external height 中文意思是什麼
external height
解釋
外廓高度-
The design point of the designed forebody / inlet is flight mach number m = 6 and flight attitude h = 25km. the three - ramp, mixed external and internal compression hypersonic / inlet is chosen as representative geometry to be designed. nine types of hypersonic / inlet model with difference forebody length and total turning angle are obtained that the incidence angle of the first ramp and height of isolator are given
根據飛行任務要求，以飛行馬赫數6 ，飛行高度25km為設計點，給定前體預壓縮角、隔離段高度，對具有不同前體長度和不同總壓縮轉角的帶隔離段的前體進氣道進行了設計。 -
Calculation methods for the ultimate stress and effective height of external prestressing tendons
體外預應力筋極限應力和有效高度計算方法 -
Brand new office renovation with landlord provisions including but not limited to false ceiling, carpet, split - type conditioning units, glass door, electricity meter box, full height external window, box bell etc
全新高級寫字樓裝修，業主並提供全單位假天花，地氈，墻紙，分體冷氣機，電箱，落地玻璃，門鐘等，不能盡錄。 -
The vertical spread of fire along the external wall is affected not only by the building - height and window dimensions, but also by the protrude components such as balcony, windowsill and fireproof eave, etc. the balcony is an important part of buildings and used widely
火焰沿外墻面豎直向上的傳播速度，不僅要受到建築高度、開窗尺寸的影響，而且還受到墻外凸出構件，如陽臺、窗臺、防火挑檐等因素的影響。陽臺是建築物的重要組成部分，運用普遍。 -
The operations on safety of working - at - height and scaffold focused on the external renovation work of buildings
在高空工作與棚架的突擊檢查行動中，我們重點巡查大廈外墻維修工程。 -
Containers must be redelivered clean. note permissible weight limits for road and rail transport. the technical details of 1cctank container for yellow phosphorus : working pressure : 0. 4mpa test pressure : 0. 6mpa external dimensions ( lx w x h ) mm : 6058 x 2438 x 2591 maximum gross : 30480 kg stacking height : 9 x 30480 kg insulation
這種罐箱容量大，密封性能好，使用周期長，抗振強度高，不易被損壞，操作方法實用；而我國現在使用的250l塑料桶，其回收或處理成本高，且污染環境，所以iso1cc黃磷罐式集裝箱是一種理想的替代塑料桶的貯運設備。 -
Typically, external leading is not included in the height of a line of text
通常，文本的行高度中不包括外部間隙。 -
The height adjustment for the yard ramp become very easy with using of the hand hydraulic pump as dynamic & the external electric supply is unnecessary
採用手搖液壓泵作動力，勿須外接動力電源即可輕松實現登車橋的高度調節。 -
Bearing capacity and displacement are two main problems in the application of geotechnical engineering. based on a series of pull - out tests using three kinds of paper and a sort of window screening as geogrid, twenty - seven in limit and several in working - stress geogrid - reinforced slope model tests designed through orthogonal principle have been conducted to have obtained the relationship between the bearing capacity and four factors ( i. e. reinforcement, angle of reinforced slope, the designed - length of reinforcement and the distance between layers of reinforcement ). the law of slope lateral ( horizontal ) displacement versus to the height of slope vary with external - load was derived from the model test data, and the main factor affecting the lateral and vertical displacement of geogrid - reinforced slope was obtained through analysis
承載力（強度）和變形是巖土工程應用領域的兩大主要問題，本文以紙和窗紗布模擬加筋土邊坡的土工格柵，在一系列拉拔試驗的基礎上，以正交設計理論分別安排27個極限應力狀態和若干個工作應力狀態加筋土邊坡模型試驗，並以模型試驗獲得的數據為依據，採用誤差、極差及回歸分析方法，探討了加筋土邊坡承載力與筋類、筋長、層間距、坡角4因素的相關關系，獲得了在外荷載作用下加筋土邊坡的側向位移隨坡高的變化規律（並進行了定性解釋）和坡頂的豎向位移特性，並分析其主要控制因素。 -
During this period, the company accepted the internal and external decorating projects for yantai civil aviation building, the glass curtain wall project for the building of bank of china in jinan ( it lies in the most flourishing commercial area. it is a 25 - story building with a height of about 100 meters. the project costs about 10 million rmb ), the external vertical decorating project for jinan real estate building ( the project is a key construction project in jinan city
2000年至今公司在總體規模、施工能力及管理水平上再上新臺階，在此期間，公司憑實力先後承接了煙臺民航大廈內外裝工程、濟南市中銀大廈玻璃幕墻工程（該工程位於濟南市最繁華商業區，共25層，高度約100米，專項造價約1000萬元） 、濟南市房產大廈外立面裝飾工程（該工程為濟南市政府重點建設項目，共26層，高度約150米，專項造價約1300萬元，公司為此動用了同濟大學專家設計力量及國內一流的施工隊伍） 、人民銀行濟南分行金庫單元幕墻窗工程等。 -
Due to the existence of the eddy and the abrupt bend of the stream line, the pressure on the four faces has the distribution as follow : the lowest pressure appears at several centimeters after the angle point along the top boundary, the highest pressure appears near the center line of the vertical shaft on the bottom boundary, near the angle point, the pressure on the inner boundary decreases with the decreasing height, the pressure on the external boundary decreases slightly in the right - angle region, and increases obviously near the corner
迴流漩渦的存在，以及直彎處流線的急劇彎曲，導致壁面壓力分佈在上表面距彎點一定距離后出現壓力最小值，下表面上，在豎井中心線略偏下游的位置出現壓力最大值，豎井內表面接近彎點處出現壓力沿程降低的現象，豎井外表面壓力在進入直彎后先是沿程略有降低，在直彎角落處又明顯升高。
分享友人