film structure 中文意思是什麼
film structure
解釋
電影結構-
This film has been identified as polycrystal znse with zinc blende structure by xrd
Xrd結果顯示該薄膜為立方閃鋅礦結構的znse多晶薄膜。 -
As to the work about theory analysis, at first, the paper describes the atomizing and humidifying process of the centrifugal nozzle with firing pin type, high pressure and little aperture and liquid physical properties. later, combining with the structure characters of this kind of nozzle, the paper studies on the theory of the atomizing and humidifying process by three phases, which is water film forming phase, water film falling into pieces phase, and heat and mass transfer between water and air phase in turn
理論工作方面，首先描述了撞針型高壓小孔徑離心式噴嘴的霧化加濕過程和液體的物理性質，然後結合撞針型高壓小孔徑離心式噴嘴的結構特點，將其霧化加濕過程分三個階段進行機理上的研究，這三個階段依次為液膜形成、液膜初次破碎及二次霧化、水與空氣的熱濕交換。 -
Inflated plastic film can protect any structure from the rain permanently or temporarily.
充氣膨脹的塑料薄膜能永久或暫時地保護任何結構物不受雨水侵襲。 -
The heat - reaction characteristics of ni / si and tin / ni / si structure and the regularity for forming the nisi film have been studied deeply and formed the excellent ni - salicide shallow junction diode
文中對ni si和tin ni si的熱反應特性以及nisi薄膜的形成規律進行了詳細的研究。制備了優質的ni硅化物淺結二極體。 -
Adopting ni / si and tin / ni / si structure, the nisi film on the < 100 > si substrate by the means of rta has been demonstrated in detail
文中詳細的闡述了採用ni si和tin ni si結構通過rta在硅單晶< 100 >襯底上制備nisi薄膜的方法。 -
The iron doped tio2 thin films showed almost no photocatalytic activity for the photodegradation of no in the gaseous phase when the calcination temperature was lower than 400 c. this was due to the fact that the phase structure of the film was amorphous. at 400 c, the film appeared obviously photoactive du
對于用液相沉積法所制備的tio :薄膜，薄膜中的si （或fe ）含量和薄膜的厚度可通過調節前驅體濃度、溶液的ph值、基片的沉積溫度和沉積時間，薄膜的熱處理溫度和時間進行有效地控制。 -
The research of micro - structure on zro2 photosensitive gels film by uv exporsure
2薄膜上引入微結構的研究 -
Among various fabrication techniques of thin film, the sol - gel process has gained much interest for the preparation of pzt thin film, due to ihe advantages of good homogeneity, easy control of composition, low in - ill i reaving temperature, easy formation of large area thin films pb ( zrxti : - k ) 0 :, ( pzt ) films were prepared on the ito coated glass plates and low resistor silicon wafer in sol - gel dip - coating process associated wi di heat treatment : at different temperatures and characterized by x - ray diffraction ( xrd ) and transmission electron microscopy ( tem ). lt is shown that the pzt ferroelectric thin films with ( 110 ) preferred orientation and well - crystallized perovskite structure can be obtained after annealing at 680 ? for 30 minutes on ito substrate and at 800 " c for lornin on silicon substrate
Pzt的制備方法有很多，其中溶膠?凝膠（ sol - gel ）方法可以和集成電路（ ic ）光刻工藝相互兼容，處理溫度低，有大面積塗敷性能，能精確地控制組分，無需復雜的真空設備，成本低廉，所以對于集成鐵電薄膜電容的應用這種方法有很廣闊的前景。本文利用sol - gel技術在摻錫的in _ 2o _ 3透明導電薄膜（ ito ）襯底和低阻硅襯底上成功地制備了pzt鐵電薄膜。運用了x射線衍射， sawyer - tower電路和lcr電橋分別對薄膜的晶化溫度，結構和電學性能進行了測試。 -
Because of the restriction of the performances of the infrared materials, we decide that the hollow waveguide should have the structure of single layer dielectric coated metallic film according to the general analysis of process controllability and transmission capability. the dielectric we choose is silver iodide, made from silver and iodine, and the optimum thickness is about 0. 77um
因材料性能的限制，通過傳輸性能以及工藝可控性綜合分析，確定製備的空芯光纖為單層電介質塗覆金屬膜結構，電介質膜定為碘化銀，理論厚度為0 . 77 m左右，由銀膜直接碘化得到。 -
In this paper, the influence of chemical deposition cobalt film alloy subjoining rare earth film were investigated to improve deposition technology, structure and properties of cobalt soft magnetic film alloy
為改善化學沉積鈷基合金的工藝、組織結構和性能，本文進行了稀土元素介入化學沉積鈷基軟磁薄膜的研究。 -
X - ray diffiaction confirms that the resulting ersi, film possesses the tetrahedral thsi, crystalline structure
同步輻射x射線衍射以）研究結果證實了所形成的餌硅化物具有thsi 。 -
Ir, sem - edx, and water contact angle measurements on polysilane and polyacrylate film obtained by double operations and single operation showed that the influence of weight ratio of polymers, the molecular of pmma on film structure was great. the film translucence dropping while the ratio of pmma / pmts grew and the compatible reducing while the molecular of pmma increased
