fan mode 中文意思是什麼

fan mode 解釋
升力風扇飛行方式
  • fan : n 1 扇子；風扇，鼓風機。2 簸箕；揚谷機；（風車的）定風翼；【航空】螺旋槳，螺旋槳葉片。3 扇狀物（...
  • mode : n 1 法，樣，方法，方式。2 模，型；樣式，體裁，款式；習慣。3 風尚；〈the mode〉流行，時髦。4 【語...
  1. On the east terrace - fault slope of the depression, the sedimentary mode of fan - shaped delta - slump turbid fan - deep lake facies are developed. on the long axial direction of fula depression, the southeastern groove was filled with a large scale delta which was the main sources, the other little delta limited by the 3 syndepositional fault was distributed down the slope edge of the northern sub - depression. this stage developed a favorable oil sources, reservoir and regional seal which formed the good matching relations of generation, reservoir and seal in the time - space zone

    Abugarbra組的sc和sd層序發育在邊界斷層和同沉積斷層活動劇烈、湖盆擴張期，凹陷中心發育半深湖-深湖相沉積，在凹陷陡坡發育近岸水下扇，斷階緩坡帶發育扇三角洲?滑塌濁積扇?深湖相組合，長軸凹槽和北部次凹的北部緩坡帶發育三角洲體系，此層位是有利生油層和巖性圈閉發育層段。
  2. The traditional refrigeration system in containers adopts the mode of invariable revolution, and its system design is based on what can match the biggest heat load. so the refrigeration compressors and cooling fan motors have been chosen according to their biggest cool and heat burthen in working conditions

    傳統的冷藏集裝箱製冷系統一般採用恆定轉速運行方式，在設計系統時，以能夠滿足最大熱負荷為依據，製冷壓縮機和冷風機選型的根據是最大冷、熱負荷工況。
  3. This paper regards narrow fan - beam scan mode as multi - detector parallel beam scan mode

    本論文將窄角扇束掃描看成是多探頭的平行束掃描。
  4. Its image reconstruction belongs to the image reconstruction under narrow fan - beam scan mode. after comparing different algorithms, this paper introduces convolution back projection algorithm for the parallel image reconstruction

    採用高能直線加速器作為射線源的高能x射線工業ct機多採用窄角扇束掃描方式，其圖像重建屬窄角扇束掃描方式下的圖像重建。
  5. It is indicated that hrv has many advantages certified by theoretic analyze and engineering practices, such as fully ventilating, abundant fresh air supplying, energy saving, etc. comparing with independent fresh air supplying, hrv is supposed to cause potential problems, - in summer load of fan - coil units will be increased, and the wet operating mode will be aggravated, the indoor relative humidity will be increased

    新風換氣機供應新風是住宅空調系統較為理想的新風供應方式，本文通過理論計算及工程實踐表明採用，新風換氣機具有換氣充分、新風量保證、節能等優點。但與新風機組獨立供應新風相比，新風換氣機供應空調系統新風時，會造成夏季風機盤管負荷增加，濕工況加重，室內相對濕度有增加趨勢。
  6. By viewing the cores in cored wells of the research district, combining with the depositional characters of every sand formation and its relevant marks of log facies, the differentiation and sorting of sedimentary microfacies of sublacustrine fan are described systematically ; the planar and vertical changing rules of sedimentary microfacies are studied on this base ; finally the three - dimensional mode of the sublacustrine fan is established, which provides a certain reference action for similar research work

    摘要通過對研究區內取芯井的巖芯觀察，結合各砂層組的沉積特徵及其相應的測井相標志，系統的描述了湖底扇沉積微相的劃分及分類，在此基礎上研究沉積微相平面及垂向上變化規律，最終建立了湖底扇的立體模型，為以後的類似的研究工作提供了一定的參考作用。
  7. Directing against state of affairs at present, such as margin of type - selection parameters being selected comparatively large during design stage of air fans for boilers in thermal power plants, the opening degree of air fans in operation being often smaller ( for adjustment of inlet regulator ) or operation at lower revolution speed ( for speed - regulating operation mode ), and efficiency of air fans being lower etc., factors and corresponding measures having to pay attention in margin selection of air fan ' s parameters have been put forward through analysing practical example of retrofitting forced draft fans in one power plant, playing certain positive role for energy - saving and benefit - increasing in power plants

