一步從理論上分析了高強高性能混凝土早期溫濕度場隨齡期發展的分佈情況，分析溫濕度變化與收縮變形的關系，建立了相應的計算模型，並且採用有限元和有限差分方法編制三維模擬系統軟體3c3d （ concretecrackingcontrol3d ） ，通過與已知數據的對比分析，驗證了該模型的可靠性和實用性。
  15. In order to improve the refrigerating efficiency of the micro - vortex - tube, we have proposed a cooling system of a micro - vortex - tube with humidifying at the hot end. the hot gas temperature is lower than the gas of environmental temperature through humidifying the hot gas in the hot end

    為了提高微型渦流管的製冷效率，提出了渦流管熱端加濕製冷系統，通過對熱端氣體加濕降溫，獲得低於環境溫度的氣體，同冷端氣體一起製冷。
  16. The installation of electrohydraulic push rod should remain adequate space, the environmental temperature should be between 10 to 60 c ( high temperature environment should order specially )

    電液推桿安裝要有足夠空間，環境溫度10 ~ 60之間（高溫環境要特別定貨） 。
  17. This is the theoretical foundation for simulating the gun interior ballistic performance using the closed vessel experiment. based on the functions from closed vessel experiments, the ballistic simulation results of maximum chamber pressure, muzzle velocity and p - t curves of a 105mm gun charged with ltsc nitroamine propellant at + 50c, + 15c and - 40 environmental temperature were in good agreement with experimental data

    在密閉爆發器實驗的基礎上，應用可視化程序對某105mm火炮採用低溫感硝胺火藥在+ 50 、 + 15和- 40環境溫度下的最大膛壓、初速以及膛壓?時間曲線進行了彈道模擬，模擬與實驗結果具有較好的一致性。
  18. The observer makes use of motor parameters to estimate speed, but these parameters ( stator and rotor resistance, magnetizing inductance ) will vary because of the change of environmental temperature, iron loss and main flux saturation. so parameter variation will lead to the error of estimation, the purpose of this paper is to study the influence and the compensation of parameter variation

    因為觀測器在估計轉速時利用的是電機的額定參數，而電機的參數（定子電阻、轉子電阻、勵磁電感）由於環境溫度的變化、鐵心損耗和主磁飽和的影響將發生變化，所以必然有估計誤差產生。
  19. The program is written by assemble language to control the movement of the vacuum circuit breaker with pma. the program also can monitor the environmental temperature, control voltage, closing displacement, zero point of contactor voltage

    用匯編語言編製程序對配永磁機構的真空斷路器的分、合閘進行控制，同時對其運行的環境溫度、控制電壓、合閘位移和觸頭間隙電壓過零點等狀態進行實時監測。
  20. The method of catalyzed electrochemical dissolution has the advantages : dissolving quickly and thoroughly, working at the environmental temperature, no hydrofluoric acid ( hf ) and low acidity ( hno3 ), etc. it can be widely applied in dissolution of pu02 and mixed oxide spent fuel element, the leaching of plutonium - contami

    該法具有溶解速度快、溶解徹底、常溫、無氟（ hf入低酸（ hn 。 ）下溶解等優點。雌能用於puo和混合氧化物乏燃料耕的娜、懷污染廢物的浸取等，也可用於含釬標準樣品的分折定值。
分享友人
分享到 Line

分享到臉書