通過測定所配製的系列濃度聚合物甲苯溶液、 thf溶液的表面張力發現：有機硅聚合物溶液的表面張力值在有機硅聚合物濃度低於30時變化不明顯；而甲基丙烯酸酯聚合物溶液表面張力值隨甲基丙烯酸酯聚合物濃度的變化比有機硅聚合物溶液明顯。 -
The preparation of gold electrode of double layers and the spectroscopic and electrochemical studies when it was incubated with bacteria : cv measurement demonstrated that the defect content within the double layer gradually decreased during the incubation, sers showed that the film structure became order during the incubation and the bands of double and triple bonds shifted toward high wavenumber, too
循環伏安測試表明在雙分子層與細菌培養的過程中，雙分子中層中的的缺陷數量逐漸減少。表面增強拉曼光譜證實在雙分子層與細菌培養的過程中，雙分子中層的膜結構變得更加有序，且其雙鍵與三鍵的共振峰也同時向高波數的方向移動。 -
These defects can be overcome by a film structure of pl / cr / cu / cr
這些缺陷可以通過在pi和cu之間採用cr膜作為阻擋層來解決。 -
Provides the theoretical reference for the anti - condensation design for buildings with double etfe film structure
為雙層薄膜圍護結構系統的防結露設計提供了理論參考。 -
Through experiment and analyzing the changes of the thickness, rigidity, tensile strength and the opening rate of the conduits caused by the different kinds of coating material, the thickness of the coating and the different braiding structures, we investigate the physical and mechanical, properties of the braided conduits. the results show : the chitosan is easy to form the film structure on the surface of the conduits increasing the conduits ' rigidity clearly ; the rigidity and opening rate of the braided structure with inserted reinforcing yarn are better than the others, this will prevent the conduits collapsing and distorting effectively in the practical uses, so we select conduits of this structure for animal experiment
在導管的物理機械性能研究方面，本課題通過塗層劑的種類（ pgla丙酮溶液和甲殼胺漿液） 、塗層劑的厚度、導管的編織結構三個方面分析它們對導管的厚度、硬挺度、拉伸強力和孔隙率等性能的影響。測試結果顯示：甲殼胺塗層易於在導管表面成膜，對導管的硬挺度有明顯提高，塗層效果較好；加筋結構神經導管在硬挺度和孔隙率方面優于其它導管，能有效防止導管在實際應用中的塌陷變形。 -
In order to make clear the effects of fe3o4 on composite film structure, the thickness, porosity, average and maximum pore size, pore size distribution of different films are measured. surface morphology is studied by scan electronics microscope ( sem ). the characterizing results of film micro - morphology showed that pore structure of fe3o4 / pvdf composite film were better than those of pvdf host film
為進一步分析fe3o4的原位生成對復合膜結構的影響，測定了pvdf基膜和復合膜的膜厚；採用干濕膜重法測試了膜樣品的孔隙率；採用泡點壓力法流體滲透法相結合，對比測試了膜樣品的最大孔徑、孔徑分佈及平均孔徑；通過掃描電子顯微鏡（ sem ）照片分析，對比研究了pvdf基體膜和fe3o4 / pvdf復合膜的表面形貌。 -
Membrane structure is a technical scientific and technological content of the construction of the new high technology, " blue ridge " was founded, from the introduction of foreign advanced membrane structural design concepts, software design, installation mocai processing technology incorporated abroad have decades of history of professional companies mature project management model in china who created fine film structure works for blue ridge membrane structural engineering companies with foreign professional companies work together to promote membrane structure and technology applications in china, has completed more than 50 projects, performance dozen cities throughout china
膜結構技術是一種科技含量較高的建築新技術， 「藍嶺」成立之初，即從引進國外先進的膜結構設計理念，設計軟體，膜材加工安裝技術，吸收了國外具有數十年歷史的專業公司的成熟工程管理模式，立志在中國打造膜結構精品工程，為此藍嶺公司與國外專業膜結構工程公司攜手合作，致力於膜結構技術在中國的推廣與應用，已完成五十多個項目，業績遍布中國十幾個城市。 -
The static recording by sil system is performed on phase - change medium, and the recorded line width is thinner by the factor of 1. 44 than the recording width without sil system. the properties of sb layer super resolution near - field structure is also studied. the sin / sb / sin film structure is deposited on substrate of k9 glass by rf sputtering technology
Sil飛行頭系統與光數據存儲光學頭實驗系統相結合，在相變記錄介質上得到了0 . 45 m的靜態記錄線寬，該結果與非sil存儲系統的記錄線寬（ 0 . 65 m ）相比壓縮了1 . 44倍。 -
The thesis main parts are as followings : ( 1 ) the mechanical properties of the cnx thin film on the various substrate materials by dc magnetron reactive sputtering. ( 2 ) the study of the cnx film structure by x - ray diffraction
文章主要部分介紹、論述、總結了我在做畢業論文期間進行的五方面工作： （ 1 ）用直流磁控反應濺射方法在各種材料襯底上沉積cnx超硬薄膜，研究在不同襯底對薄膜的力學性質的影響。
分享友人