    摘要針對目前火力發電廠鍋爐風機在設計選型時參數裕量選取較大，運行時風門開度較小（對入口調節器調節）或低轉速運行（調速運行方式） ，風機效率較低的狀況，通過對某電廠送風機改造實例的分析，提出了在風機參數選擇中的裕量選取需要注意的因素及相關對策，對電廠的節能增效有一定的積極作用。
  8. The ore body totally shows the characteristics of fan - shaped, which mode of occurrence is 18 - 25 32 - 70

    礦體多呈脈狀、囊狀、似板狀、不規則狀，總體呈扇形分佈，產狀18 ? 45 32 ? 70 。
  9. Basic function : heat source is anti - blast infrared - tube made of microcrystal quartz ;, continuosly variable mattress tilt, radiant head can two - directory rotate on horizon, x - ray cassette shelf under infant bed ; high - bright erdiate lamp detect lightness ; advanced microprocessor control temperature system, auto - heated mode, separately display set temperature and real temperature ; 4sound - light alarm capacity : set - off, fan, sensor, over temp.

    基本配置：採用了防爆型微晶石英紅外管作輻射熱源，嬰兒床斜傾角度有級可調，輻射頭可在水平位置上雙向隨意轉動，嬰兒床下內設有x光暗盒架，檢查照明採用高照度射燈，溫度控制系統採用先進的計算機控制，自動加熱方式，設定溫度和實際溫度分屏顯示，有四種聲光報警功能（溫度上下偏差、傳感器、斷電、超溫） 。
  10. Presents starting link and system organization of fan ’ s inspects status and fault diagnosis. the system collects data through data acquisition system, inspects fan ’ s status with monitoring soft, establishes routine and fault data bases, and calls routine analysis daughter system, and in the end diagnoses the fault, observates equipment ’ s operating mode ; finds fault type and cause. with the assistance of the diagnosis system, the economy and safety of factory is greatly improved

    通過數據採集系統對信號進行採集與處理，利用監測軟體實現風機狀態監測，建立常規數據庫和故障數據庫以及調用常規分析子系統進行故障診斷等手段，觀察設備運行狀態，找到故障的類型和原因，作為決策的依據，從而提高了設備的經濟性和安全性。
  11. When x - ict detects large industrial parts and requires high resolving power, image reconstruction of x - ict has huge pixel matrix and the amount of calculation increases greatly resulting in much more time of image reconstruction. this paper proposes the parallel image reconstruction based on workstations cluster to solve fast image reconstruction of high power x - ict this paper presents the relevant basic theories and principles of ict and image reconstruction, including scan mode and image reconstruction algorithm. high power x - ict which adopts powerful beeline accelerator as radial source often uses narrow fan - beam scan mode

    工業ct機檢測對象為大型工業構件並且要求高解析度時，圖像重建的像素點陣巨大，計算量大大增加，從而圖像重建時間過長。本論文提出用在工作站機群上的多機并行工作的并行圖像重建解決高能x射線工業ct機的快速圖像重建問題。本論文介紹了工業ct和圖像重建的基本理論、基本原理等有關內容，包括掃描方式和圖像重建演算法。
  12. And also this paper analyzes many important aspects about the design of the variable air volume system, for exam pie the calculation method of cold and volume, the choice of tuyeres, the adjustment operating mode of the fan during summer and winter and proffer form some opinions

    對系統設計中各主要方面諸如負荷計算、風量取值、風口選型以及系統在冬夏運行調節時的風機控制方式，系統運行模式作了一定的探討並提出了自己的見解。
  13. Fan delay stop. it can be set as controlled mode and free mode

    ：風機延時啟動溫度和時間雙重控制風機延時關閉。
  14. Delay shut down of fan. it can be set as controlled mode and free mode

    ：風機延時啟動溫度和時間雙重控制風機延時關閉。
  15. A new circuit of fan - out of high frequency clock was designed to provide a reference clock for the front electrical mode of pet system in the fourth " part of the thesis

    論文的第四部分介紹了為pet系統前端電子學模塊提供時間基準而設計的一種新型高頻時鐘扇出電路。
分享友人
分享到 Line

分享到臉書