feed steam 中文意思是什麼
feed steam
解釋
進汽-
Main feed lines, main steam lines, shafting, and boiler brickwork within the ship are especially sensitive to shock.
船內的主要燃料系統蒸汽系統、軸系以及汽鍋裝置等對沖擊波特別敏感。 -
Study on the optimum condition of high pressure steam to sterilize spf chicken feed
雞飼料高壓蒸汽滅菌條件研究 -
The system optimization and heat economic analysis for feed pump steam turbine
機組給水泵小汽輪機系統的改造及其熱經濟性比較 -
Specifications for steam turbine low pressure feed water heaters
汽輪機低壓給水加熱器技術條件 -
In order to improve the utilization efficiency of energy and equipment, a general steady simulation model of complex cross - feed multi - effect evaporation was established for the purpose of in - depth research on rule of multi - effect evaporation. in this model, the energy - saving measures, including extra steam being led off to preheat material liquid, the condensation water flash and solution flash, were adopted, and the solid separation was also considered in the process of evaporation
為了提高多效蒸發系統能量與設備的利用效率以及深入研究多效蒸發過程的規律，建立了帶有冷凝水閃蒸、溶液閃蒸和引出額外蒸汽預熱原料液等節能措施並考慮蒸發過程有固相析出的復雜錯流多效蒸發穩態模擬通用模型。 -
Combined with practice of rotation - impulsing for steam - driven feed - water pump by using standby steam source in yahe - kou power - generation co ltd, the feasibility and economic behavior of rotation - impulsing for steam - driven feed - water pump, and warming turbine and pump up in advance by using standby steam source to shorten cold - state start - up time, and to save start - up expenses, have been analysed
摘要結合鴨河口發電公司採用汽動給水泵備用汽源沖轉的實踐，分析了汽動給水泵採用備用汽源沖轉，提前進行暖機、暖泵，縮短冷態起動時間、節約起動費用的可行性和經濟性。 -
In case of disuse for a long time, it is necessary to discharge the feed in the pump chamber completely and wash it with water or steam
當泵處于長期停止工作時，應將泵腔內料液放凈，並用水或蒸汽沖洗。 -
Steam seal feed valve
汽封給水閥 -
The response was compared with that obtained through simulation realized by the use of matlab and the actual process on different steam flow, feed water flow, fuel flow and control method
並運用matlab模擬工具，針對鍋爐水位和汽壓調節對象模擬模型在不同的蒸汽負荷、不同給水量、不同燃油量和不同控制方式下的動、靜態情況進行模擬研究。 -
To the steam generator a heat exchanger, which converts the feed water in the secondary circuit to high - pressure steam at about 67 bar or 6 700 kpa and deliver it to the " conventional island " via steam pipe for driving the turbine and generator
內的高壓水帶到蒸汽發生器即熱交換器，蒸汽發生器會將二迴路給水轉化為約67巴或6 700千帕的高壓蒸汽，再經過蒸氣管送到常規島，以推動渦輪發電機。 -
To the steam generator ( a heat exchanger ), which converts the feed water in the secondary circuit to high - pressure steam at about 67 bar ( or 6 700 kpa ) and deliver it to the " conventional island " via steam pipe for driving the turbine and generator
內的高壓水帶到蒸汽發生器（即熱交換器） ，蒸汽發生器會將二迴路給水轉化為約67巴（或6700千帕）的高壓蒸汽，再經過蒸氣管送到常規島，以推動渦輪發電機。 -
By detailedly analyzing the control problem caused by the time - delayed characteristic of main - steam temperature, the fact that a well - designed feed - forward effect can supply the want of the feedback effect and solve the control problem of long time - delayed system was put forward
通過對電廠主蒸汽溫度的大遲延特性導致的控制難題的詳細分析，提出合理設計的前饋控製作用能彌補反饋控製作用的不足，可以有效地解決大遲延系統的控制問題。 -
