feed by pressure 中文意思是什麼
feed by pressure
解釋
氣力輸送-
This machine is not effected by the liquid level, air pressure, temperature etc, because it adopts the auto feed back system
液位氣壓溫度等因素對本設備沒有任何影響，因為本機採用了自動反饋控制系統。 -
To improve the purity of carbon dioxide from the purifying column, a nonlinear model was established for describing the relationship between the carbon dioxide purity and the seven factors of feed purity, feed temperature, column top pressure, column top temperature, column reactor heating temperature, column reactor pressure and column reactor temperature built on the actual production data by using artificial neural network
摘要為提高提純塔出口二氧化碳純度，根據實際生產數據運用人工神經網路方法建立了出口二氧化碳純度與進塔純度、進塔溫度、塔頂壓力、塔頂溫度、塔釜加熱溫度、塔釜壓力、塔釜溫度7個因素之間的非線性模型。 -
A test - bed of dg45 - 80 10 hypo - pressure feed water pump is designed, based on which the general on - line performance testing system is developed and the thermodynamic method is introduced to measure the efficiency of the pump. a new programming technology combining vc + + with matlab is presented by which the vibration monitoring system of boiler feed water pump is developed successfully to perform data analysis after on - line acquisition
本文首先進行了次高壓鍋爐給水泵dg45 80 10實驗臺的設計，在此實驗臺設計成功並安裝調試通過的基礎上，開發了鍋爐給水泵通用性能試驗系統，包括測點的布置、各型測量儀器的選購，設計，安裝和調試以及軟體平臺開發。 -
The piezoelectric - pump driven by piezoelectric - stack is a newly development trend, it can accommodate frequency and pressure in a large scale and control the output flux in precision. this pump will widely apply to transfusion, feed oil and clean the equipment in industrial automation, and scientific research, lab, chemical preparation and cooling of cpu etc. driven theory of piezoelectric - stack because the piezoelectric - stack is the core part of the pump that we designed, we should pay more attention to driven principle of the piezo - stack so that we can using it correctly. this paper introduces piezoelectric material and interrelated parameter, output characteristic and driven principle and driving type of piezoelectric - stack
壓電疊堆泵是一種以壓電疊堆作為驅動元件的微型泵，它是隨著mems的發展而發展起來的。本文提出利用壓電疊堆與柔性鉸鏈放大機構配合來驅動微型泵的橫隔膜，以達到泵送流體的目的。本文在查閱國內外大量文獻的基礎上，總結了國內外壓電疊堆泵的研究現狀，分析了壓電疊堆的動靜態特性，提出一種以壓電疊堆作為驅動源的壓電流體泵的構想。 -
Under the conditions of operation pressure about 0. 5mpa and feed temperature 25 c, the rejection performance of nacl feed solution ( 500ppm ), is about 35 %, while the flux is about 45ml cm - 2 h - 1. the pa membranes were prepared by interfacial polymerization, usingl, 3, 5 - benzenetricarbonyltrichlori2, 4 - dichloroterephthalaldehyd e, 1, 3 - phenylenediamine as monomers
研究結果表明， 5102 / a12o :無機復合超濾膜的研製原料正硅酸乙酷、乙醇、水、 n ， n一二甲基甲酸胺（ dcca ）和hno3之間的配比、塗膜過程、熱處理溫度等直接影響著溶膠的質量和膜的性能。 -
In this paper, an experimental investigation of the removal of volatile organic compounds ( voc ) from dilute aqueous solutions was presented by vacuum membrane distillation ( vmd ). experiments were carried out using aqueous mixtures of ethanol with hollow fiber module. the influences of operating variables such as feed concentration, flow rate, temperature and downstream pressure on the flux and separation factor were investigated
本文對膜蒸餾脫除水溶液中的揮發性有機化合物（ voc ）進行了試驗研究；文中以乙醇水溶液為研究對象，採用真空膜蒸餾法，膜材料為中空纖維膜，研究膜通量及分離因子與原料液的溫度、濃度、流速，冷側壓力的關系，並對真空膜蒸餾的傳熱傳質機理進行了初步探討。 -
However, traditional ultrasonic molding machining is in very low level at present. it adopts " principle of shape copy ", only be used in one dimension machining, and adjusts important machining pressure and feed technics parameters only by equipped weight, so the machining precision and machining efficiency are both very poor
從原理上講，超聲波加工是解決工程陶瓷加工難題最有潛力的技術之一，然而目前傳統超聲波成型加工處於十分落後的狀態，它採用「形狀拷貝原理」 ，僅靠配重來調節加工壓力和進給量等重要工藝參數，加工精度和加工效率都很低，而且只能用於一維加工中。 -
The results showed that the reducing organic acid solution include oxalic acid which were generated in the reaction liquid caused the corrosion of the titanium pressure - relief valve, which mostly because the feed solution in the 1 ( superscript # ) desulfurizing unit were mixed with the waste water discharged by 2 ( superscript # ) desulfurizing unit right after the time when the inhibitor were stopped being used anymore
結果表明，由於二脫硫裝置停用緩蝕劑後排出的廢水混入一脫硫裝置的原料液中，進而使反應液中形成了草酸等還原性有機酸溶液，最終造成鈦制減壓閥發生腐蝕。 -
The feed material is broken between the counter - rotating rolls and crushed by pressure and shearing stress
在壓力和切力的作用下，給料在彼此相向旋轉的軋輥間破碎。
分享友人