Establishing on the foundation of the project of " the monitoring state and maintenance assist support system of feed pump for 300mw unit, shiheng power plant, shandong ", this paper ' s content comprise on - line monitoring and thermodynamic calculation on small steam turbine for feed water pump, and supply the necessary data for feed water pump ' s performance analysis, trouble analysis and small steam turbine ' s performance analysis, optimization, heat stress calculation and tremble monitoring
=本論文的內容是建立在「山東石橫電廠給水泵狀態監測與維修輔助支持系統」項目基礎上，涉及大型機組鍋爐給水泵驅動用小汽輪機進行在線監測和熱力計算，為給水泵的性能分析、故障分析以及小汽輪機的性能分析和優化、熱應力計算和震動監測提供必需的數據。 -
This condensate discharge from the condensers feed water is pumped back to the steam generator in the nuclear island to be converted into steam again
從冷凝器流出的凝結水即給水會泵回核島內的蒸汽發生器，然後再次轉化為蒸汽。 -
This condensate discharge from the condensers ( feed water ) is pumped back to the steam generator in the nuclear island to be converted into steam again. cooling water for the condensers is taken from the sea via the seawater pumps in the pump house
從冷凝器流出的凝結水（即給水）會泵回核島內的蒸汽發生器，然後再次轉化為蒸汽。在這過程中，蒸氣會將渦輪發電機作高速轉動（ -
For example, the condenser algorithm considered the trouble condition such as the leak of tube, fail of seal in vacuum system, the lower shaft sea - ting steam pressure, pollute of tube, the high water level of hot - well. the heater algorithm considered the trouble condition such as the leak, pollute of feed - water pipe and high water level of heater
如凝汽器演算法考慮了銅管泄漏、真空系統密封不嚴、軸封蒸汽壓力低、銅管結垢污染、熱井水位過高等故障項目，加熱器演算法考慮了給水管道泄漏、給水管道污染、結垢、加熱器水位過高等故障項目。 -
Material balance and energy balance equations of complex multi - effect evaporation system were expressed in matrix equation, which has the advantages of clear structure and high modularization. by holding or omitting correlation block - matrix in matrix equation, matrix equation could be used to describe the difference of forward - feed, back - feed and cross - reed multi - evaporation system with or without solid separation, extra steam being led off to preheat material liquid, condensation water flash, or solution flash. the models include design and operation
該模型利用矩陣方程具有結構清晰和高度模塊化的特點，將復雜多效蒸發系統的物料及熱量衡算方程組以矩陣形式表達，通過保留或舍棄矩陣中特定功能模塊，模型就能代表有或無固相析出、有或無引出額外蒸汽預熱原料液、有或無冷凝水閃蒸、有或無溶液閃蒸等不同情況以及各種情況任意組合的併流、逆流、錯流多效蒸發過程，從而實現模型的通用性。 -
On the basis of mass unit matrix analytical method, taking thermal system of steam power - generation unit as study object, a new method of feed - water enthalpy rise distribution in regenerative system has been put forward through vigorous mathematical deduction
摘要以質量單元矩陣分析法為基礎，以火電機組的熱力系統為研究對象，通過嚴謹的數學推導，提出了回熱系統給水焓升分配的新方法。 -
After we analyses fully the factors of influencing the feed water, combustion and steam temperature, compare controlling program, design circuits of feed water, combustion and steam temperature
燃燒和蒸汽溫度擾動的各種因素和對控制方案進行分析?比較的基礎上，對沸騰爐給水控制迴路?燃燒控制迴路和蒸汽溫度控制迴路進行了具體的設計 -
Two kinds of representative cc - repowering ( feed water heating repowering, full firing repowering ) are study in this paper. the concise performance expressions and typical data are analyzed for the combined cycle and for repowering the existed steam power station
本文針對兩種典型的聯合循環系統（排氣助燃型和給水加熱型）進行了研究，給出了這兩種聯合循環及其在用以增容改造已有的蒸汽輪機電廠時的性能簡明示式和典型數據。
分享友人